流量比調節器 的英文怎麼說

中文拼音 [liúliángbǐdiàojiéqì]
流量比調節器 英文
flow ratio controller
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 量比 : fnc
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
  2. The improvement system is made up of the pressure sensor, flow sensor, displacement sensor, electro - hydraulic proportional flow control valve, power amplifier, data gathering board and computer. the platform can carry out testing the hydraulic parameters, processing the tested data, saving the processed data and drawing, adjusting the pressure automatically

    改造后的測控系統主要由壓力傳感器、流量傳感器、位移傳感器、比例節流閥、功率放大器、數據採集卡和計算機組成。改造后的實驗臺具有自動採集實驗數據、自動處理實驗數據、自動保存實驗數據、自動調節液壓系統負載壓力等功能，大大提高了實驗臺的工作效率、測試精度和智能化水平。
  3. The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method

    本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。
  4. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念，對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成電流閉環系統的穩態誤差，並用根軌跡法對轉子位移控制系統的校正環節進行了研究。
  5. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲用水處理系統由於存在復雜性、非線性、時變性，本文根據臭氧生物活性炭水處理工藝存在復雜性、非線性、時變性等特點，將模糊控制應用在水處理這一不確定的非線性時變系統，針對不同水溫下臭氧利用率及水質的變化，設計一種基於系統過程狀態的變結構的模糊控制器，以單片機作為主要控制硬體，按查表方式設計軟體，對進水閥門開度進行在線控制，調節臭氧氣體與進水的比例（臭氧流量及濃度不變） ，達到氣水比最優化。
  6. In this paper, some off - line manual methods for regulation of flow equation have been compared and analyzed. based on pid speed governor of turbines, two kinds of governors are designed for adjustable - blade pump, which can perform autoregulation on water height of the fore bay and on pump output by adjusting the blade angle of adjustable - blade pump. the computation models of the two kinds of governors are also offered and the transient simulation can be done on pc

    文中，比較分析了現有的多種離線手動調節流量平衡的方法，在水輪機pid調速器的基礎上，針對轉槳泵設計了兩種新型調節器，通過改變轉槳泵的葉片安放角，分別能對泵站前池水位和泵的輸出流量進行自動調節；提出了兩種新型調節器的計算模型，使轉槳泵在線自動調節動態模擬得以在微機上得以實現。
  7. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理，建立它的軟體模擬系統，它可以根據給定的結構、環境、電路設置等參數首先模擬光熱、熱電轉換過程，並可根據電路結構，模擬校準、參數調節並讀出信號，給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵量的定量變化過程，預測製成后器件的各種性能參數。
  8. This strategy has many advantages : solving the problems that the system is unsteady under super - synchronization ; improving power factor of stator ( it is unity relative to that of rotor ) ; no rotor position sensor and no initial position measurement, easily building up doubly fed speed adjustment system with speed sensorless because adjusting speed is taken in the rotor coordinate and rotor current vector fixing is implemented

    該方案由於引入了定子電流勵磁分量的閉環控制，使系統同時具有轉速和勵磁調節兩個調節通道，具有如下優點：一、解決了超同步工作工況不穩定的問題；二、提高了定子側的功率因數（與轉子側功率因數為1相比） 。三、由於速度調節在轉子坐標系下進行，並以轉子電流矢量定向，所以無須轉子位置傳感器，也不用檢測初始位置，易於組成無速度傳感器雙饋調速系統。
  9. With regard to the flow regulation of the best - effort traffic, the controllable traffic in high speed computer communication networks, the present paper proposes a novel control theoretic approach that designs a proportional - integrative ( pi ) controller based on multi - rate sampling for congestion controlling. based on the traffic model of a single node and on system stability criterion, it is shown that this pi controller can regulate the source rate on the basis of the knowledge of buffer occupancy of the destination node in such a manner that the congestion - controlled network is asymptotically stable without oscillation in terms of the buffer occupancy of the destionation node ; and the steady value of queue length is consistent with the specified threshold value

    本文從控制理論的角度出發，針對計算機高速網際網路中最大服務交通流即能控交通流的調節問題提出了一種基於多速率采樣的具有比例積分（ pi ）控制器結構的擁塞控制理論和方法，在單個節點的交通流的模型基礎上，運用控制理論中的系統穩定性分析方法，討論如何利用信終端節點緩沖佔有量的比例加積分的反饋形式來調節信源節點的能控交通流的輸入速率，從而使被控網路節點的緩沖佔有量趨于穩定;同時使被控網路節點的穩定隊列長度逼近指定的門限值。
  10. The main module of sensorless pmsm vector control such as voltage sensing, current sensing, smo rotor position estimation, speed calculation, generation of sine and cosine, vector coordinate transformation, pi regulators, svpwm vector modulation are all accomplished in the pwm interrupt service routines

    永磁同步電機無位置傳感器矢量控制的主要模塊如電壓采樣、電流采樣、滑模轉子位置估算、速度計算、正餘弦值生成、矢量坐標變換、比例積分調節器、空間電壓矢量脈寬調制等都是在pwm中斷服務子程序中完成。
  11. Fcd. 3 138g : 4ds outer - thread copper pipe union at both ends of the inlet and the outlet this valve uses the principle of two - stage pressure reducing variation and, when to lower the switch valve, the shock from the water pressure to the valve casing shortens the start time of this valve under the highest medium pressure and makes it with the incomparable superiority of energy saving among the pulse - type electric - controlled valves, combining to increase filtered to regulate the discharge function with machine type

    該閥採用二級減壓變化原理，降低開關閥時水壓對閥體等配件的沖擊，提高電磁閥的可靠性和工作壽命，縮短了閥在最高介質壓力下開啟時間，使其在脈沖式電控閥門中具有無可倫比的節能優勢，並在接線上採用密封插件，並增加了過濾器和機械式調節流量功能。
  12. And the controlling method of pi makes the temperature control quick and stable. at the same time, the paper completes the mutual communication between temperature control equipment and computer by way of serial interface and usb interface, so as to realize the remote control of computer to the temperature control equipment. finally, the performance test of the semi - conductor temperature control equipment researched in this paper is carried out, and the results show that the precision of the temperature of the controller of semi - conductor can reach to 0. 2, and the degree of temperature stablization is less than 0. 05

    整個系統採用閉環控制結構，使系統的抗干擾能力大大增強;為半導體製冷器量身定做的驅動電路，可以方便的調節通過tec電流的大小和方向，使tec加熱製冷靈活迅速的特點得到充分發揮;使用比例積分（ pi ）的控制方法使得溫度控制快速穩定;同時，本文還實現了溫控儀與上位機通過串列口和usb口兩種方式的通訊，實現了上位機對溫控儀的遠程控制;最後，對所研製的半導體溫度控制儀進行了性能測試，測試結果表明，半導體溫度控制儀溫控精度達到0 . 2 ，溫度穩定度小於0 . 05 ，滿足了系統設計的要求。
分享友人
分享到 Line

分享到臉書