注入器柱 的英文怎麼說
中文拼音 [zhùrùqìzhù]
注入器柱
英文
injector column- 注 : Ⅰ動詞1 （灌入） pour; irrigate 2 （集中） concentrate on; fix on; focus on 3 （用文字來解釋字句）...
- 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
- 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
- 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
-
The test samples injected into injection valve are brought into the column by mobile phase ; all ingredients are separated in the column and entered into the tester by order, chromatographic signals of which will be recorded by recorder, integrator or data processing system
注入進樣閥的供試品，由流動相帶入柱內，各成分在柱內被分離，並依次進入檢測器，由記錄儀、積分儀或數據處理系統記錄色譜信號。Therefore, the paper establishes the parallel computing platform and meets the demand of computing resources for large eddy simulation. it also studies the integration of cad / cam, grid generation system and cfd system, and brings the model computed in the paper into this system. on the bases of systematical and thorough numerical simulation researches in circular cylinder and the compares between instantaneous piv metrical results and numerical results of circular cylinder, the paper obtained some problems and several conclusions which should be noticed in les for making correct computatioa finally, by using these experiences and conclusions above and by putting them into an actual problem in engineering - optimized numerical simulation of static mixer, this paper achieved the turbulent high - level numerical simulation technique, i. e., system atical attempt in engineering application by les method
為此，搭建了微機并行計算平臺，解決了大渦模擬對計算資源要求；對cad cam 、網格生成與cfd系統集成進行研究，並將論文中所要計算的模型納入到此系統內；在對圓柱繞流問題進行了系統和深入的數值模擬研究和對圓柱繞流瞬態piv測量結果與數值計算結果進行比較工作基礎上，得到大渦模擬方法正確計算所需要注意問題和若干結論；最後利用以上得出的計算經驗和結論，通過對一個實際工程問題? ?靜態混合器優化的數值計算，完成了cfd中湍流高級數值模擬技術? ?大渦模擬方法工程應用的系統嘗試。
分享友人