氣體蓄壓器 的英文怎麼說

中文拼音 [qìtǐxùyāqì]
氣體蓄壓器 英文
pressurizing-gas container
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 蓄 : 動詞1. （儲存; 積蓄） store up; save up 2. （留著而不剃掉） grow 3. （心裏藏著） entertain （ideas）; harbour
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 氣體 : gas; gaseous fluid
  1. Hydraulic fluid power - gas loaded accumulators - specification for seamless steel accumulator bodies above 0. 5 l water capacity

    液壓流體動力.氣體加載蓄能器.第1部分:水容量0 . 5l以上無縫鋼蓄能器體規范
  2. It is suitable to be used as the medium to filter the high purity and strong corrosive gas or liquid, the air plug of battery, gasket, seals for medium / low pressure, the waveguide tube pre - heater for boiler, the sealing wash, the cover of big - powered micro - wave antenna, and radar antenna of twt etc

    適用於過濾、高純度、強腐蝕性的氣體液體介質、蓄電池上作氣塞、襯墊、中低壓密封元件、鍋爐波管預熱器、密封圈和軍用微波大功率天線罩，以及行饋網路雷達天線等。
  3. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  4. Hydraulic fluid power. gas - loaded accumulators. calculation and test of steel accumulator bodies

    液壓傳動.氣壓蓄能器.鋼蓄能器殼體的計算和試驗
  5. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  6. The results show that : the lose of pressure is small when air velocity and the longth of honeycomb potter heat storage bed are varied ; but the switch time of air and the bulk of storage bed play important roles as regard its dynamic thermal performance

    結果表明：蜂窩型陶瓷蓄熱體換熱器的壓力損失隨著空氣流速以及蓄熱體長度的不同而變化，但總體上說，其壓力損失並不大；四通換向閥的換向周期和蜂窩陶瓷蓄熱體換熱器的體積等是影響其溫度效率和熱回收率等熱性能的重要因素。
  7. Finally, being aimed at a certain machine model, a experiment research about the means of relief valve to reduce hydraulic impact is carried out, which prove the founded prove founded mathematics model. also, some pending coefficient are amended and the optimum pressure of relief valve is determined. at the same time, a experiment and emulation research about the means of accumulator to decrease hydraulic impact is carried put, in which the optimum pneumatic pressure and the optimum primitive capacity of accumulator were determined

    最後針對某一具體機型，對用溢流閥方式減小液壓沖擊進行了實驗研究，驗證了所建立的數學模型並修正了待定系數，確定了溢流閥的最優調定壓力；對用蓄能器方式減小液壓沖擊進行了實驗和模擬研究，確定了蓄能器的最優充氣壓力和最優初始容積。
  8. Hydraulic fluid power - gas - loaded accumulators - dimensions of gas ports

    液壓流體動力.氣-液蓄壓器.氣體口的尺寸
  9. Hydraulic fluid power - gas - loaded accumulators with separator - selection of preferred hydraulic ports

    液壓流體動力.帶分離器的氣液蓄壓器.優選液壓埠的選擇
  10. Based on two application modes of the capsule accumulator in this system, the charge pressure and effective volume of the high pressure accumulator as an air spring and the performance parameters optimization with the jig working parameter determined was studied in this paper

    本文在簡要說明氣囊式蓄能器在跳汰機交流液壓系統中的高、低壓兩種應用的基礎上，對作為氣體液壓彈簧的高壓蓄能器工作容積的選擇與充氣壓力的問題進行研究，並在跳汰機工作參數確定的前提下，合理進行交流液壓系統中氣體液壓彈簧的參數優化。
分享友人
分享到 Line

分享到臉書