比較放大器 的英文怎麼說

中文拼音 [jiàofàng]
比較放大器 英文
comparison amplifier
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • : Ⅰ動詞1 (比較) compare 2 [書面語] (計較) dispute Ⅱ副詞(比較) comparatively; relatively; fair...
  • : releaseset freelet go
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 比較 : 1 (對比) compare; compare with; contrast; parallel (with); comparison; by comparison; in comp...
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. A novel amplifier chain which is composed of the forward wave crossed - field amplifier ( cfa ) driven directly by solid state amplifier ( ssa ) is better in performances and reliability compared with traditional three stage chain which is composed of " ssa + twta + cfa "

    摘要採用固態直接驅動前向波管的新型鏈與「固態-中功率行波管-前向波管」三級鏈相,具有更好的性能指標。
  2. Current feedback vs. voltage feedback operational amplifiers

    電壓反饋和電流反饋運算
  3. D / a conversion chip and isolation amplifiers are used to obtain the comparative levels required by isolation channels, which could be set with actual requirement ; it can enhance flexibility of the module. otherwise, four - channel isolation signal sources are exported using d / a conversion chip and isolation amplifiers as well

    另外還利用d / a轉換晶元和隔離運算輸出四路隔離信號源,該隔離信號源能與隔離電平通過繼電進行程式控制切換,這樣擴展了該計數模塊的功能。
  4. The adm system mainly includes a oscillator, a clock generator, an amplifier, a pre - amplif ier, a comparator, an agc ( automatic gain control ), an adm analyzer & synthesizer, a d / a converter and a lowpass filter

    整個系統包括:內置振蕩,時鐘產生,前置運算, agc (自動增益控制) , adm分析綜合,數模轉換以及低通濾波
  5. According to negative temperature coefficient of vbe and positive temperature coefficient of vt, a framework of band - gap voltage reference is investigated. the reference offer a source of pir, distributed three voltage, one as upper - threshold voltage of dual - threshold comparator, the other as lower - threshold voltage of comparator, the other as direct current voltage for second band - pass filter amplifier

    同時利用pnp晶體管發射結電壓的負溫度特性和發射結差值電壓的正溫度特性設計了一個帶隙基準電壓源。此帶隙基準電壓源本身作為熱釋電紅外傳感的電源電壓,同時分壓提供雙限電壓的上限電平和下限電平以及第二級帶通濾波的直流電平。
  6. Because gyrotron traveling wave tube amplifier ( gyro - twt ) is an important millimeter wave amplifier with the characteristics of the high output power, the broadband width, and good efficiency, which has vast application vistas in many areas such as millimeter radar, communications, electronic countermeasure, and so forth, it has been pay much respect in the world

    迴旋行波管是一種功率、高效率、寬頻帶,在毫米波雷達,通信與電子戰等方面有十分重要的應用前景,因而在國際上受到高度重視。由俄羅斯人g . denisov等提出的螺旋波紋波導是一種理想的結構。
  7. Grounding on above theory, the zvs resonant of soft switch full - bridges circuit, and class - e amplifier, and push - pull class - e amplifier are analyzed respectively in theory. push - pull class - e amplifier is available by comparing results of simulation and low power experiment

    基於以上理論,分別選擇了zvs諧振型全橋串聯逆變、 e類以及推挽式e類進行詳細的理論分析,模擬以及小功率實驗對照。
  8. In the paper a gmc filter with a cutoff frequency of 29. 8mhz is implemented. an effective improvement is made in cmfb ( common mode feedback ) through using a differential amplifier with four inputs. transconductors are tuned through comparing two voltages, which helps to stabilize the cutoff frequency

    文中實現了跨導電容濾波,其截止頻率達到29 . 8mhz ;採用四輸入端的差分使共模反饋得到了有效的改善;通過簡單的電壓實現跨導的調諧,有助於穩定截止頻率。
  9. Some sub - block circuits ( error amplifier, soft - start, enable comparator and under - voltage protection circuit ) are designed and several electrical characteristics are simulated using hspice. finally, the whole chip performance is simulated. and the results show the satisfaction to both function targets and characteristics

    在子電路設計中,本論文只對其中的誤差、軟啟動電路、使能和欠壓保護四個子電路進行了電路原理分析與設計,並在此基礎上,運用eda軟體hspice對各功能模塊的各項指標、參數進行了模擬、分析。
  10. And the ways to optimize the circuit architecture, minimize the circuit nonidealities and improve the circuit performance are analyzed combined with the characteristics of the modulator architecture. based on it, the switched - capacitor integrator, class a amplifier, nonoverlap clock, voltage reference, comparator, feedback dac have been designed. in the end, the layout design is shown

    調制採用全差分開關電容電路實現,並根據系統結構特點就如何優化電路結構、克服電路中存在的非理想特性、提高電路性能作了具體分析,在此基礎上完成了開關電容積分(開關、電容、運算) 、參考電壓源、、兩相非交疊時鐘、反饋dac等模塊的電路結構和參數設計。
  11. The whole circuit consists of a multiplier, an error amplifier, a comparator, a rs flip - flop, an and gate, and an inverter, etc. the electronic circuit simulator cadence is utilized to practice the detailed functional simulation of the general circuit and the subsystem circuits

    整個電路由模擬乘法、誤差、 rs觸發、與門和倒相等基本單元電路組成,採用工作站上的型ic設計軟體cadence進行模擬。
  12. Battery is the only power source for portable equipment. in order to prolong the service time of these battery - operated equipments, ultra - low - power consumption is demanded. the main method that decreases the power losses is to higher the conversion efficiency and to lower the operating voltage

    開關變換內包含了帶隙參考電壓源、誤差、頻率補償電路、三角波產生電路、 pwm以及數字邏輯控制電路,此晶元採用聯華電子公司0 . 6微米cmos工藝。
  13. In the thesis, some of the most important functional modules of the pwm power control ics are designed and simulated, including error amplifier, voltage reference, voltage regulator, comparator, and oscillator. the topologies, schematics and layouts of some circuits are introduced and developed

    本畢業設計研究和提出了構成pwm電源控制晶元的主要功能模塊,設計了其中主要模塊ip核的多種結構電路並進行了模擬,完成了部分電路的版圖設計? ?包括誤差,基準電壓源,電壓調節,振蕩等。
  14. The bluetooth chip nrf2401 uses the gfsk modulation. after analyzing and comparing the characteristic of every class power amplifiers, the thesis bring up with the idea of using a switched mode power amplifier to achieve the demanding output power and the higher efficiency

    結合「微型核」信息電子系統實現方案中nrf2401藍牙晶元的特點,本文通過對各類功率的結構和特點的分析,提出了採用了開關類功率來實現系統輸出功率要求和盡可能高的效率的設計思想。
  15. Advanced fpga technology is introduced to improve the integration of digital circuits, and all digital circuits in the original module are integrated in the fpga chips, which could not only reduce the cost, but also improve the reliability and measurement precision of the circuits. high speed digital signal processor ( dsp ) is selected as the coprocessor instead of scm ; it can receive all kinds of commands sent from vxi, analyze and execute the commands, harmonize each section of the module and process the data. higher - conversion - speed comparator chip is adopted to convert the input signals being measured into square waveform signals which could be identified by fpga chip ; it can expand the measurement range of frequency dramatically

    本文在原有vxi總線四通道計數模塊的設計基礎上,通過對原模塊缺陷的分析,採用一些新的技術和新的電子件來重新設計該計數模塊:採用最新的fpga技術來提高數字電路的集成度,將原模塊中的所有數字電路全部集成在fpga晶元中,這樣不僅能節約成本,還能提高電路的可靠性和測量精度;採用高速的數字信號處理( dsp )取代原有的單片機作為協處理,來接收vxi發來的各種命令,分析命令、執行命令、協調模塊各部分的工作以及對數據的處理;採用轉換速率更高的晶元將輸入的被測信號轉換為fpga晶元能夠識別的方波信號,能極提高測量頻率的范圍;採用d / a轉換晶元和隔離運算得到隔離通道所需的電平,該電平值能夠根據實際需求進行設置,能增強模塊的使用靈活性。
  16. The lna is one of the most important and broad components in microwave communication system receiver, and is used to amplify the low level signal. as the first signal processing block after the antenna, the lna determines the noise figure and input voltage swr and greatly impacts the dynamic range

    低噪聲( lna )廣泛應用於微波接收系統中,是重要件之一,主要用來低電平信號,由於是自天線下來第一個進行信號處理的件, lna決定了整個系統的噪聲性能和電壓駐波vswr ,並對動態范圍有著的影響。
  17. Approach to high efficient rf power amplifier ' s linearization

    高效率射頻功率線性化技術的研究
  18. Use comparators for comparing and op amps for amplifying and don " t even think of mixing the two

    使用,並且不要想著混淆兩者。
  19. Secondly, we simulate the transmission process in computer, calculate the optical - signal - to - noise - ratio ( osnr ) of output signal with the same input signal filtered by the ofbg, matched filter and f - p filter, analyze the improvement of the osnr after filtered by them. we find it also has advantage over f - p filter. taking the two reasons into account, we believe that the weak ofbg is superior to the widely used f - p filter

    另外用計算機模擬計算了光信噪的改善情況,研究發現:一個相同的噪聲信號經弱ofbg后的光信噪經過f - p濾波后的光信噪高,由此認為, ofbg用作光濾波對接收端前置光的噪聲進行濾波,常用f - p光濾波具有更的優越性。
  20. Firstly, the theory and the architecture of hardware system are described, secondly, the steps of the signal processing are discussed in detail. based on the experiments and the characteristics of the signal, we pre - process the signals with band - pass filter, proportional amplifier and coherent demodulator. after sampling and analysis doppler information, we display the final results distinctly to alarm in time

    然後,結合系統中各主要部分的任務,詳細介紹了信號處理的各個步驟:通過實驗,並結合接收信號的特點,選用帶通濾波、相干檢波等技術對信號進行預處理;然後對獲得的多卜勒信息進行采樣和頻譜分析;最後,用直觀的形式顯示數據結果,以及時準確地告警。
分享友人