流體壓力測法 的英文怎麼說

中文拼音 [liútǐyālìcèfǎ]
流體壓力測法 英文
manometry
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  1. Hydraulic fluid power - test code for determination of airborne noise levels - part 3 : pumps - method using a parallelepiped microphone array

    液壓流體動力.氣載噪聲級測定的試驗規程.第3部分:泵.採用平行六面體麥克風排列法
  2. The forecast method of formation compression the principle of forecast method is based on increasing of formation compression along with burial depth. the used parameters include velocity, density, porosity, and fluid content etc. in fact, the factor influence formation compression is very complex

    4地層壓力預測方法地層壓力預測方法的基本原理建立在地層壓力隨埋深增加而增加的基礎上，所用的參數主要有巖層速度、密度、孔隙度、流體含量或與之有關的參數等。
  3. Methods for determining the performance of pumps and motors for hydraulic fluid power transmission

    液壓流體動力傳輸用動力泵和電動機性能的測定方法
  4. Pneumatic fluid power systems. cylinders. measurement of friction forces. laboratory method

    氣壓流體動力系統.氣缸.摩擦力測量.實驗室方法
  5. Petroleum and related products - determination of the extreme - pressure and anti - wear properties of fluids - four ball method european conditions

    石油及其產品的試驗方法. bs 2000 - 239 :流體的極限壓力和耐磨特性測定.四球法
  6. Pneumatic fluid power - compressed air lubricators - test methods to determine the main characteristics to be included in supplier ' s literature

    氣動流體動力.壓縮空氣潤滑器.供貨商文件包括主要特性測定的試驗方法
  7. Hydraulic fluid power - fluid contamination - determination of particulate contamination by the counting method using an optical microscope

    液壓流體動力.流體污染.用光學顯微鏡計數法測定粒狀物污染
  8. It has a long history using a throttle device to measure the flow volume of fluid in pipe the method has formed normalization at home and abroad the principle is to make the flow bunch form the particial shrink at the place where the throttle part is located so as to produce a static pressure difference then measure and calculate the flow volume at the moment when the fluid is flowing through the throttle device by the static pressure measured this method is based on the law of conservation of energy and the equation of flow continuity

    用節流裝置測量管道中流體流量已歷史悠久，在國內、國際上都已標準化，其原理是使流束在節流件處形成局部收縮，產生靜壓力差，通過測量靜壓力差來衡量流體流過節流裝置時的流量大小，這種測量方法是以能量守恆定律和流動連續性方程為基礎的。
  9. According to the request of this subject, we have developed the system hardware and software for the slave device and the inspection software running on the pc. in this paper all of the followings is illustrated detailedly, such as the research on the principles of measurement and its realization, three means of water - level measurement that are separately based on photo electricity coder, pressure sensor and potentiometer ; selection of the microchip, we choose an advanced integrated soc ( system on chip ) microchip c8051f021 as the main controller ; realization of signal sampling, processing and its conversion in the mcu ; application of high precision 16 bits adc cmos chip - - ad7705 in our system, designing its interface with the microchip and relevant program ; using a trickle charge timekeeping chip ds1302 in the system which can provide time norm and designing of its i / o interface and program ; additionally, a 4 ~ 20ma current output channel to provide system check - up using ad421. in the system, ad421, ad7705 and the microchip compose spi bus ; to communicate with the master pc, here we use two ways which are separately rs232 and rs485 ; moreover, there are alarm unit, keyboard unit, power supply inspection unit and voltage norm providing unit in the system

    針對研製任務的要求，課題期間研製了下位機系統硬體和軟體，開發了上位機監控軟體，其中所作的具體工作包括：測量原理的研究和在系統中的實現，在本次設計中用三種方法來進行水位測量，分別是旋轉編碼器法、液位壓力傳感器法和可變電阻器法；主控晶元的選擇，我們選用了高集成度的混合信號系統級晶元c8051f021 ；實現了信號的採集和處理，包括信號的轉換和在單片機內的運算；高集成度16位模數轉換晶元ad7705在系統中的應用，我們完成了它與單片機的介面設計及程序編制任務；精確時鐘晶元ds1302在系統中的應用，在此，我們實現了用單片機的i o口與ds1302的連接和在軟體中對時序的模擬，該晶元的應用給整臺儀器提供了時間基準，方便了儀器的使用；另外，針對研製任務的要求，還給系統加上了一路4 20ma模擬信號電流環的輸出電路來提供系統監測，該部分的實現是通過採用ad421晶元來完成的，本設計中完成了ad421與單片機的spi介面任務，協調了它與ad7705晶元和單片機共同構成的spi總線系統的關系，並完成了程序設計；與上位機的通信介面設計，該部分通過兩種方法實現： rs232通信方式和rs485通信方式；系統設計方面還包括報警電路設計、操作鍵盤設計、電源監控電路設計、電壓基準電路的設計。
  10. According to the high dispersedness and low precision of measurements when using the traditional time difference method in small diameter and low flow rates conditon, this paper brings forward a new method based on high - speed data acquisition technique. the time difference comes out accurately with high resolving ability of time by using the method and the signal processing algorithms. the developed ultrasonic detection system is composed of two ultrasonic detectors, a transmitting and receiving ultrasonic unit, a high - speed data acquisition unit and a computer

    本文針對傳統的時差法在小管徑、低流速測量時，具有測時結果分散性大、測量精度受計數頻率的影響大等不足，創造性地把高速數據採集技術應用在超聲波流量、壓力測量上，用信號處理演算法求時差，使時差成為一個統計量，有效地克服了超聲波傳統時差法測量精度差、不能測量小管徑、低流速流體流量的缺點，提高了時差測量的解析度和精度。
  11. Hydraulic fluid power - fluid contamination - determination of particulate contamination by the counting method using a microscope

    液壓流體動力.流體污染.用顯微鏡計數方法測定顆粒污染度
  12. The prediction of propeller - induced hull pressure fluctuation in non - uniform flow is studied by using theoretical calculation and model experiment systematically. an intact method and computer program for the prediction of unsteady cavitating propeller - induced hull pressure fluctuation in non - uniform flow is set up in this paper. the measurement of propeller induced hull pressure fluctuation in depressurized towing tank carried out in this paper is the first time inland

    本文從理論計算和模型試驗兩個方面系統地研究了不均勻流場中螺旋槳空泡誘導的船體表面脈動壓力的預報問題，建立了一套完整的預報非定常空泡螺旋槳誘導的船體表面脈動壓力的方法和程序，並在國內首次完成了在減壓拖曳水池中進行空泡螺旋槳誘導的船體表面脈動壓力測試。
  13. Hydraulic fluid power. fluids. determination of overall particulate contamination by the gravimetric method

    液壓流體動力.流體.用重量法測定顆粒總污染度
  14. Determination of hydraulic fluid power motor characteristics - method at constant flow and at constant torque

    液壓流體動力馬達特性的測定.第3部分:恆定流和恆定扭矩法
  15. Pneumatic fluid power. compressed air lubricators. part 2 : test methods to determine the main characteristics to be included in supplier ' s literature

    氣動流體動力.壓縮空氣潤滑器.第2部分:測定供應商資料中應包含的主要特性的試驗方法
  16. Pneumatic fluid power - compressed air pressure regulators and filter - regulators - part 2 : test methods to determine the main characteristics to be included in literature from suppliers

    氣動流體動力.壓縮空氣壓力調節器和過濾調節器.第2部分:廠商資料應包含的主要特性測定的試驗方法
  17. Pnuematic fluid power - compressed air filters - test methods to determine the main characteristics to be included in supplier ' s literature

    氣壓流體動力.壓縮空氣過濾器.供貨商文件包括主要特性測定的試驗方法
  18. Pneumatic fluid power. compressed air filters. part 2 : test methods to determine the main characteristics to be included in supplier ' s literature

    氣壓流體動力.壓縮空氣過濾器.第2部分:測試供應商資料中應包含的主要特性的試驗方法
  19. Pneumatic fluid power - compressed air filters - part 2 : test methods to determine the main characteristics to be included in supplier ' s literature

    氣液流體動力.壓縮空氣過濾器.第2部分:預定列入供應商資料中的產品主要特性的測定試驗方法
  20. Hydraulic fluid systems. fluids. determination of solid particulate contamination by optical microscope and image analysis

    液壓流體動力.流體.用光學顯微鏡和圖象分析法測定固體顆粒污染度
分享友人
分享到 Line

分享到臉書