比熱容量 的英文怎麼說
中文拼音 [bǐrèróngliáng]
比熱容量
英文
specific heat capacity-
Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors
就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。Specific heat capacity at constant pressure
定壓比熱容量The specific heat of a material is the amount of heat that must be added to a unit mass of the material to raise its temperature by 1 degree.
物質的比熱容是使單位質量的物質溫度升高1度所須加給的熱量。We made use of wheatstone bridge to control ratio of heating power between the samples, thus, it enable to control and measure the differential heating power accurately. consequently, it improves sensitivity of the system. the resolution of the measurement can reach from 1 : 1000 to 1 : 10000 or better in comparison with the traditional differential technique
我們測量了聚苯胺及其摻雜鹽酸后在1 . 8k至45k的熱容，利用聲子分形子模型來處理非晶態對比熱的貢獻，對獲得的數據進行處理，發現eb和es的比熱數據均不符合德拜理論，超出德拜模型的比熱來源於非晶態的貢獻。The interior size and the calorific capacity of the borehole are much smaller, moreover the temperature change is slow, so usually we can neglect the influence of calorific capacity but to consider according to the heat transfer in steady state process, thus we can establish one - dimensional and the two - dimensional thermal resistance model in the borehole
而在鉆孔內部，包括回填材料，管壁和管內傳熱介質，與鉆孔外的傳熱過程相比較，由於其幾何尺寸和熱容量要小得多，而且溫度變化較為緩慢，因此通常可以忽略其熱容量的影響而按穩態傳熱過程來考慮，建立了鉆孔內的一維和二維的熱阻模型。Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le
對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model
本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。Specific heat capacity at constant volume
定容比熱容量Recently, a new layered limno2 which has higher capacity than spinel limn2o4, has become the hot topic of cathode of lithium - ion batteries
最近，具有比尖晶石型的鋰錳氧化物更高理論容量的層狀結構的limno2 ，成為當前的研究熱點。Electrochemical measurements show that specific capacitance of single electrode is increased by 15 % and its impedance is only tens of m
雙氫氧化物經水熱處理后單電極比容量提高了15 ，達460f4 ，電極內阻僅數十毫歐姆。Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material
研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。Test methods of thermal diffusivity, specific heat capacity, and thermal conductivity for fine ceramics by laser flash method
激光閃爍法測定精細陶瓷的熱擴散率比熱容量熱傳導率試驗方法The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell
對磺化膜的研究分析表明：膜的性能參數如離子交換容量、吸水率、水合系數、形體穩定性、導電性能、化學與熱穩定性等依賴于膜中苯乙烯含量，且接枝苯乙烯相互間的位阻效應對膜性能影響很大；膜的性能可與nafion膜相比較；質子在膜中的傳導遵循「似液體」質子傳導機理；電滲析與擴散作用使膜保持水平衡。Standard test method for determining specific heat capacity by differential scanning calorimetry
用差示掃描熱量測定儀測定比熱容量的標準試驗方法Electrochemical tests indicate that the materials prove to be excellent electrodes for supercapacitors in an unbuffered 0. 5mol / l na2so4 aqueous electrolyte. a sample decomposed at 550 gives a specific capacitance of 243f / g
這些材料皆有典型的電容性能，其中550熱解產物電容特性最好，比電容量達243f g ，充放電性能好，經200次循環電極容量保持在95以上。3. when table sugar was used as starting materials, it was used and pyrolyzed directly or was first mined with sulphuric acid after surface area of those materials is not larger than that of pas capacity is small in their electric double - layer capacitor, specific surface area has great effect on capacity, the larger specific surface area is, the higher capacity is, . but bulk density will decrease with increase of specific surface area
當以食糖為熱裂解碳的原料時，採用直接焦化和酸洗焦化兩種方式。所制備的樣品比表面積沒有聚並苯材料的大，在以30 h _ 2so _ 4為電解質的雙電層電容器中，容量相對較小。電極活性物質的比表面積對雙電層電容器的容量有很大的影響。The charging - discharging capacity of linio2 is high but it makes serious environmental pollution and is difficult to be synthesized. the structure of it is unstable, the thermal stability of it is bad, which will cause the decrease of the charging - discharging capacities
鎳的資源豐富， linio _ 2比容量高，但存在污染環境、合成困難、熱穩定性差、結構不穩定引起容量衰減等問題。Drawing the following concludes : ( 1 ) for the different metallic small particles with even number or odd number, the heat capacity is varied. the result is different from the bulk metal in essence. at the low temperature, the distribution of the discrete energy levels has important effects on the heat capacity ; at the high temperature, the distribution of the discrete energy levels has little effects because of the involving of mass electrons into the energy distribution
得到如下結論： （ 1 ）金屬小粒子所含的電子數奇偶性不同，其電子熱容是不同的，這與大塊金屬有本質區別；低溫極限時電子熱容受能級分佈的影響很大；而在高溫時，有大量的電子參與能量配位，比熱遵循大塊金屬的線性規律，能級分佈的影響小時。Ln chapter 4, imbalanced counterflow of indirect evaporative cooling is simulated while taking into account the non - linearity of the saturation line of moist air. four diagrams are provided to assist in determination of the optimum heat capacity ratio
第四章針對蒸發冷卻過程中飽和濕空氣比熱容隨溫度的非線性變化關系，研究了非平衡流逆流間接蒸發冷卻過程（火用）損失及最佳熱容量比的計算線圖。Compared to heat transfer in the external region of borehole, mass and heat capacity of materials inside the borehole are insignificant and negligible. thus, heat transfer inside the borehole is approximated as steady - state heat transfer except for analyses of short times ( a few hours )
與鉆孔周圍區域傳熱過程相比，由於鉆孔內材料的熱容量較小，因此除了討論短時間（數小時）的瞬變傳熱問題以外，可以忽略鉆孔內材料的熱容量，把該部分的傳熱近似作為穩態傳熱處理。分享友人