汽水分離器 的英文怎麼說

中文拼音 [qìshuǐfēnlíqì]
汽水分離器 英文
automatic return trap
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 汽水 : 1 （飲料） mineral waters; aerated water; soft drink; soda water; gazoz; highball2 （汽、水） ste...
  1. Cyz - a self - priming centrifugal oil pump according to domestic and international to develop newest pump products that become after digesting, absorbing, improving about technical data by oneself, domestic blank, unique, extensively suitable for the oil depot, service station, oil ship, oil carrier, quay, oil truck, airport, send the petrol, kerosene, diesel oil, boat coal etc

    型自吸式離心油泵是根據國內外有關技術資料經消化、吸收、改進后研製而成的最新泵類產品，國內空白獨一無二，該泵適用於石油行業、陸地油庫、油灌車的理想產品，並適合於作船底泵、消防泵和壓載泵及機器冷卻水循環等，分別輸送汽油、煤油、柴油、航煤等石油產品和海水、清水，介質溫度- 20 80 ，加輸送化工液體可改用耐腐蝕機械密封。
  2. For the most demanding hobbyists, fini offers air lines, filters, pressure regulators, water - oil separators, and miscellaneous connecting elements to satisfy any need and transform your garage into a well - equipped small workshop

    面向更多要求的愛好者， fini提供輸送線，過濾器，壓力調節器，水油分離器，以及各種各樣的連結件滿足任何需要並且把你的汽車庫轉變成一間裝備良好的小工場。
  3. The characteristic of “ t ? sun ” electric heatingboiler is “ no vapor carry liquid problem ” generally, mini boiler have vapor carry liquid problem

    獨特的內置式汽水分離器解決了一般同類產品蒸汽帶水的難題。
  4. The company mainly produces high - tension and low - tension electric equipment, thyristors electrical machinery soft starter, automatic regulating silicon piles etc. it developed the technology with own patent adopting sun shape heat tube radiators with steam and water separated, and developed the integrated power module unit including thyristors and rectifiers with the technology. the products organization is novel, and it conducts heat rapidly and has solved the difficult problems of heat dissipation in generator excitation and exchange power

    公司主要生產高低壓成套電器低壓動態無功補償裝置晶閘管電機軟啟動自動調壓硅堆等產品。研製開發出了「日」字形汽水分離式熱管散熱，並利用該技術開發了晶閘管整流管一體化功率組件，結構新穎，傳熱迅速，為發電機勵磁交流調功等領域解決了器件散熱難題，產品的各項性能均處于國內外領先水平。
  5. Xinchang asian ace automobile bearing co., ltd, an integrated technological enter prise featuring scientific research, development and manufacturing, specializes in the production of tapered roller bearings, cylindrical roller bearings, clutch release bearings, auto steering bearings, wheel hub bearings and so on, which are mainly exported to such countries and areas as usa, europe, africa, south asia and middle east

    浙江新昌亞王汽車軸承有限公司位於浙江特色軸承工業園?新昌西山，是一家集科研、開發和生產為一體的浙江省中小型科技企業、紹興市高新技術企業，主要生產圓錐滾子軸承、圓柱滾子軸承、汽車離合器分離軸承、汽車方向機軸承、汽車輪轂軸承及輪轂單元、中心支架軸承，同時可生產汽車水泵軸承、推力滾子軸承、非磨軸承、沖壓軸承等，產品主要銷往美國、歐洲、非洲、東南亞和中東等國家和地區。
  6. Water in the reactor is kept at a lower pressure of about 75 bars such that it will boil at about 285 degree c. the steam produced from the reactor will directly feed into the turbine after passing through steam separators above the reactor core

    反應堆的水會維持約75巴的低壓，令水可以在大約攝氏285度時沸騰。反應堆所產生的蒸汽會經過堆芯上方的蒸汽分離器，然後直接送到渦輪機。
  7. This paper introduces several separation technologies for alcohol - water system, which include not only traditional azeotropic distillation and extraction distillation, but also new membrane separation techniques, such as membrane distillation, pervaporation and membrane contactor

    摘要主要介紹了醇水體系分離的幾種工藝和新方法，其中包括傳統的恆沸精餾和萃取精餾等主流工藝，以及膜蒸餾、滲透汽化和膜接觸器等新型膜分離技術。
  8. Analysis of the benefit of high - pressure steam - water separator

    高壓汽水分離器效能分析
  9. The results show that the three parameters, i. e. the maximum allowable flow rate of the drain tank, the drain tank pres - sure, and the pressure of the water separator, are supporting and restraining each other, and the variations of the pressure and flow rate are reasonable

    模擬結果表明：疏水箱的最大允許流量、疏水箱壓力以及汽水分離器的壓力三參數是相輔相成，相互制約的；壓力和流量等參數變化趨勢合理，模擬結果對外高橋電廠機組啟停有一定的指導意義。
  10. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  11. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
分享友人
分享到 Line

分享到臉書