泵浦開關 的英文怎麼說
中文拼音 [bèngpǔkāiguān]
泵浦開關
英文
pumswitch-
Safety device containing an audible alarm will break the circuit automatically when the pump is overloaded, temperature overheats or there is a shortage of oil or water
設想周到的各種電子保護裝置，如無熔絲開關，缺水或缺油，溫度異常及泵浦過負荷等自動警示系統，迴路能自動切斷，確保安全。Solid laser pumped by semiconductor laser has the advantages of laser diode and solid laser, so it develops rapidly in recent years and gets the extensive application in the fields of military, communication, processing and scientific research, etc. in order to meet the demands for laser power of semiconductor solid laser pump solid yag laser, i synthetically adopt the singlechip digital automatic control technology which is extensively used in the intelligent instruments, products of electromechanical integration and automatic control system, lcd technology, pc switch technology and steady voltage, invariable current technology
半導體激光泵浦的固體激光器由於兼有了激光二極體和固體激光器的雙重優點，近年來得到迅速發展，並在軍事、通訊、加工和科研等領域中得到廣泛的應用。本文針對半導體固體激光器泵浦固體yag激光器系統對激光電源的要求，並且綜合運用了當前在智能儀表、機電一體化產品、自動控制系統中應用廣泛的單片機數字化自動控制技術、 lcd顯示技術、 pc開關技術及穩壓、恆流技術，研製了脈沖半導體激光電源。Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too
本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
分享友人