油泵葉輪 的英文怎麼說

中文拼音 [yóubèngyèlún]
油泵葉輪 英文
fuel pump impeller
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 輪 : Ⅰ名1 （輪子） wheel 2 （像輪子的東西） wheel like object; ring; disc 3 （輪船） steamer; steamboa...
  1. The results also display the impeller ' s good hydraulic properties and the vaned diffuser ' s imperfect hydraulic properties and low efficiency

    計算結果還顯示：潛油泵葉輪有較好的水力性能，而潛油泵導輪的水力性能是不完善的，效率較低。
  2. Test method for indicating wear characteristics of petroleum hydraulic fluids in a high pressure constant volume vane pump

    高壓定容葉輪泵中石油液壓液耐磨特性指示的試驗方法
  3. [ 5 ] the influence of the number of blades on the affinity law of impeller trim for the centrifugal oil pump is obtained

    （ 5 ）得到了葉片數對離心油泵葉輪切割定律的影響規律性。
  4. Nowadays, the affinity law of impeller trim for the centrifugal water pumps is applied to impeller trim for the centrifugal oil pumps

    目前，都採用離心清水泵的切割定律來切割離心油泵葉輪。
  5. [ 3 ] the greatest error is 50 % between the result given by the affinity law of u. s. a and that calculated by using the trim law issued in this work

    （ 3 ）發現在輸送水時美國的葉輪切割定律計算結果與本文相差最大為50 。按美國的切割指數用於離心油泵葉輪切割，誤差比較大。
  6. Based on the findings of the investigation, the following conclusions should be made : [ 1 ] the affinity law of impeller trim for the centrifugal oil pump 65y60 is obtained when handling water from the experiments

    通過研究，取得到了以下研究成果： （ 1 ）得到了輸送水時65y60型離心油泵葉輪切割定律。
  7. [ 2 ] the affinity law of impeller trim for the centrifugal oil pump 65y60 is gained when pumping viscous oil

    （ 2 ）得到了輸送粘油時65y60型離心油泵的葉輪切割規律。
  8. Up to now, there is no research on the affinity law of impeller trim for the centrifugal oil pumps

    到目前為止，國內外還沒有對離心油泵的葉輪切割定律進行過研究。
  9. The centrifugal oil pump of type 65y60, finalized by the former ministry of machinery - building of china is used as a model, which is widely utilized in oilfields and refineries. the affinity law of impeller trim for the pumps at various viscosity and the influence of number of blades on the law have been thoroughly investigated by experiments

    本文以油田和煉油廠常用的，機械工業定型產品65y60型離心油泵為研究對象，採用試驗的方法，全面研究了不同粘度下離心油泵的葉輪切割定律和葉片數對葉輪切割定律的影響規律。
  10. Standard test method for indicating wear characteristics of petroleum and non - petroleum hydraulic fluids in a constant volume vane pump

    定容葉輪泵中石油和非石油液壓液的磨損特性指示的標準試驗方法
分享友人
分享到 Line

分享到臉書