泊松系數 的英文怎麼說
中文拼音 [bósōngxìshǔ]
泊松系數
英文
poisons coefficient-
( 6 ) in this paper. adopting fea software ansys to simulation and analysis the al ecap process. in order to spread out studying of ecap in the future. the results show : die comer angle, the radius of round angle, the friction coffience of workpiece and die, the properties of die ( elastic modulus, possion ratio ) et al, have some degree impact on the deformation of materials
（ 6 ）採用有限元（ fea ）分析軟體ansys對al的擠壓過程進行ecap模擬與分析，為后續研究工作做好鋪墊，分析結果表明：外切角、圓角半徑、試樣與凹模之間的摩擦系數、凹模本身的特性（如彈性模量、泊松比等）等等，對材料的變形量都由不同程度的影響。Rotation - cavitation mechanism was outlined based on the experiment results and the essential conditions for the occurrence of auxetic properties in polyolefin blends were concluded as followed : firstly there must be at least two phases, the matrix can be soft materials which were able to be networks when being stretched, as well as suitable consistence must be provided between two phases. fracture stress work measurement was optioned to characterize the force between two phases. finally, the auxtic property repeatability of the blends was measured and the fact that the auxetic property could only occur in the elastic range was certificated by the result that only the specimens which were stretched for 5s, 10s had repeatability after being retained for 1 months
實驗工作的最後一部分研究了體系負泊松比效應的可重復性，選取穩定的負泊松比共混體系在測試數據採集時間為55 、 105 、 155 、 205條件下進行測試，將樣條放置l天、 10天、 30天進行測試，測試結果表明，在5s 、 105條件下測試的試樣在放置一個月後泊松比測試結果具有可重復性，證實了體系的負泊松比現象發生在材料的彈性形變范圍內。Based on the analysis of thin sections by microscope, measurement of porosity and density, and geological setting, we tested the rock physical parameters of sandstone, siltstone, carbonate and other transitional sedimentary rocks by the mts system under formation conditions ( temperatures, pressures and pore fluid properties ). the rocks we tested are from tertiary ( including zhujiang formation, zhuhai formation, enping formation, hanjiang formation ) of zhujiangkou basin in southern china sea. according to the analysis results, we studied the main ultrasonic wave velocity characters of rocks, which are compressive and shear wave velocity and poisson ' s ratio under different formation conditions
在對珠江口盆地第三系儲集巖進行顯微鏡薄片分析、孔隙度和密度分析，以及地質背景分析的基礎上，利用巖石物理參數測試系統（ mts ）模擬地層條件（溫度、壓力和孔隙流體狀況）測試了珠江口盆地第三系（包括珠江組、珠海組、恩平組、韓江組，以下有關討論同）砂巖、粉砂巖、碳酸鹽巖及其過渡性巖石物理性質，重點研究了不同地層條件下巖石的聲學特徵（巖石的縱橫波速度和泊松比） 。With the increase of lateral pressure modulus, the magnitude of principal stress decreases and the direction of it is hardly changeable ; with the increase of the angle between the direction of the maximal horizontal principal stress on magnitude and the fault bearing, the magnitude of principal stress increase and its direction can hardly change ; with the increase of the elastic modulus of rocks, the magnitude of principal stress increases and the direction changes more ; with the increase of pr, the magnitude of principal stress decreases and the direction changes more ; with the increase of lateral pressure modulus, the principal stress at hance, the tress at topmost arch, bottom arch and principal stress at lateral arch decreases, with the increase of the depth of tunnel, the stress of surrounding rock also increases, and the poorer the quality of surrounding rock is, the little its principle stress is
分析得出，隨著側壓力系數的增大，主應力量值減小，主應力方位難改變；隨著與斷層走向的夾角增大，主應力量值增大，應力方向難改變：隨著巖石的彈性模量的增大，主應力量值增大，方向變化越大；隨著泊松比的增大，主應力量值減小，方位變化越大。隨著側壓力系數的增大，頂、底拱處的各應力值增大，拱腰處的主應力減小，剪應力增大，側拱處的各主應力減小，同一側壓力系數的條件下圍巖質量越差，各應力值也越小；隨著洞室埋深的增加，圍巖壓力也增大，圍巖質量越差，其應力值也減小。To meet the need of settlement calculation with fem when absence of laboratory triaxial test data in common road engineering, methods of determining the five parameters included in tangential elastic module through soil routine tests and the related emendation coefficient are given. at the same time, one approximately substituted formula for tangential poisson ratio is also developed, which is suitable for both sandy soil and cohesive soil. ( 3 ) research on main parameters modification of duncan - chang model based on the improved bp network
對於一般道路工程中不做三軸試驗但須進行沉降有限元計算的情況，給出了依據土體常規試驗的切線彈性模量確定方法和相關修正系數，同時也提出了對砂性土和粘性土均適用的切線泊松比的近似替代式子； （ 3 ）基於改進的bp網路對鄧肯張模型主要參數修正研究。Poisson ' s coefficient
泊松系數( 5 ) for slope safety problem, the paper analyzed the sensitivity of parameter. the result shows that e, v, k0 have little affecting on slope safety, friction angle and cohness c are main factors. providing a theoretics gist for reinforcing bank
結果表明，彈性模量e 、泊松比、剪脹角和側壓力系數_ 0對邊坡的安全系數影響不大，影響邊坡安全系數的土體參數主要為內摩擦角和內粘聚力c ，為邊坡穩定的治理提供了理論依據。The third section discusses that when every stage incurs fixed ordering cost and each uses echelon stock ( r, q ) policy, we assume that demand is a poison process, and we use a lower bound as near - optimal solution for a two - stage inventory system
第三節討論在每個庫存點訂購費都是正數時，各點採用級庫存（ r ， q ）策略，假設1個需求是泊松過程的兩點系統，對該系統運用下界函數法可以近似地求出優化解。5 ) the velocity of the compressive and shear wave for the samples saturated completely by brine increases with the increasing of confining pressure ( with the constant pore pressure ), but poisson ' s ratio decreases. 6 ) some interior factors, such as the composition of rock, porosity, density and so on
5 ）在完全飽和水、溫度和孔隙壓力不變的條件下，無論是縱波、橫波1還是橫波2 ，珠江口盆地第三系砂巖、粉砂巖、碳酸鹽巖及其過渡性巖石類型的速度均隨圍壓的增大而增加；大多數情況下，泊松比隨圍壓的增加而降低。Influences of soil elastic modulus and poisson ' s ratio on slope stability
彈性模量和泊松比對邊坡穩定安全系數的影響A kind of grid generation method based on two - dimension poisson equtions is devlop - ed into the grid generation method based on three - dimension poisson equtions in this dessertation. use this method, this paper generals the grids of glide bullet to increase range that is at three states, that is with no control rudder and no tail wing, only with tail wing and with control rudder and tail wing. this paper has calculated the aerodynamic coefficients of glide bullet to increase range that is at three states. beside this the paper has given the results and analysised the differences of the three states, and the effects of control rudder and tail wing to the lift and drag. this can give us some information about the ability of the control ruder and tail wing for increasing the range
本文在二維泊松方程網格生成方法的基礎上推導出了一種三維泊松方程網格生成方法。並利用該方法生成了繞彈體、尾翼彈、滑翔增程彈三種不同彈形的流場網格。計算了超音速來流下彈體、尾翼彈，滑翔增程彈三種不同彈形的空氣動力學系數，分析了三種不同彈形計算結果的差別；分析了控制舵和尾翼對升力和阻力的影響。The principle of the ultrasonic method applied to measure elastic coefficient is by measuring the velocity of ultrasonic wave propagation in the solid material to obtain the elastic module, shear modulus and poisson ratio
摘要彈性系數的超聲檢測，即藉助固體彈性常數與超聲波波速間的固有關系，通過測量縱波及橫波在固體中的傳播速度來獲取材料的彈性模量、剪切模量及泊松比。分享友人