水冷壓縮機 的英文怎麼說

中文拼音 [shuǐlěngyāsuōjī]
水冷壓縮機 英文
water-cooled compressor
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 壓 : 壓構詞成分。
  • 縮 : 縮構詞成分。
  • 機 : machineengine
  1. Breaker, refrigerator over - load protection relay, refrigerant high pressure switch, air circulator thermal switch, fuse, overheat protector, alarm

    無熔絲開關，壓縮機超載保護開關，冷媒高壓保護開關，超溫保護開關，水盤缺水保護開關，電磁開關，故障警告系統，警報器
  2. Uncontaminated water is normally used as seal water for vacuum pumps and for compressor cooling as well as for sanitary use.

    未污染的水通常用作真空泵的密封水和壓縮機的冷卻水以及供保健用。
  3. It is the first time in china to set the speed increase gears form in the new compressor and to adopt several new techniques including the condenser with oil - separator built - in, jet exhauster and electrical expansion valve used to supply liquid for the flooded evaporator in the unit

    本壓縮機在國內首次採用了帶增速齒輪的形式，冷水機組在國內內首次採用了內置油分冷凝器、引射器和電子膨脹閥對滿液式蒸發器供液等新技術。
  4. Renovation to water circulation for hot water boiler

    氫氣壓縮機機封冷卻水循環利用改造
  5. The experts of the inside and outside nations company had researched and developed the " super cool star " which was the had standard of international and it is addi - tive of the highly effective refrigeration conservation, this is the product of simple use and the high technical ， could rapidly promote the refrigeration effect, the energy conservation to reach above 20 %

    公司聯合國內外專家共同研發了具有國際水平的「超冷星」 ? ?高效製冷節能添加劑，該產品使用簡單，技術含量高，能迅速提升壓縮機的製冷效果，節能達20 %以上。
  6. Magswitch is suitable for many liquid and gaseous media, and is used in vacuum technology pump actuation, refrigeration technology compressor control, gas technology supply monitoring, leak detection, filter monitoring soiling detection, filling level measurement overfilling protection, dry running protection and for many different measuring tasks in hydraulic and pneumatic systems, in mechanical engineering and in building service engineering

    磁控開關適應多種液體和氣體，並應用於真空技術泵啟動，冷藏技術壓縮機控制，瓦斯技術供給控制，密閉性檢查，過濾控制污染探測，填充狀態測量防過滿，防干運行，以及許多水壓，氣壓系統的測量任務，還有機械工程，屋宇設備工程中。
  7. By using a same boundary dimensions high efficient and new type copper exchanger substituted carbon steel oil condenser, and increasing flow rate of circulation water to reduce the temperature of freezing oil which feeds into compressor stage, to eliminate the malfunction during compressor operation, and improve running efficiency of the machine

    採取將碳鋼材質的油冷卻器更換成等外形尺寸的高效新型銅管換熱器、增加循環水流量的方法，降低了進入二段壓縮機冷凍油溫度，排除了壓縮機運行中的故障，改善了機組的運行效率。
  8. 9 series pressure cavity is made of stainless steel single unit integration structure by processing so may guarantee for the better seal performance. the characteristic of product are no o - ring, no welded, no silicon oil or other organic, structural durability ; the most apply to pump and compressor, liquid pressure and pneumatic system, go - anywhere vehicle, energy and water processing system, pressure instrument, refrigerating equipment, agricultural machinery device, locomotive braking system

    9系列壓力腔採用不銹鋼單件一體式結構加工而成，因而可以保證較好的密封性能， 9系列產品的特點是無o形圈無焊縫無硅油或其它的有機物，經久耐用，主要應用於泵及壓縮機，液壓及氣動系統越野車能源及水處理系統壓力儀表冷凍設備農機設備機車剎車系統。
  9. A refrigerant charge model is established to predict the effect of refrigerant charge inven

    壓縮機耗功t均隨冷卻水和冷凍水溫度的升高而增加。
  10. Fini air treatment systems for industry are composed of refrigerating dryers, filters for separating impurities, condensate drain cocks, water - oil separators, tanks and all other components necessary for adapting the compressor room to your needs

    工業用的fini空氣處理系統由冷藏乾燥器組成，專用於壓縮機房的空壓機由濾波器分開雜質，排水閥，水油分離器，氣罐和全部必要的其他零部件等適合你的需要。
  11. Fini air treatment systems for the woodworking industry are composed of refrigerating dryers, filters for separating impurities, condensate drain cocks, water - oil separators, tanks, and all other components necessary for adapting the compressor room to the needs of the sector

    木工行業的fini空氣處理系統由冷藏乾燥器組成，分開雜質的過濾器，直立式排水道，水油分離器，氣罐和其他組成部分都為適應壓縮機房的需要而設計。
  12. Simulation results show that the surge line moved up - left relative to the original one and surge margin became larger when wet compression is used, which means wet compression can extend steady - operation regions of compressors and the si a - 02 gas turbine. at last, based on the moore - greitzer model surge and rotating stall of a compression system with wet compression is modeled with consideration of inlet evaporative cooling and compressor pressure rise when wet compression is used

    哈爾濱工程大學博士學位論文最後，本文在壓縮系統moors grei上zer模型的基礎上，考慮進口蒸發冷卻的作用和壓氣機濕壓縮過程的作用，推導出了濕壓縮系統喘振和旋轉失速的統一模型，該模型可以模擬系統發生喘振和旋轉失速時的瞬態響應以及噴水濕壓縮對系統瞬態響應的影響。
  13. The results show that, when the compressor continuously runs, the stability of the test bed after using manual valve is better than that of using thermal valve, and it is little affected by the kinds of valves for adjusting cooling water ; and that, when the compressor intermittently runs, the operation stability would be obtained if pneumatic valve is used to adjust cooling water, especially at low speed

    結果表明，壓縮機連續運行時，製冷劑採用手動閥調節后工況的穩定性明顯好於採用熱力膨脹閥時的情況，此時調節冷卻水量用的電動調節閥和氣動調節閥對工況穩定性影響相差無幾；間歇運行時，無論是熱力膨脹閥還是手動閥，即便壓縮機通電時間最長，仍達不到設定工況，特別是低速的斷續尤為明顯，而使用氣動閥就能很好地解決這一問題。
  14. Air conditioners, liquid chilling packages and heat pumps with electrically driven compressors. heating mode. part 3 : testing and requirements for marking for sanitary hot water units

    帶電驅動壓縮機的空調器，液體冷卻設備和熱力泵.供暖方式.第3部分:衛生用熱水裝置的試驗和標記要求
  15. With the refrigeration equipment industry as the background, xi " an qingan refrigeration equipment co. ltd as the research object, lean production management as the fundamental theory, this article is to analyze the current conditions and problems in the organizational pattern of assembly line, ways of purchasing materials, storage and production management information system in xi " an qingan refrigeration equipment co. ltd, to discuss the adaptability, feasibility and applied condition of lean production management, to compare the production, purchase, storage and production management information system before and after lean production management is adopted and the different effects, to pose efficient methods of purchase, production and storage which have been proved effective and feasible, to research method and experience attained during the application of lean production management, to offer proposition and assumption to apply lean production management, and to reach the conclusion that to enhance competitive ability the application of lean production management is the inevitable choice of the xi ' an qingan refrigeration equipment co. ltd

    本文以空調製冷和壓縮機行業為研究背景，以「慶安製冷」公司為研究對象，運用精細生產管理的基本理論，對「慶安製冷」公司空調壓縮機多品種中小批量的流水線生產組織模式、采購模式、庫存模式和生產管理信息系統中的管理現狀及存在問題進行了分析，探討了精細生產管理模式在「慶安製冷」公司應用的適應性、可行性和應用條件，對比分析了公司開展精細生產管理前後生產組織、采購、庫存、生產管理信息系統取得的成效，提出了公司的采購過程模型，零部件最優庫存控制模型，並經實踐驗證有效可行。文章研究分析了公司總裝車間開展精細生產管理的思路、方法和經驗，並對公司未來運用精細生產管理方式提出了改進建議和設想。文章得出的結論是：應用精細生產管理方式是「慶安製冷」公司提升競爭力的必然選擇。
  16. Air conditioners, liquid chilling packages and heat pumps with electrically driven compressors - heating mode - testing and requirements for marking for sanitary hot water units

    帶電動壓縮機的空調器.液體製冷設備和熱力泵.加熱方式.衛生間熱水裝置的試驗和標記要求
  17. It specifies the process of the design, simulation and experiment of liquid cooling system. main contents of the thesis are as follows : description of the present usage of liquid cooling system, presentation of a new type of liquid cooling system and description of its work principles ; design of the liquid cooling system, which mainly deals with the design and collating calculating of serpentine condenser and heat exchangers adopted in this system. meanwhile, the model chosen calculating of compressor 、 thermal expansion valve 、 plate evaporator 、 water pump and the like equipment used in the system are also carried out

    本文的主要內容如下:對液冷源使用現狀進行了描述，提出了一種新型液冷源系統並對其工作原理進行了闡述;對系統進行了設計，主要對系統中所採用的管帶式冷凝器和水側空/液換熱器進行了設計和校核計算，同時對系統中所用到的壓縮機、熱力膨脹閥、板式蒸發器、水泵等配套設備進行了選型計算;分別對製冷系統和冷卻液循環系統進行了數學建模。
  18. Blx - s series of water cool machines adopt original semi - seal cool - media compressor, which provides high efficiency, convenient maintain and reliable motion

    Bxl - s型冷水機組採用原裝進口螺桿式半封閉冷媒壓縮機，效率高，維修方便，運行可靠。
  19. Abstract : the performance of screw compressor in air - source heat pump heater / chiller unit operatingin winter is simulated using the neural networks

    文摘:採用神經網路對冬季運行的空氣源熱泵冷熱水機組中螺桿式壓縮機的特性進行了模擬。
  20. Through theoretical analysis and real machine demonstration, the control measure of " ensuring stable status of the specific chiller by utilizing plc technology and by controlling the operating pressure of the water chiller of the cooling system through electric 3 - way regulating valve " was researched

    摘要通過理論分析和實機驗證，研究了「利用plc控制技術通過電動三通調節閥控制製冷壓縮機的冷凝壓力，進而保證冷水機組的狀態穩定」的控制措施。
分享友人
分享到 Line

分享到臉書