水輪機的轉輪 的英文怎麼說
中文拼音 [shuǐlúnjīdezhuǎnlún]
水輪機的轉輪
英文
rotor-
Because of the technical complexity of the turbine for the three gorges project and on the basis of several important technical problems which have been defined in the international bidding documents for 14 generating units in the left bank power station, the owner of the project has decided another some important technical problems based on appraisal and comparison in the bid appraisal stage after the bidding documents are analyzed and the tender documents are cleared by the tenderers
由於三峽工程水輪機技術上的復雜性和挑戰性,在左岸電站14臺機組國際招標文件已明確了若干重大技術問題的基礎上,在機組議評標階段,對招標文件進行分析和投標商對投標文件進行澄清說明后,經評議比選,業主又決策了幾個重大技術問題,主要有:水輪機設計水頭的確定,負傾角葉片水輪機的應用,兩套水力設計,舍棄初期轉輪,蝸殼進行水壓試驗等。Many large capacity turbine runners in commercial running have come to cracks or vibration problems with different extent in china. therefore, to ensure the large francis turbines running safely and stably is an important issue on design and type selection research
在我國陸續投運的大型水輪機轉輪相繼不同程度地出現振動與裂紋,因此,保證大型混流式水輪機的安全穩定運行就成為設計選型研究的重要問題。Calculation for transverse force of vibration in turbine runner induced by draft tube surges
水輪機尾水管渦帶誘發的轉輪橫向激振力計算The paper lucubrated on retrofit design of francis runner hl240
本文對hl240混流式水輪機轉輪的改型設計進行了深入的研究。Energy losses leading to a decrease in head are also done away with, likewise losses in flow rate from the screening installations, both of which can have a detrimental effect on the efficiency of the facility. the constructional effort required for a hydrodynamic screw is small compared to that required for a turbine. if the compact version of a hydrodynamic screw hydrodynamic screw trough power take - off unit combined as a single unit is used, the constructional effort can be further reduced
水力螺旋機技術的優點有:無需監控系統,可自行調節水體供給和供給頻率運行效率高於水輪機和小型渦輪機效率梯度平穩轉速低20rpm - 80rpm ,運行穩定防磨損無需定期清潔,易維護對河道湖泊里的魚蝦無損害基礎工事少,安裝簡便無堵塞,無需隔欄裝置能量利用充分等。A computer drawing program of water turbine operating characteristic curve based on autocad
的水輪機運轉特性曲線自動繪製程序This paper elaborates the parameters selection of the 700mw turbine for laxiwa power station located upstream yellow river, which is coming into construction soon. through statistical calculation of specific speed for turbines with large capacity, high operating head in domestic and oversea power station, utilizing turbine homologous theory. adopting regression statistic calculation method, it has got specific speed statistic equation., the demonstration of primary parameters selection, and the primary target parameters suitable for laxiwa power station
本文針對黃河上游即將開工建設的拉西瓦水電站700mw水輪機的參數選擇進行了研究,通過對國內外的大容量、高水頭水輪機的比轉速統計計算,利用水輪機的相似理論,採用回歸統計計算方法,統計出了比轉速統計方程,並進行了水輪機主要參數選擇論證,提出了適合拉西瓦水電站水輪機的主要目標參數。A pcc based stepping motor driven dual control governor for kaplan turbine is presented in this paper. the governor adds the function of adaptive control of blades and radius basis function cam network based on the current pcc based stepping motor driven single control governor
該調速器在當前pcc步進式水輪機單調整調速器的基礎上引入了槳葉自適應控制和基於rbf網路的協聯裝置,可定期對轉槳式水輪機協聯關系進行自校正,保證水輪機始終運行在較高效率區。The axial flow type turbines are available for hydrauric power resources of medium and low heads. ganfa manufactures both the propeller type fixed blade type and the kaplan type adjustable blade type turbines. the propeller type turbines are suitable for hydropower stations with small or medium capacities and heads, and relatively stable loads. the kaplan turbines are suitable for hydropower stations with medium or large capacities and heads, and relatively unstable loads
軸流式水輪機適應于開發中低水頭水力資源。我公司生產的軸流式水輪機按轉輪結構分為定槳zd轉槳zz兩種,定槳式一般適用於中小容量及水頭負荷變化較小的的水電站轉槳式多用於大中型電站及水頭負荷變化較大的水電站。The repair and maintenance work of the turbine blades is the international problem for all the hydro power plant. a lot of manpower and resources is costed every year, especially in china, because the rivers contain plentiful sand, the problem is more serious
水輪機轉輪葉片的維修與維護一直是各國水電部門的一項重要工作,每年都要對其耗費巨大的人力、物力、財力,尤其是我國河流泥沙含量大,此項工作就更為艱巨。Design of main structures at yaoheba hydropower station
混流式水輪機轉輪流道數據庫系統的設計及應用研究The transient cfd simulation including the spiral case, stay vane, guide vane, runner vane and draft tube at different operation points is studied fitly, then the result of the pressure distribution on runner blade is provided for the runner transient structural simulation by fluid - structure interaction ( fsi ) method
文中首先對高水頭小負荷的渦帶工況下混流式水輪機內流場進行非定常cfd計算,得到渦帶工況下葉片表面不同時刻的水壓力載荷,並利用流固耦合方法對轉輪進行結構場瞬態特性計算,分析轉輪葉片的動應力特性。Aiming at the problems in the field of the government for hydraulic turbine, this thesis applies the technology of programmable controller to the speed control of hydroelectric generators in hydropower station. a digital regulating system based on the fx2 programmable controller for the water - gate and paddle of hydraulic turbine is developed. first, the turbine regulating system is briefly introduced and the mathematics model of the system is derived
本文針對當前我國水輪機調速器領域技術現狀,將可編程式控制制器技術應用於水電廠發電機組的轉速控制,提出了在應用可編程式控制制器實現導葉控制系統的基礎上,以可編程式控制制器實現導葉、輪葉雙調整控制系統,並參與研製了以fx2可編程式控制制器為核心的水輪機雙調節控制器,樣機的實際運行良好,系統的軟硬體設計得到驗證,結果令人滿意。The tubular turbines are the best selection for exploitation of tidal power and hydraulic power with extremely low heads and extremely large flow rates. they have large discharge, high specific and high efficiency, and need less excavation. they have been classified into bulb, pit, siphon and " s " types in the light of their structural types
貫流式水輪機是開發特低水頭,特大流量水電站及潮汐發電的良好機型。該機具有開挖量小,過流量大,比轉速高等特點。按其結構型式分燈泡式豎井式軸伸式等。In order to resolve the question, in the thesis a simulation arithmetic of hydro - electrical system is put up. the equations of hydro - electrical system are divided to two parts, one of which consists of the differential equations of conduit system, hydro turbine and generator ' s rotator and is solved by characteristic equation arithmetic, the other of which consists of the differential equations of generator, magnetic system and grid and is solved by longge - kuta arithmetic or covert integrated arithmetic. through the alternative solving of the two parts, the simulation results of the large - disturbance transient could be abstained eventually
為解決這一問題,本文提出了一種將水力系統和電力系統方程交替求解的水電系統聯合模擬演算法,即將包括輸水系統、水輪機以及機組轉子等部分的水力系統差分方程作為一部分,將包括同步發電機、勵磁系統以及電網等部分的電力系統微分方程或差分方程作為另一鄭州大學工學碩士論文部分,對前一部分採用特徵線法求解,對后一部分根據模型形式採用龍格一庫塔法或隱式積分法等演算法求解,這兩部分的求解過程交替進行,最終即可得到水電系統大擾動過程的模擬結果。The result indicates that the dynamic stress caused by hydraulic pulse at partial load is one of the important reason of the fatigue and cracks of the runner
結果表明由於水壓力脈動引起的轉輪葉片上的振動交變動應力是混流式水輪機疲勞破壞的主要原因之一。The repair and preservation work of the turbine blades is the international problem for all the hydro power plant
對水輪機轉輪葉片的維護與維修是各國水電部門的一項重要工作,每年都要在其上耗費大量的人力、物力、財力。A measurement method applied to detect the dfects of the turbine blades
水輪機轉輪葉片表面缺陷的檢測方法A new and simple method for drawing equi - efficiency locus on combined operation characteristics of hydraulic turbine
水輪機運轉綜合特性曲線中等效率線的簡捷新繪法The problem of the digitalization of turbine model ' s characteristic curve is discussed for the requirements of turbine performance curve drawing automatically
摘要從自動繪制水輪機運轉綜合特性曲線出發,探討了水輪機模型特性曲線的數字化的問題。分享友人