注入光纖 的英文怎麼說

中文拼音 [zhùrùguāngxiān]
注入光纖 英文
injection fiber
  • 注 : Ⅰ動詞1 （灌入） pour; irrigate 2 （集中） concentrate on; fix on; focus on 3 （用文字來解釋字句）...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 纖 : 纖形容詞（細小） fine; minute
  • 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
  1. Just below threshold, consistel1t to theoretical analysis, there are numbers of comb - like narrow linewidth lights due to resonating of ifltr8 - cavity ase light. novel experimental results of the erbium - doped - fiber ring resonator behaviors operating near threshold are reported in the chapter

    首先理論分析了當有源環形腔無注入光，且有源光纖環形腔在閾值以下時，由有源腔內ase輸出光表現出的腔輸出特性。
  2. We also propose a new subsidiary method for finesse measurement based on selfhomodyne by x m. using of resonating of the intra - cavity amplified spontaneous emission ( ase ) light, without extemal light source

    同時提出利用腔內ase輸出光的線寬來測量有源光纖環形腔濾波器的精細度，而不需要注入光。
  3. ( 2 ) ln the third chapter of this dissertation, the behaviors of intra - cavity amplified spontaneous emission ( ase ) light in the active fiber resonators are firstly studied by both theoretical and experiment8l ways, when it is operating near the threshold

    二、在本文第三章中，研究無注入光時，通過分析腔內ase光輸出特性來研究有源光纖環形腔在近閾值點附近的濾波特性。
  4. 3 using current injecting frequency modulation method and modulating sine wave around the resonator point, the lock - in phenomena is observed in a comparatively short period of time. this has achieved the basic goal for a closed loop r - fog

    3 、採用電流注入法，在諧振點附近進行正弦調制，實現了對諧振點的短時間鎖定，達到了閉環光纖陀螺設計的首要基本要求。
  5. In this paper, a new theoretical model is established for optical fiber pumped by broadband laser. using the new model, we have analyzed the influence of longitudinal - mode number, bandwidth and line - width of pumping source on sbs reflectivity, and pointed out the monochromaticity of pumping laser has obvious affect on optical fiber conjugator

    成功解釋了激光線寬、縱模間隔與數目對光纖中sbs過程的影響，並通過數值計算分析了sbs閾值、反射率、相對穩定性、保真度等性能參數隨著注入激光能量、脈寬以及光纖長度、芯徑的變化趨勢。
  6. In the paper some newly developed technologies on all - fiber coherent beam combining are introduced. theoretial explanation of injection locking is given based on the simulation

    摘要全面介紹了光纖激光器相干組束技術的發展現狀，對注入鎖定現象給出了相應的理論解釋。
  7. In this work, based on the threshold condition of the fiber grating external cavity semiconductor laser ( fgesl ) which the phase of the fiber grating has been included, the effect of the temperature variation and the fg external cavity length on the lasing wavelength of the fgesl has been investigated theoretically. in addition, we have used the phase condition of fgesl to get the longitudinal mode distribution of fgesl, then the influence of the injected current on the output characteristics of fgesl has been studied

    基於此，本文中利用陽實際的反射相位分佈，計及半導體激光器（ ld ） 、外腔及光纖光柵（ fg ）三者的共同作用，根據fgesl滿足的閩值條件，從理論上研究了溫度及外腔長度的變化對fgesl激射波長的影響;根據fgesl中縱模所滿足的相位條件得到其縱模分佈后，利用fgesl滿足的多模速率方程，研究了ld的注入電流對fgesl輸出特性的影響。
  8. Then we analyze the static character of sbs to obtain the sbs gain factor and threshold under continuous wave and pulse. because there is no stokes seed in fiber hydrophone system, we analyze the sbs based on the noise initiation of sbs model. we use the finite differential time domain method to do the sbs numerical simulation in fiber

    由於光纖水聽器中的sbs是在沒有種子光注入下產生的，於是我們推導了噪聲激發模型下描述sbs的耦合波方程組，對該方程組使用時域有限差分法進行了數值模擬，並推導了連續光和脈沖光下的閾值。
  9. In the end, this thesis tests the resonator with three methods in case that it is both open looped and closed looped, and gets the results listed below : 1 taking 1 mhz frequency width ld as the light source, using current injecting frequency modulation method, the output characteristic of the resonator is got, which proves that the laser used in the lab can be used to modulate the frequency using current injecting frequency modulation

    本文最後採用三種不同的方法對諧振式光纖陀螺進行了開環和閉環的實驗測試，並取得了以下實驗結果： 1 、用頻寬1mhz的ld作光源，採用電流注入調頻的方法，觀測到了諧振腔的輸出特性曲線。證明了實驗採用的激光器可以通過注入電流的方法實現調頻。
  10. The paper discusses the specific problems about the conductive light - solidification composite material ( clscm ) deeply in theory ; presents the coat process of manufacturing clscm and some simple experiment methods creatively. we use several different fillings and different technics to make different clscm, and test some performances. in addition, we confect a kind of fiber - resin composite, and research the relationship between the performance of the material and the distortion of parts

    從理論上深入探討了開發導電性光固化復合材料應注意的問題，指出了填料的性能與添加量對復合材料性能的影響；提出了開發導電性復合材料的塗層工藝及一些簡易的實驗方法；利用不同的填料、不同的工藝方式開發出不同的導電性光固化復合材料，並對其多種性能進行了實驗測定或估測；根據理論分析，研究了材料性能與零件變形的關系，配製出纖維?樹脂復合材料。
  11. Many advantages make optical fiber suitable used as transmission medium of high - rate broadband services, such as broad transmission band, large capacity, low loss, strong immunity to interference etc. among optical access network, passive optical network ( pon ) is paid more attention throughout the world. it offers easily upgraded and low cost of lay, ope ration and maintenance. especially passive optical network based on atm ( atm - pon ) integrates the capability of supporting multiple qos services with atm and transparent transmission with pon

    在光纖接入網中，無源光網路（ pon ）由於不採用有源節點、敷設和運行維護成本低且成本共享、對業務透明、易於升級等優點而備受世界各國的關注，特別是以atm為基礎的無源光網路（ atm - pon ） ，由於結合了atm多業務、多比特率的支持能力和pon的透明寬帶傳送能力，將成為實現未來寬帶接入乃至最終實現ftth的重要方式。
分享友人
分享到 Line

分享到臉書