氣流噴霧機 的英文怎麼說

中文拼音 [qìliúpēnwùjī]
氣流噴霧機 英文
airflow sprayer
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 霧 : 名詞1. （水蒸氣凝結成的小水點） fog 2. （像霧的許多小水點） fine spray
  • 機 : machineengine
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  1. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  2. The main products of our company : series of mining emulsion pump station, series of electric haulage shearer, sparying pump station, series of mining flame - proof vacuum / air electromagnetic starter, series of mining vacuum / air feeding switch, series of mining fame - proof and natural - safe. type ac soft starter, series of hydraulic stand valve and pipe system, high flow rate quick - moving valve, the new product nearing into market - the hydraulic support electric - control system, mining electric drill, hydraulic valve test table, electric performance test table

    公司主導產品為：系列電牽引採煤機、系列礦用乳化液泵站、噴霧泵站、礦用隔爆兼本質安全型交流軟起動器、系列礦用隔爆真空、空氣電磁起動器、系列礦用真空、空氣饋電開關、系列液壓支架閥類及管路系統、大流量快速移架閥、即將投入市場的新產品? ?液壓支架電液控制系統、煤電鉆系列、液壓閥試驗臺、電性能試驗臺等。
  3. Referred and analyzed the developing and researching achievement of high turbulent combustion chamber on diesel engine in the world, the grooved combustion chamber is designed and developed based on the rationale of designing high turbulent combustion chamber and employed the effect of the grooved of the combustion chamber wall on the spray impingement

    在分析和參考國內外柴油機高紊流燃燒系統開發研究成果的基礎上，根據高紊流燃燒室設計的理論基礎，利用矩形環槽對燃油噴霧撞壁效應能加速混合氣形成的機理，設計開發了在燃燒室側壁上加工有矩形環槽的燃燒室方案。
  4. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  5. In this dissertation, the author summed up the muti - technique in fluid dynamics, heat and mass transferring, mechanical designing and computational technique and studied the conventional pressure spray dryers with different air disperse structure and outlet equipment, at last put forward the theme i. e. the study on combined spin - flow pressure spray drying technology, the main contents were as follows : ( 1 ) the combined spin - flow pressure nozzle was designed whose novel structure has no report at present, and the structural designing parameters were obtained through analyzing the physical characteristic of materials and distribution of particles

    本文總結了國內外在壓力噴霧乾燥裝置的研究應用狀況，並分析了現有噴霧乾燥裝置設計方面的優缺點，運用流體力學、空氣動力學、傳熱傳質學、機械設計和計算機技術等多學科知識，綜合研究了傳統壓力噴霧乾燥系統的單噴嘴霧化裝置在併流、逆流以及混流乾燥中的應用和噴霧乾燥塔的不同布風裝置以及出風裝置的設置情況等，提出了新型旋流式組合壓力噴霧乾燥技術並對此進行了研究，其主要內容包括： （ 1 ）本文創造性地設計出旋流式組合壓力噴嘴的基本結構，並通過對料液的物化特性研究分析以及顆粒度的分佈要求，給出了噴嘴的不同結構設計參數。
  6. The present research and practical indicated that the effervescent atomizer may obtain the good atomization effect in the small alr situation, compares with the ordinary machinery and the medium spray nozzle, has the merits of saving the fuel, reducing pollution and so on, has the broad application prospect

    目前的研究及實用表明，氣泡霧化噴嘴可以在小氣液質量流量比情況下獲得較好的霧化效果，與普通的機械和介質霧化噴嘴相比，有節約燃料，減少污染等優點，具有廣闊的應用前景。
分享友人
分享到 Line

分享到臉書