水力射流 的英文怎麼說

中文拼音 [shuǐshèliú]
水力射流 英文
hydraulic jet
  • : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 水力 : waterpower; hydraulic power水力剝離 [采礦工程] hydraulic stripping; strip with water; 水力采礦 hy...
  1. The additional flow is formed by the device of dentoid baffle, and the application of the device of dentoid baffle cooperated with a stilling basin has been investigated by systematic model tests. based on the research results, the hydraulic problems such as the characteristics of hydrodynamic pressure and cavitation on the head of the denotid baffle, the properties of flow under the condition that the device of denotid baffle is used with a stilling basin, the hydraulic computation about a stilling basin, the estimation of energy dissipation and its various affection factors, the mechanism and effect of energy dissipation, and distributions of velocity and pressure and aerating concentration, etc, have been analyzed ; the method and step of hydraulic design of device of denotid baffle by which the additional flow is produced has also been proposed

    文中利用齒墩設施實現附加,對齒墩設施與消池聯合應用進行了大量的和系統的模型試驗,分析研究了中低佛勞德數條件下,齒墩墩頭的動壓強及空化特性,齒墩設施與消池聯合應用時的態特性,消池的計算,消能量的估算及其各種影響因素,消能機理和效果,消池內的速、壓強特性,摻氣濃度分佈等學問題,並提出了實現附加齒墩設施的設計方法和步驟。
  2. The water current flows over the top of the dentoid baffle to the hydraulic jump as additional momentum. while it is cooperated with a stilling basin, the flowing condition emerged in the basin may be improved greatly and the length and downstream water depth required by the basin can be decreased to a great extent. such an appliance may be also used to solve the problems of insufficiently dissipating water flow energy and aerating flow, which are often faced with those hydraulic engineering constraction as acted by high waterhead, great specific discharge and low froude number

    本文通過齒墩頂部的擴散舌所形成的附加,從上部躍,即可改善消池內的態,又可降低第二共軛深,減小躍長度,增進躍消能效果,同時還能解決大單寬、低佛勞德數條件下摻氣和消能不足的問題,試驗證實它是一種安全、經濟的消能工。
  3. To utilize hydraulic soil evaporimeter and supporting meteorology, radiation, the materials on the surface water evaporation, considering the influence of each factor of " soil - plant - atmosphere " system on soil evaporation, we set up calculating model of the soil evaporation which is suitable for the heilonggang region

    利用式土壤蒸發器及其配套的氣象、輻面蒸發儀器觀測資料,綜合考慮「土壤植物大氣」系統中的各個因素對土壤蒸散的影響,建立了適于黑龍港域的土壤蒸散量計算模型。
  4. The major work is as follows : solution of two dimensional radiation or diffraction fluid field. this thesis extends multipole expansion method to adapt to disturbed fluid fields of 2d floating bodies with asymmetric forms, which is applied with symmetric forms originally. and given the solution of potential velocity and hydrodynamic pressure of radiation and diffraction fluid fields, which is incited by a 2d arbitrary form, actual application field of the multipole expansion method has been enlarged

    關於二維擾動場的求解:將通常僅適宜求解具有對稱形狀二維物體擾動場的多極展開法(保角變換方法)擴展至非對稱形狀二維物體,給出了任意形狀二維物體的輻和繞場的速度勢及動壓的頻域解,進一步擴大了多極展開法的實際應用范圍。
  5. The characteristics of high pressure gyratory sprayed pumping discusses is presented, which is applicable in wide range of scope and ground layers, convenient for construction, long durability, wide source of materials. mechanism for subgrade strengthening : complex foundation of cement solid and earth between piles was formed by pulsant load of flowing pressure and spraying flow, water wallop, cavitation phenomenon, water wedge effect, extrusion force and air flow agitation etc so as to enhance foundation bearing force and reduce settlement and deformation

    高壓旋噴注漿技術具有適用范圍、適用地層較廣,施工方便,耐久性好,材料廣闊等特點;其加固地基機理主要是通過動壓、噴的脈動負荷、塊的沖擊、空穴現象、楔效應、擠壓、氣攪動等效應形成泥固結體與樁間土的復合地基,從而提高地基承載,減少沉降變形。
  6. Study on pressure stability of ultrahigh - pressure water jet system

    超高壓系統壓穩定性研究
  7. For two up and down jets plunging into a cushion pool, two factors of up depth and down depth of water cushion are first introduced actually, then the methods calculating the reasonable depth of cushion pool and the reasonable distance between up jet and down jet are introduced

    針對上、下雙股舌入墊塘時墊塘底板上的壓變化規律,首次根據理論提出了上、下墊深度的概念及其計算方法,並進而提出了計算墊塘合理深度及墊塘內舌合理入間距的方法。
  8. The hydrauli c model of gradual dike - break simulates numerically the 2 - d flow of gradual dike - break waves. it shows the variation of flow field on breach, and the complicated flow characteristic of the propagation, diffraction, reflection and deformation of the dike - break waves. the hydraulic model can realistically simulate the burst process of dike, and computational accuracy is satisfied with the engineering demands

    本文建立逐漸潰堤的模型首次對二維逐漸潰堤波的動問題進行了數值研究,揭示了逐漸潰堤過程中潰口處場的變化情況,以及潰堤波的傳播、繞、反及變形的復雜運動特徵,能較好地模擬實際工程中的潰堤失事,模擬比較逼近於真實潰決過程,計算精度可滿足工程要求。
  9. Analysis of forces acting on abrasive particles in abrasive water jet

    磨料中磨料顆粒的受分析
  10. For a single jet plunging into a cushion pool, a method of calculating depth of the pool is introduced according to the maximum water pressure on the pool bottom and the jet theory ; 7

    對于單股舌入墊塘的情況,以理論為依據,建立了以墊塘底板上所受動為控制參數的墊塘深度的計算方法; 7
  11. The main work in this paper includes three parts : the theory research on partially - cavitating and super - cavitating axisymmetric bodies, the numerical computations and experimental investigations on partially - cavitation and super - cavitation on axisymmetric bodies. after finishing the study of theory and experiment on the partially - cavitation and super - cavitation for axisymmetric body, i use the potential flow theory to build the mathematical model on the partially - cavitation and super - cavitation for axisymmetric body. many cavity wake models, such as pressure recovery close model, riabouchinsky model and re - entrant jet model, are studied seriously

    本文在深入研究了回轉體局部空化與超空化理論及實驗結果的基礎上,基於勢理論,建立了回轉體局部空泡和超空泡場的基本數學模型,通過對kinnas和fine 、 uhlman以及jiedang和gertkuiper等人基於二維翼提出的壓恢復閉合模型、鏡像板模型和回模型等空泡尾模型進行了逐一的研究分析,發現其中的壓恢復閉合模型較適用於模擬回轉體空泡尾部場,並選用此空泡尾模型作為求解回轉體空化場正問題與逆問題的數學模型的組成部分。
  12. Author has investigated the air - volume affect the pressure oscillation in piping system from converse viewpoint. when the structure parameters of the air - volume are some certain value, the pressure oscillation in the exit of the piping system is magnified. this idea makes us a new way to design the power source of high pressure water - jet

    研究表明:當設計的空氣室結構參數(空氣室的容積,安裝位置等)取某組數值時,管道出口端的壓波動幅值遠大於系統輸入壓波動幅值,從而為設計高壓脈沖的動源提供了一條新的思路。
  13. A presentation is given of the renovation plan and process flow for the hydraulic injection vacuum supply unit, which is used to replace the former steam injector

    摘要介紹了採用抽真空裝置代替原蒸汽噴裝置的改造方案及程。
  14. Phenomena, such as flow field confusion and slagging etc. have occurred in the practical process of cyclone burner for coal - water slurry ( cws ) firing, on this basis a study on aerodynamic field of cws cyclone burners had been carried out through cold state experiments in the laboratory, then the influence of burner ' s structure properties upon the said flow field had been carried out, and expected to find more reasonable structure of the burner was found. in my study the focus is on the affection of cone and cyclone intensity in the condition of infinite and finite fields

    本文著重研究現有煤漿旋燃燒器的旋葉片角度,一次風擴口的長度以及角度對旋燃燒器出口場的影響,通過場的比較,以期得到性能較好的旋燃燒器。考慮到煤漿燃燒器中心的煤漿對于其空氣動場的影響,本文在實驗室冷態實驗研究的基礎上,模擬煤漿,研究其對燃燒器空氣動場的影響。
  15. Calculation method and affecting factors of productivity for deep penetrating perforation with hydraulic jet flow

    深穿透水力射流孔產能的計算及影響因素
  16. Hydraulic seeding - part 2 : hydraulic seeding in current agitating - technical requirements

    播種機.第2部分:攪拌式噴播機.技術條件
  17. The paper introduces the work principle, characteristic and purpose of the ultrahigh pressure abrasive waterjet cutting equipment

    摘要本文介紹了超高壓磨料切割機的工作原理、特性和用途。
  18. Secondly, the helmholtz oscillator was designed. based on the flow network theory, the expression of intrinsic frequency was deduced. the main parameter of helmholtz oscillator was calculated

    對于同一結構的helmholtz共振腔,參數不同,所產生的自激振蕩脈沖的強弱也不相同。
  19. According to the selected project, a stability test with scale of 1 : 35 of cushion bottom had been done. with the research results of the experiments and the flow shape of xiao wan hydraulic power station were thought about, on the other hand, the ternary complex jet shape of baishan water cushion was analyzed, all this gave a base for the analysis of the force of the cushion bottom. through observation, the dynamic water pressure, the fluctuation pressure, the time - homogeneous pressure on the surface of the bottom and the characteristics of the fluctuation pressure could be got, also the calculation method and the test results were compared to get the argument

    針對選定的方案,進一步做了1 : 35比尺的墊塘底板穩定性試驗;通過試驗及借鑒小灣墊塘內態的研究成果,分析白山墊塘內三元復雜淹沒態,為墊塘內底板受分析打下基礎;通過觀測得到墊塘底板動沖擊壓、脈動壓、底板上下表面的時均壓及脈動壓特性,並通過計算方法與試驗成果進行相互比較論證。
  20. Research on the behavior of buoyant jet from square orifice in static ambient

    中正方形孔口浮特性的研究
分享友人