水力傳導率 的英文怎麼說

中文拼音 [shuǐlìzhuàndǎolǜ]
水力傳導率 英文
hydraulic conductivity
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 水力 : waterpower; hydraulic power水力剝離 [采礦工程] hydraulic stripping; strip with water; 水力采礦 hy...
  1. 2 photosynthetic rate, transpiration rate and stomatal conductance in four species are higher in forenoon than in afternoon, it is mainly due to daily decreasing soil water

    2 、四物種的光合速率、蒸騰速率和氣孔傳導力在上午時均比下午大，這主要是由於一天中土壤水分逐漸減少所影響。
  2. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  3. 3 environment factors have some effects on photosynthetic rate, transpiration rate and stomatal conductance, and the effects show difference with changing species and treatments

    3 、環境因子對四物種的光合速率、蒸騰速率和氣孔傳導力均有一定的影響，隨著種和水分梯度的不同，表現出不同的影響差異。
  4. We analyzed the alternative in functional phenotypic plasticity responding to variational entironments, consequently, we interpreted the difference between endangerment and wide - distribution of these closely related species, and the results showed : 1 all of the daily changes of photosynthetic rate responding to different water status show " double apices " except m. d, the daily changes of photosynthetic rate in m. d shows " simple apices " responding to arid soil water content, while " double apices " responding to the other soil water content. emerging time of daily maxim of pn is difference between species and between treatments. daily course of transpiration and stomatal conductance of these for species all show " double apices ", but the emerging time of daily maxim of transpiration rate and stomatal conductance rate are all different between species

    結果表明： 1 、除小魚仙草外，四物種的光合速率日變化在不同水分梯度下均表現出「雙峰型」 ，小魚仙草的光合速率日變化在於旱時表現出「單峰型」 ，其餘水分梯度下表現出「雙峰型」 ，種間和梯度間日最大光合速率出現時間有一定的差異；四物種蒸騰速率和氣孔傳導力日進程也表現出「雙峰型」 ，但種間日最大氣孔傳導力和蒸騰速率出現的時間也存在一定的差異。
  5. Method for determination of the relative hydraulic conductivity of permeable surfacings

    可滲透表面的相對水力傳導率的測定方法
  6. In order to examine the influence of soil hydraulic characteristics on land surface process, the four soil hydraulic models are coupled with the simplified simple biosphere model ( ssib ) respectively and the simulated net radiation, sensible heat, latent heat and soil heat fluxes by the four coupled model are compared

    利用ssib模式研究了不同的土壤水力模式對陸面過程模式模擬結果的影響。利用ssib mm5耦合模式研究了在陸面過程模式中土壤水力傳導率等計算上的差異對大氣模式模擬結果的可能影響。
  7. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  8. The properties of the membranes such as proton conductivity, water uptake, swelling degree and thermal stability were measured. results show that the sulfonated sbs membranes had good proton conductivity, at the same time, the water uptake and the swelling degree could meet the need of fuel cell

    通過對不同磺化度的質子交換膜的電性能、吸水率、溶脹率以及熱穩定性等性能進行了研究，表明磺化sbs膜具有了比較好的質子傳導能力，吸水率與溶脹率也能滿足燃料電池的工作需求。
  9. This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed. on the basis of this new technology and the optimum blade profile, the performance of both the compressor and the turbocharger is largely improved. through the heating power calculation of the compressor, the analysis of the surge and the block of the compressor, the test - bed performance test of the turbocharger, the matching test of turbocharger and diesel engine, the propulsion test of the turbocharger on plateau condition, it is proved that the newly - designed compressor not only has high efficiency, but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area

    主要內容包括：提出一種全新的壓氣機葉輪技術和概念，這種技術將傳統的導風輪和壓氣機分開設計、單獨加工改為整體設計、整體加工的單體葉輪；從增壓器與柴油機配機計算所得出的基本參數出發，通過對壓氣機進行熱力計算，確定壓氣機的基本結構參數；再對葉型以及葉輪輪廓與葉輪罩殼的配合間隙進行優化，對新設計的壓氣機進行喘振和堵塞分析；通過增壓器平臺性能試驗，驗證了新設計的壓氣機的性能水平得到了較大的提高，達到了提高增壓器的整體性能水平的目的；通過增壓器與柴油機配機試驗、以及增壓器用於高原條件下的牽引試驗，驗證了新設計的壓氣機不但具有高效率，還改善了高效率區的流量分佈，使牽引特性線貫穿高效率區。
  10. At the fixed temperature level, both the permeability and hydraulic conductivity of sandstone decrease with the increasing effective stress, following the law of negative exponent. at the fixed effective stress level, however, the function between hydraulic conductivity and temperature is not a monotone one

    在溫度一定的條件下，砂巖的滲透率和水力傳導系數均隨有效應力的增加而呈負指數規律減小，但在有效應力一定的條件下，水力傳導系數與溫度之間的關系函數並非單調函數。
  11. The results in this study can be summarized by the following : ( 1 ) some difference of calculated soil hydraulic conductivity and soil matric potential are existed in different soil hydraulic models

    研究結果表明：不同的土壤水力模式對土壤水力傳導率和土壤水勢的計算結果是有差異的，而這種差異會影響陸面模式中土壤濕度的模擬。
  12. Traditional electromagnetic hydrodynamic propeller in water, which depends on super conduct technique, generates the stronger thrust. but the disadvantages that have strict request with super conduct material and difficult realization and low efficiency restrict the application of this technique in a large of degree

    傳統的水中電磁流體推進可以產生較大的推力，但它主要依賴于超導技術，對超導材料的要求嚴格、實現困難、效率低，在很大程度上制約了這種技術的應用。
分享友人
分享到 Line

分享到臉書