氧利用比率 的英文怎麼說

中文拼音 [yǎngyòng]
氧利用比率 英文
oxygen utilization ratio
  • : 名詞[化學] (氣體元素) oxygen (o)
  • : Ⅰ動詞1 (使用) use; employ; apply 2 (多用於否定: 需要) need 3 (敬辭: 吃; 喝) eat; drink Ⅱ名...
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • : 率名詞(比值) rate; ratio; proportion
  • 比率 : ratio; proportion; rate比率計 ratio meter
  1. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採有機硅單體延遲滴加及添加水解抑制劑等技術,有效防止了-甲基丙烯酰基丙基三甲基硅烷在乳液聚合過程中的過渡水解及縮合反應,提高了聚合物大分子鏈中有機硅鏈節的含量;紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵,並通過對共聚產物力學和吸水的測試,證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有純丙烯酸酯聚合物更優良的力學及耐水性能;從分子設計角度出發,醇解反應合成出水解、縮合反應速較慢的兩種新型不飽和有機硅單體: ?甲基丙烯酰基丙基三乙基硅烷和?甲基丙烯酰基丙基三異丙基硅烷;核磁共振對新型硅烷單體結構進行了證實;研究表明新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液,且其聚合產物具有較高的力學及耐水性能。
  2. The results indicate that ( a ) before heat treatment, with the increasing of substrate temperatures, content of lower valency ( tij + ) decreases, the stoichiometric proportion of o / ti in all samples is about 2 ; the films have amorphous incompact columnar fiber structure, and with the increasing of substrate temperature, the size of columnar fiber increases ; the films have good hyalescence in visible range and great absorbability at the wavelength of 350nm ; optical constants of the films are calculated from the transmittance spectrums in visible range by mathematical analysis of the orders of interference, the results show that the refractive ind

    研究結果表明, ( a )熱處理前,隨著基片溫度的增加,薄膜中的低價化鈦含量逐漸減少,化學計量趨于o ti = 2 ;薄膜具有非晶態不緻密的柱狀纖維結構,柱狀纖維的尺寸隨基片溫度的升高而增加;薄膜在可見光范圍內透明,在波長為35onzn時嚴重吸收,干涉級次法分析了薄膜的光學常數,結果表明,薄膜的折射隨基片溫度的升高而增加,根據計算結果得到了tioz薄膜在不同基片溫度下的折射色散曲線。
  3. Because of drying in vacuum, it has high speed under low temperature, its dry speed has raise 2 times, save sources, and the heat efficiency is high, especially adapt to material which is heat sensitive and easy oxidized

    由於是在真空下乾燥,在較低溫度下有較高速一般乾燥設備速度提高2倍,節約能源,熱高,特別適合熱敏性物料和易化物料的乾燥。
  4. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲水處理系統由於存在復雜性、非線性、時變性,本文根據臭生物活性炭水處理工藝存在復雜性、非線性、時變性等特點,將模糊控制應在水處理這一不確定的非線性時變系統,針對不同水溫下臭及水質的變化,設計一種基於系統過程狀態的變結構的模糊控制器,以單片機作為主要控制硬體,按查表方式設計軟體,對進水閥門開度進行在線控制,調節臭氣體與進水的例(臭流量及濃度不變) ,達到氣水最優化。
  5. Citigroup ' s initiative comes as wall street is rushing to capitalise on opportunities in areas such as alternative energy, energy efficiency and carbon emissions trading

    花期集團主動來了,華爾街急切地了在這些方面的機會,如可重復的能源,能源效和二化碳排放貿易等
  6. A composite electrode material comprising carbon nanotube and transition metal oxide may meet both the powerand the energy requirements. the properties of supercapacitor utilizing carbon nanotube as electrode material are studied

    通過充分其較大的表面積和適宜的孔徑,可望得到大容量、高功的超級電容器,與過渡金屬化物復合更能提高其綜合性能。
  7. In the case of sorbents prepared without naoh addition, both the ca utilization and the so2 capture increased with increasing slurrying temperature and varied with the bfs / hl weight ratio ; however, in the case of sorbents prepared with naoh addition, their ca utilization in creased to a level that was nearly independent of the slurrying temperature and the bfs / hl weight ratio

    未添加氫化鈉的爐石氫化鈣吸收劑與二化硫反應的鈣與二化硫捕捉隨漿化溫度的增加而增加,且隨爐石氫化鈣重量配而改變;添加氫化鈉后,吸收劑之鈣幾乎相同,不受漿化溫度與重量配影響。
  8. In order to otain high quality zno thin films, we, for the first time, employ the plasma enhanced chemical vapor deposition ( pecvd ) to prepare high quality zno thin film at low temperature using a zinc organic source ( zn ( c2h5 ) 2 ) and carbon dioxide ( co2 ) gas mixtures. the effects of the growing condiction and the native oxide layer of si substrate on the quality of zno thin films was studied in detail. to prepare p - zno and overcome the dufficulty of reverse due to the interaction between the n atomic, we obtain high qulaity p - zno by a easy way of thermal zn3n2

    為了在低溫下制備高質量的化鋅薄膜,我們採金屬有機源和二化碳氣源,首次等離子體增強化學氣相沉積的技術在低溫下制備了高質量的化鋅薄膜,系統地研究了生長條件以及襯底表面化層對薄膜質量的影響,確定了生長高質量化鋅薄膜的優化條件;為獲得p - zno材料,克服在zno中摻n雜質間相互作影響摻雜效不易獲得p - zno的困難,我們通過熱化zn3n2的方法制備了p - zno ,獲得了一系列研究結果: 1 、詳細研究了氣體流速,襯底溫度和射頻功實驗參數對化鋅薄膜特性的影響。
  9. The morphology of the sputter - deposited films were observed by scanning electron microscopy ( sem ) and atom force microscopy ( afm ). the effect of the power, discharged pressure, sputtering time and the ratio of ar / o2 on morphology has been studied

    掃描電鏡( sem )結合原子力顯微鏡( afm )研究了的濺射膜的表面形貌及成膜機理,並系統研究了各工藝條件(放電功、工作壓力、濺射處理時間、等)對表面形貌的影響。
分享友人