沸騰特性 的英文怎麼說

中文拼音 [fèiténgtèxìng]
沸騰特性 英文
rimming property
  • 沸 : Ⅰ動詞（滾開） boil; bubbleⅡ形容詞（滾開的;沸騰） boiling; bubbling
  • 騰 : 騰象聲詞（形容猛然動作發出的聲音）
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 沸騰 : 1 [物理學] （液體氣化） boiling; ebullition; ebullience; elixation 2 （情緒高昂） seethe with exc...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  2. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內流動沸騰換熱特性的實驗研究表明： a ）隨著質量流率的增加，含油混合物微肋管內的沸騰平均換熱系數增加。
  3. This paper is consisted of two major parts : one deals with the general working performance of the fmghp by setting up mathematic model and developing computer procedure, getting the datum related to the capillary flow and heat transfer, analysing the working characteristics of fmghp in different working temperature, heat flux and inclination angle etc. in this part, the prediction of capillary and boiling limit are also included. the other major part studies the flow and heat transfer characteristics in the micro - film region formed by the meniscus attached on the metalic fin in the micro rectangular groove. investigations on the influence of width of groove and other factors on heat transfer in this region have been made. the importance of this micro - region in the heat transfer of the entire heat pipe has been unveiled. the heat transfer characteristics gotten by this research could be used in design and application and also optimization of this kind of fmghp

    本文在大量查閱現有國內外文獻的基礎上，總結並綜合前人有關微槽平板熱管理論研究方面的成果，對單面刻有槽道的微槽平板熱管進行了較為深入和細致的研究。本文的研究共分兩大部分，其中第一部分考察了該型熱管的整體工作表現，通過建立數學模型和開發相應的計算程序，得到了熱管內部毛細流動和傳熱的數據，分析了熱管在不同工作傾角、不同加熱熱流以及不同工作溫度等情況下工作特性的變化規律，考察了汽液界面上的剪切作用對熱管傳熱量的影響，並且進一步在理論上預測了該型熱管的毛細和沸騰極限。
  4. Analysis of heat transfer characteristics in the level tube with ipsa algorithm

    法對水平管內流動沸騰傳熱特性的分析
  5. In this work, the macroscopical characteristics of diesel and diesel / lpg sprays are studied through using a digital camera with a high spatial resolution. based on processing technique for digital image, the droplets photographed, which are at the spray edge, are studied. after a comparison of the characteristics of sprays for different fuels, such as diesel, blend fuels of diesel and lpg with different weight fractions, it is shown that flash - boiling injection ( fuel containing dissolved gas ) is good for the atomization of fuel

    本文對柴油和柴油lpg混合燃油的噴霧的宏觀特性採用高解析度數碼相機進行測量，並運用數字圖像技術處理了數碼相機捕捉到的處于霧束外沿的粒子，通過比較純柴油和不同lpg比例混合油的霧化性能，表明溶氣噴射（閃急沸騰）有利於噴射油滴的霧化。
  6. At the same time, experimental study on boiling heat transfer by changing mass flow of refrigerant, mass flow of water, and inlet temperature of water was also finished. and then the performance of miniature evaporator was estimated

    本文完成了液單相、兩相熱平衡實驗和阻力特性實驗，研究了製冷劑在管內流動的壓降;同時進行了微型蒸發器流動沸騰實驗，通過改變製冷劑質量流量、水的質量流量、水的進口溫度等，實現了對微型蒸發器的性能評價。
  7. Characteristic study of highly subcooled boiling in the 5 mw nuclear heating reactor

    核供熱堆高欠熱沸騰的特性研究
  8. Effects of geometry parameters of microfin tubes on flow boiling of refrigerant mixtures

    微翅管幾何參數對混合工質流動沸騰特性的影響
  9. A new experimental rig of testing flow boiling heat transfer of refrigerant - lubricant mutually soluble mixture

    潤滑油互溶混合物系流動沸騰特性測試裝置的研製
  10. Investigation on characteristics of pressure drop for binary mixture in horizontal micro - fin tube

    水平微翅管內二元混合製冷劑流動沸騰阻力特性研究
  11. Especially, in the filed of high tc superconductor, the technology that the cryocooler directly cool the superconducting system has changed the traditional cooling manner, which adopts the method of low tc fluid helium ' s convection and boiling to exchange the heat. it mainly depends on the cooling manner of conducting heat through the interfacial layer between the material of superconductor and non - superconductor ( such as cu, isolator, etc )

    特別是在高溫超導領域中，由於製冷機直接冷卻技術改變了傳統的靠低溫液氦對流、沸騰換熱的冷卻方式，主要依靠超導材料與非超導材料（如銅、電絕緣材料等）固體間的接觸導熱冷卻方式，固體間界面熱阻成為影響導熱性能的關鍵因素之一。
  12. Then, against both industrial fluidized bed boiler of chongqing jialing industrial limited company, industrial fluidized bed boiler is a kind of industrial boiler, based on analysis and comparison, this paper puts forward an " one control two " automatic monitoring and controlling system with one computer, i. e. one computer monitors and controls two boilers at the same time

    比較，設計了一種具有特色的"一控二"微機自動監控系統，即一臺微機同時監控兩臺工業沸騰爐的自動監控系統?這種系統與"一控一"系統相比，在降低硬體成本?提高系統的穩定性
分享友人
分享到 Line

分享到臉書