氣流堵塞 的英文怎麼說

中文拼音 [liú]
氣流堵塞 英文
mass blocking of flow
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ動詞(堵塞) stop up; block up Ⅱ形容詞(悶) stifled; suffocated; oppressed Ⅲ名詞1 [書面語] (墻...
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  • 堵塞 : 1 stop up; block up; choke; gag; jam 2 blocking; occlusion; impassability; blinding; blockage; ch...
  1. The advent of balloon angioplasty reduced the intrusiveness for certain patients ; a balloon was fed along a catheter to the blockage, then expanded to crack and compress the plaque, leaving a wider conduit for blood flow

    球血管造形術則降低了手術侵入程度:球沿著導管送進的血管區域,然後球會充,壓碎並壓緊粥狀硬化斑,以利血液通。
  2. A stripping uint with the cross - flow fan was developed, aimed to reduce the grain losses at the rear of the stripping drum reduce the blocking to the air outlet sifter and diffuse dust. this dissertation gives overall scheme of the rig and had mad experimental study

    針對非吸式割前摘脫裝置在收獲作物時,出風口篩面發生使裝置內場變差,導致裝置的落粒損失率過大;以及出風口處煙塵四散,影響了駕駛員的視野和危害工作人員的身心健康等生產中存在的問題。
  3. If air-bleed passages become plugged, they may cause the float bowl to be emptied after the engine shuts off.

    如果空滲入通道,在發動機熄火后,會導致浮子室中的燃油盡。
  4. To prevent clogging of the pressure tap by fine solids gas is bled into the bed at low velocity at the taps.

    為了防止測壓管嘴被微細顆粒,在管嘴處以低速向床內注入體。
  5. An analysis is made of the causes for the problems of the decrease in quench water flowrate, abrasive wear of the coal water pipes, and blockage of the heat exchanger for ash water and the revamp measures, and after an inquiry into them, improvement measures are proposed

    摘要對化裝置激冷水量的降低、黑水管道磨損、灰水換熱器問題的產生原因及改造措施進行分析和探討,提出改進措施。
  6. It is found that the hub leakage flow leads to an increased flow blockage near the hub, resulting in drop of rotor performance

    結果表明:葉根泄漏可使葉根附近增大,造成轉子動性能的惡化。
  7. If transport vehicles fuel consumption air pollution caused by, resulting from packaging waste pollution, transportation and processing of the flow caused by noise pollution, waste of resources, urban congestion

    如運輸車輛的燃油消耗所造成的空污染,包裝所帶來的廢棄物污染,運輸和通加工所帶來的噪音污染、資源浪費、城市交通等。
  8. Underground logistic system ( uls ) has great significance for reducing traffic jams, air pollution and accidents caused by trucks

    摘要城市地下物系統對于改善由貨運卡車引起的交通、空污染和交通事故具有特別重要意義。
  9. Over the years, lrt technology has been upgraded to counter the negative effects of traffic jams, noise, environmental damage, air pollution, etc. featuring a small radius of curvature, multiple car units, modulated train set, enlarged cars both in transverse and longitudinal directions, low car floors, streamlined car design, advanced control systems, and flexible right of way, modern lrt systems have been successfully adopted to most environmental and social needs. they adequately display their merits as transportation systems ; i. e., the lrt system is able to co - exist with automobiles. the low car floor means that roads can act as station facilities, and passengers can get on and off the cars in the street

    輕軌運輸系統lrt源起於歐洲街道電車street car ,街道電車一度在都市捷運化與私人機動化的浪潮沖擊下迅速沒落,但隨著都會地區機動車輛不斷增加,道路交通阻噪音環境破壞排放廢污染問題嚴重惡化之際,輕軌車輛技術已不斷提升,具備小轉彎半徑能力的聯結式車廂模組化列車編組車廂斷面長度加大加長低地板車廂線型車廂設計,搭配先進控制系統及彈性的路權型式,使現代化輕軌系統具備有與生活空間結合重視環境問題與社會情勢並活用進化街車之都市交通工具等特徵與優點,如高性能輕軌列車與汽車共存,低底盤的車廂創造無障礙車站空間,道路即是車站設備,旅客可以在街區上下車,提供沿線居民高度的便利性,消除交通噪音及空污染等,輕軌系統並與街景充分的調和,成為活動的都市意象。
  10. This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed. on the basis of this new technology and the optimum blade profile, the performance of both the compressor and the turbocharger is largely improved. through the heating power calculation of the compressor, the analysis of the surge and the block of the compressor, the test - bed performance test of the turbocharger, the matching test of turbocharger and diesel engine, the propulsion test of the turbocharger on plateau condition, it is proved that the newly - designed compressor not only has high efficiency, but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area

    主要內容包括:提出一種全新的壓機葉輪技術和概念,這種技術將傳統的導風輪和壓機分開設計、單獨加工改為整體設計、整體加工的單體葉輪;從增壓器與柴油機配機計算所得出的基本參數出發,通過對壓機進行熱力計算,確定壓機的基本結構參數;再對葉型以及葉輪輪廓與葉輪罩殼的配合間隙進行優化,對新設計的壓機進行喘振和分析;通過增壓器平臺性能試驗,驗證了新設計的壓機的性能水平得到了較大的提高,達到了提高增壓器的整體性能水平的目的;通過增壓器與柴油機配機試驗、以及增壓器用於高原條件下的牽引試驗,驗證了新設計的壓機不但具有高效率,還改善了高效率區的量分佈,使牽引特性線貫穿高效率區。
  11. The abnormal conditions of polyester vaccum system such as the frequent exchanging of liquid - ring pump in prepolycondensation, the occlusion of scraped condenser and vaccum atmospheric leg, the eg spray flow decreasing of vaccum injection pump, the working performance on the low side of the injection pump itself were analysed

    摘要對聚酯真空系統的異常情況如預聚液環泵頻繁切換,刮板冷凝器、真空大、真空噴射泵eg噴淋量降低,噴射泵本體工作性能偏低等進行了分析。
  12. Sub - choking phenomenon of low - speed gas flow in a long - constant - area microchannel

    長微直管內體低速動的亞現象
  13. And based on the simulation of dynamic arc characteristics during the interrupting process, the interactive mechanism of the arc and high velocity gas flow has been deeply analyzed, the variation of the gas flow parameters under the condition of arc clogging and interaction of arc and shock wave have been studied

    在斷路器開斷過程動態電弧特性模擬的基礎上,深入解析了電弧與高速的相互作用機理,研究了電弧情況下噴口參數的變化,電弧與激波的沈陽工業大學博士學位論文摘要相互作用等。
  14. The operation of a heater with poor ventilation ; 3. the operation of a heater with good ventilation and air flue being partially blocked ; 4 the operation of heater with poor vetilation and air flue partially blocked

    模擬工況有以下幾種:廚房空通情況下熱水器正常使用;廚房空通情況下使用熱水器;廚房空通情況下,熱水器煙道部分;廚房空通情況下,熱水器煙道部分
分享友人