法式線縫 的英文怎麼說

中文拼音 [fǎshìxiànféng]
法式線縫 英文
seam on a garment etc with the raw edges turned and sewn under
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 縫 : 縫名詞1. （接合處） seam 2. （縫隙） crack; crevice; fissure; slit
  • 法式 : 1. （標準的格式） rule; method; model: 《營造法式》 rules of architecture2. （法國式的） french
  1. Methods the improvements of the operation included ; a supertemporal conjunctival flap 180 with its base at the fornix, the puncture points were located at 8 and 2 o ' clock ( right eye ) or 10 and 4 o ' clock ( left eye ), the straight needle and shovel needle with prolene suture were conducted into the eye via two different side of corneal incision and out of the eye under the scleral flap at 8 and 2 o ' clock ( right eye )

    方法術式改進包括：顳上方180 、以穹隆為基底的大結膜瓣；穿刺點選擇8點及2點位（右眼）或10及4點位（左眼） ；用聚丙烯縫線所帶直針及鏟針，從角膜切口兩端進入眼內，由8點及2點位鞏膜瓣下穿刺出針。
  2. The study gets the following conclusions : 1 ) inverted nine - spot pattern water flooding is used in the early stage of the development, while linear water flooding is used in the later stage ; 2 ) well array is parallel to the fracture trend ; 3 ) the well arrangement of barycentric position method is a suitable pattern adjustment method in the later period of the development in low permeable oil fields

    研究認為，一是油田開發初期注采方式採用反九點法面積注水，開發後期調整為線狀注水方式；二是井排方向與裂縫走向平行；三是「重心位置」布井方式對低滲透油田開發後期是較為適合的井網調整方式。
  3. A new waveguide made of changing a wide wall of a rectangular waveguide to a uniform curved wall is called conformal waveguide. a kind of expression of approximate solution for domain mode of the new waveguide, including symmetric, unsymmetric arc, parabolic arch, hyperbolic arch, elliptic arch, etc., is constructed by using boundary condition of mental waveguide, variational method and boundary element method. by using the equivalence principle, an approximate calculating formula for equivalent resonant conductance of a narrow longitudinal halfwavelength slot cut in the curved wall of the unsymmetric arcrectangular waveguide is derived, and the result is shown. although this solution is approximate, it can solve the problem in designing the slotted antenna of such conformal waveguide

    把矩形波導一個寬面外突成均勻曲面構成的新波導統稱為共形波導.利用金屬波導邊界條件、變分法、邊界元素法構造這種新波導中主模場的一種近似解表達式，包括曲面橫截線為對稱、非對稱圓弧，拋物線弧，雙曲線弧，橢圓弧等.然後根據等效原理，推導非對稱圓弧矩形波導曲面上窄的縱向半波長縫隙的等效諧振電導的近似計算公式，給出計算曲線.這種解雖然是近似的，但卻能解決這類共形波導縫隙天線的工程設計
  4. In the construction of the tanghe inverted siphon on mid - roule of south - to - north water transfer project, some reliable construction processes and techniques are applied such as belt conveyor with three - rail gantry, construction with combined steel formwork, straight screw sleeve connection for reinforcement and the crushed stone - planting method etc., by which better construction effects are obtained

    摘要南水北調中線唐河倒虹吸工程項目施工中，根據工程特點，採用了三軌門架式皮帶布料機、鋼模板聯體施工、鋼筋滾壓直螺紋套筒連接、混凝土施工縫栽石法等可靠的施工技術和施工工藝，取得了較好的效果。
  5. A method of joining hemmed edges by crisscrossing thread over an open seam

    花式針跡接縫將線在接縫處十字交叉縫邊的一種方法
  6. The reduction factors derived from curve fitting based on calculation results by the finite element program ( ansys ) considering all kinds of damages such as cutouts, corrosion, cracks, denting, initial deflection and residual stress are introduced to modify the effective width of perfect panel in the present paper

    本文考慮板中可能存在孔洞、腐蝕、裂縫、局部撞損和初始焊接變形或殘余應力等損傷和初始缺陷，對不同的損傷形式用有限元程序（ ansys ）進行大量的計算，通過曲線擬合的方法引入折減系數對完好板格的有效寬度進行修正。
  7. This technique combines the edge - based finite - element method with physical optics ( po ) and physical theory of diffraction ( ptd ). the hybrid technique is applied to compute the scattering fields from the electrically large bodies with cracks and cavities on their surfaces. it is also used to analyze the scattering characteristics of microstrip antennas residing in a cavity mounted on metal objects with finite sizes

    本文採用edge - basedfem為基本方法，結合物理光學法（ po ） 、物理繞射理論（ ptd ） 、邊界積分方程（ bi ） 、區域分解技術（ ddm ）和完全匹配層（ pml ）吸收邊界條件等求解方法構成的混合方法，對電磁散射和輻射問題進行了研究，主要包括以下內容：提出了一種edge - basedfem與物理光學方法和物理繞射理論相結合的混合方法? fem po - ptd方法，並將該混合方法應用於帶有腔體或槽縫的電大尺寸導體目標的電磁散射特性分析和位於有限導體目標上的背腔式微帶貼片天線的電磁散射特性分析。
  8. At the same time in this paper we analyze nonlinear behavior of masonry through finite element method program and obtain its load when the wall start to crack and when it destroy, the p - u curve and so on. a comparison has been made between the data obtained from the experiment and the calculated through finite element method program so that we can study the cause of crack. in this paper we use finite element method to study concrete ' s character to analyze masonry, satisfactory results have been attained

    因此本文在對灰砂磚砌體進行力學性能試驗的基礎上，分析其裂縫產生的破壞模式與開裂機理，並論述了將斷裂力學知識運用於研究砌體裂縫問題的可行性；同時，本文運用有限元方法對結構低周反復加載靜力試驗所做的灰砂磚墻片進行非線性分析計算，得出墻片的開裂荷載、極限荷載、 p ? u曲線，裂縫在墻體上的分佈等，與試驗所得數據對比，以便於研究裂縫的開裂機理，並將研究混凝土的有限元方法運用到對砌體的研究中，取得了較滿意的結果，為類似的試驗分析提供了一條新的思路。
  9. The conformal microstrip antenna with some unique character has been applied in many fields, especialy on speedy objects. in this paper, an efficient fdtd algorithm is introduced to analyse the microstrip antenna. firstly, the fdtd formula in descartes coordinate system and in cylindrical coordinate system are obtained from the time _ dependent maxwell equations using the yee algorithm in a calculating region where the dielectric parameters are independent of time and space. the choice of the space discretization units and the time discretization interval are discussed which are decided by the accuracy and stability respectively. the shape and setup of the excitation source are discussed too. the excitation source is chosen to be gaussian pulse in shape. secondly, the mur ' s first - order and second - order boundary condition are deduced in cylindrical coordinate system. the methods of transforming radiation fields from near zone to far zone in the frequency domain and in the time domain are presented when fdtd is applied to analyse the characteristics of far zone. finally, three kinds of microstrip antennas are analysed. they are a slot antenna that lies on a plane ground of a microstrip, a slot antenna that lies on a cylindrical ground of a microstrip and a microstrip line _ fed aperture coupled stacked rectangular patch antenna in cylindrical coordinate system

    本文從麥克斯韋旋度方程出發，建立了笛卡兒坐標下無源空間中均勻無耗媒質的fdtd基本方程和圓柱坐標下無源空間中均勻無耗媒質的fdtd基本方程，詳細討論了fdtd法計算中時間步長和空間步長的選取原則以及激勵源的類型和設置；推導了mur一階和二階邊界條件在圓柱坐標下的差分格式；給出了在用fdtd法計算天線的遠場輻射特性時必需採用的頻域和時域近場遠場變換技術；最後用fdtd法計算了平面微帶縫隙天線、柱面共形微帶縫隙天線和柱面共形微帶層疊天線的輸入阻抗和遠區輻射場，並分析了天線的一些參數的變化對天線輸入阻抗的影響，得出了一些有用的結論。
  10. This paper discusses the applicable ranges of current welding long rail techniques under various construction circumstances of urban rail transit project, and holds that the engineering scheme of the welded - rail site, the viaduct welded site and the utilization of mobile touch - weld vehicle shall be adopted

    針對城市軌道交通工程中不同的施工環境，對比分析了現有的各種長鋼軌焊接方法和適用范圍，探討了現場焊軌基地、高架橋上的焊軌基地及利用移動式焊軌車焊接無縫線路長鋼軌的施工方案。
  11. The details are as following : 1 ) through the experiments of seventeen reinforced concrete plates with round openings, stress distributions of concrete and steel bars, concrete cracking, failure mechanism, and the influence of reinforcing bars with different amount and layouts on cracking and failure mechanism of the specimens are studied. the experimental study provides data not only for the validation of fea model and nonlinear fem program, but also for the research on new methodology of design for orifices

    本文的主要工作有： 1 ）通過17塊帶圓孔鋼筋混凝土板的試驗，研究在荷載作用下孔口周圍混凝土和鋼筋的應力應變分佈和孔口開裂、破壞規律，以及不同的配筋方式和數量對孔口混凝土裂縫的產生、發展及孔口破壞的影響，為驗證有限元分析模型及非線性分析程序的可靠性提供試驗依據，並為建立新的孔口配筋設計方法提供基本試驗資料。
  12. For video images with moving objects, an optimal stitching line was found by heuristic optimal path search algorithm in mosaics of images, and the images were smoothed by multi resolution theory after mosaics of images

    對存在運動物體的視頻圖像，採用啟發式最優路徑搜索演算法尋找到圖像間拼接的最佳縫合線，並使用多解析度原理進行圖像拼接后的平滑處理。
分享友人
分享到 Line

分享到臉書