波峰輸出 的英文怎麼說

中文拼音 [bōfēngshūchū]
波峰輸出 英文
peak output
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Some researches about frequency doubling are made, and two methods to improve intensity of second frequency generation are given. we realized q - switched 532 nm laser, by using nd : gdvo4 as laser crystal, using cr4 + : yag as saturable absorber, using ktp as intra - cavity frequency doubling crystal. average power of 109mw, repetition of 40khz, pulse width of 30ns, pulse energy of 2. 6uj, peak power of 91w are obtained

    4 .對倍頻理論進行研究和分析:討論兩種提高二次諧波功率密度的方一法;實驗匕在國內首次實現ld端面泵浦nd : gdvo4 / ktp ，用cr4 + : yag作為可飽和吸收片的綠光激光器，腔內倍頻得到了平均功率為109mw 、重復頻率為40khz 、脈寬為3ons 、單脈沖能量為2 . 6閃、峰值功率為glw的調q綠光輸出。
  2. Because of the clamping capacitor and the interleaved structure, it has some good features compared with other flyback converters, such as : the topology is simple and can be realized easily ; the voltage spike of the power switch is availably restrained and without leakage - inductance energy loss ; the ripple of the input and output current is reduced, correspondingly, the volume and weight of the output and input filter is also significantly reduced

    由於箝位電容的加入，相對于其他類型的反激式變換器電路，該拓撲具有一些獨特的優點:電路結構簡單且易於實現;無需另加輔助開關管，實現了開關管的有源箝位，抑制了開關管的電壓尖峰;提高了輸入、輸出電流的脈動頻率，減小了輸入及輸出濾波器體積。
  3. The motor has a normal maximum power of 180kw and a peak output of 230kw. external feeds are arranged to the inverter from ( i ) the accelerator pedal, ( ii ) the forwardreverse selector, and ( iii ) the brake pedal, in order to determine power demand, direction of travel ( forwards or backwards ) and brake regeneration

    馬達一般最大功率為一百八十仟瓦及峰值輸出二百三十仟瓦。外來訊號經由i ）油門踏板ii ）前後波掣及iii ）剎車踏板，傳輸至轉換器以決定所需功率、行車方向（前或后）及剎車效能之再生等等。
  4. Meanwhile it can filter the waveform and gather the envelope and calculation the current peak and max steepness of lightning by length of erased magnetic record. thirdly we need analyze the difference of length of erased magnetic record between kinds magnetic tape or pre - recorded sine wave on magnetic tape, and finding the min and max lightning current that can be recorded by magnetic tape. then we confirm the type of the magnetic tapes and the way of installing which fit to the line towers

    同時對該波形進行濾波消噪，提取包絡線計算磁帶消磁長度和雷電流峰值及最大陡度第三部分根據mtlcd得出的數據分析不同雷電流通道下不同磁帶、不同預錄正弦波消磁長度的差異及磁帶可以記錄的最小雷電流和最大雷電流，找到可以在輸電鐵塔角鋼上安裝使用的磁帶及其放置方式。
  5. At the beginning of this thesis, the principle of fiber fabry - perot strain sensor is presented briefly, and the influence on the results of the peak - to - peak algorithm, brought by the spectrum distribution of light source, wavelength quantification or the noise in the output of the fabry - perot sensor is investigated. the limitation of the peak - to - peak algorithm is pointed out

    論文首先闡述了光纖法珀應變傳感器的測量原理，分析了實際光源光譜的非均勻分佈、波長量化和傳感器輸出信號中的噪聲等對波長域的條紋峰值解調演算法的應變測量結果的影響，深入分析了條紋峰值解調演算法的局限性。
  6. The third, some groping researches are made on broadband coaxial line filter output circuit of klystron. a broadband output circuit - mode four coupling slots double - gap output cavity loaded with coaxial filter, which has a workable relative bandwidth bigger than 14 % and fits in with l - band multi - beam klystron, is designed. meanwhile some analysis of its stability and peak power capacity is made

    第三，對速調管同軸線濾波器寬帶輸出迴路進行研究和探索，設計出了一個適合用於l波段多注速調管、相對帶寬超過14的四耦合槽模強耦合雙間隙腔加載同軸線濾波器輸出迴路，並對其穩定性和峰值功率容限做了一些分析。
  7. Based on this arithmetic, the high frequency characteristics of five - cavity with open boundary is calculated by the code written in fortran language. then the transit effect of five modes of five - cavity with open boundary is also calculated using code mathcad and matlab. the results show that the working mode of five - cavity transit tube oscillator is 3 / 6 mode, and the analysis of the theory are in good agreement with the simulation results

    根據從基於四腔渡越時間效應的自調制出發，經過一段飄移，然後再採用雙間隙提取腔邊耦合輸出高功率微波的思路，採用粒子模擬方法優化設計出一種峰值功率為1 . 5gw ，頻率為9 . 3ghz的六腔渡越輻射振蕩器，並研究了它的一系列工作特性。
  8. The simulation results show the existence of both limits and optima for the studied parameters, related to the stable operation and the maximum efficiency, respectively. underlying the conditions that the longitudinal guiding magnetic field is 1. 8t, diode voltage is 250 kv, the impedance is 150, we got a peak power as high as 100 mw for the tm01 mode at 38ghz

    經優化設計，本文給出了一個相對論亞納秒毫米波返波振蕩器的物理模型，在引導磁場為1 . 8t 、二極體電壓為250kv 、阻抗為150的情況下得到了超輻射狀態下輸出微波峰值功率為100mw 、中心頻率為38ghz 、模式為tm _ （ 01 ）模的微波輻射。
  9. The simulation results of the 2. 5 - d pic code for this new structure are presented. a 2. 5 gw peak output power with the frequency of l. 3ghz is generated with the input of 625kv voltage, dc input power of 18gw

    然後對這種器件進行了數值模擬研究，得到的典型結果為:輸入電壓625kv ，輸入直流功率18gw ，輸出微波峰值功率為2 . sgw ，虛陰極振蕩頻率被鎖定，微波飽和時間小於sns ，頻率為1 . 3ghz 。
  10. Simulation results show 2. 5 gw output power with a frequency of 1. 25ghz can be generated with an input of 620kv voltage, dc input power of 10. 5gw electron beam. ( 3 ) the radial reflex klystron with an open foldaway - concentric cylindrical resonant cavity integrates the resonant cavity and reflex cavity within one foldaway coaxial cavity, so it is a very compact high power microwave device

    然後對這種器件進行了數值模擬研究，得到的典型結果為:輸入電壓620kv ，輸入直流功率io . sgw ，輸出微波峰值功率為2 . sgw ，虛陰極振蕩頻率被鎖定，頻率為1 . 25ghz ，微波飽和時間小於sns 。
  11. Based on fourth - order cumulant, a computationally efficient method for joint estimating both directions of arrival and ranges of near field sources with known carrier frequency is firstly presented. the proposed algorithm need not any spectral peak searching and the 2 - d parameters are automatically paired. lt is suitable for arbitrary additive gaussian noise environment. in the following section, a 3 - d esprit method for jointly estimating of frequencies, doa ' s and ranges of multiple near - field sources with unknown carrier frequencies is proposed. the parameters estimation are given by the eigenvalues of different matrices. furthermore, its performances are confirmed by several computer simulations

    利用四階累積量，第五章首先給出了一種載頻已知的情況下基於近場源的距離和波達方向聯合估計演算法，通過構造的陣列輸出信號四階累量矩陣使空間信號到達方向和距離估計無需譜峰搜索，且參數自動配對，適合於任意高斯噪聲環境。進一步在第三節提出了一種載頻未知的情況下的多個近場窄帶信號源doa 、距離和頻率聯合估計的3 - desprit演算法。
  12. The water ' s absorption in tissues is particularly great, so the erbium laser is suitable. simultaneously we design the laser alignment system, the laser shaping system and the focal setting system. doing the theoretical analysis and experiments, we research and develop a medical blood - sampling instalment of laser, with the good application prospect

    因為摻鉺yag固體激光器輸出的中心波長為2 . 94 m ，與水的吸收峰相吻合，而且皮膚組織中水的吸收非常顯著，所以鉺激光是合適的，同時設計了激光對準系統、激光整形系統和聚焦系統，通過理論和實驗研究，研製出一臺激光採血儀樣機，具有良好的應用前景。
  13. Through analyzing decision variable of receiver, the f - pe method can increase autocorrelation of desire user ' s spreading sequence, and improve the ber performance

    對接收機判決變量輸出分析表明，該演算法能有效增加關心用戶的解擴濾波相關峰值，對誤碼率性能有很好的改善。
  14. In this paper, after adopting the plane wave approximation, taking into account the fact that the output from a fabry - perot is formed on the basis of the interference of the multi - reflected beams of the input pulse that enters the filter, an analytical expression of the output pulse intensity has been derived

    本文推導出了高斯型光脈沖經過濾波器后輸出脈沖的時域表達式。在此基礎上，對出射脈沖的峰值功率、脈沖寬度以及濾波器對入射脈沖的時延等進行了深入的研究。
分享友人
分享到 Line

分享到臉書