浸水變水 的英文怎麼說

中文拼音 [jìnshuǐbiànshuǐ]
浸水變水 英文
steep water change
  • : Ⅰ動詞1 (泡在液體里) soak; steep; immerse 2 (液體滲入) soak; saturate; steep Ⅱ副詞[書面語] (...
  • : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
  • 浸水 : flooding
  1. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸形、霉主要發生在地板企口表面的特徵,採用企口表面全封閉法,在復合強化地板企口表面噴塗特殊的防封閉劑,使其依靠毛細管作用及滲透作用進入板內一定深度,堵塞木纖維之間的空隙及毛細孔通道,截斷分傳遞的渠道,並改毛細孔壁及纖維的表面性質以不利於潤與吸附,同時其固化后能在企口表面形成一層緻密的憎薄膜,防止分、濕氣從企口侵入板內引起木纖維膨脹形、發霉等現象。
  2. The inner factors refer to the mechanical behavior such as the rock type, density, construction parameter, etc. and the outer factors refer to the foundation condition, geological condition, valley shape, rise and fall of water level, seepage due to respiration

    內因是指堆石料的巖質巖性、密實程度、施工參數等組成壩體的各種力學性質;外因是壩址所處的基礎條件和兩岸的地形地質等條件、河谷形狀、位的化、降雨潤等因素。
  3. Test results show that that the breakcown voltage and heat distortion temperature the encapsulating materials of epoxy resin with hgh are famously improved, but the the addition of hgh, the viscosities of the epoxy resin - hgh system is higher compared with that of the others and the encapsulating process is effected. nano - sio2 improves the mechanical properties of encapsulating materials of epoxy resin, impact strength reaches 27. 64kj / m2 from 13. 95 kj / m2, flexural strength reaches 136. 68mpa from64. 95 mpa. by addition of the montmorillonite, glass transition temperature and heat distortion temperature of the encapsulating materials are 13. 2 and 16 higher than that of epoxy re

    結果表明,活性硅微粉對環氧灌封材料的熱形溫度和電學性能提高較為顯著,尤其在后,電學性能降低幅度很小,西北工業大學碩士學位論文但活性硅微粉用量較大,材料的工藝性能明顯降低;納米5102對環氧灌封材料具有顯著的增強和增韌作用,沖擊強度、彎曲強度由原來的13 . 95kj / mz和64 . 95mpa分別提高到27 . 64kjzm2和136 . 68mpa 。
  4. Npe should be on the list of differential diagnoses in patients with bilateral alveolar infiltration after a neurological event

    因此,在中樞神經傷害后,若病人生成雙側肺化,應將神經性肺腫列為鑒別診斷之一。
  5. Detailed predictions on the fluid flow in mold and in cavity of nozzle working end were obtained at different side - hole angle and submerged depth of nozzles, and then the flux variation of liquid steel passing through central hole of the three - hole nozzle and the fluctuation of liquid steel in mold were inspected based on above predictions

    針對3孔入式口不同側孔傾角和入深度,數值模擬對結晶器內鋼流動做出了較為詳細的預報,研究工作就此分別考察了口中心孔流量化和鋼液面波動幅度。
  6. Owing of the special structure of the loess, the moistening deformation of varying degrees is on show with the result of the pressure and water, causing a lot of project accidents

    黃土由於其特殊的結構性,一般在與壓力的作用下顯示出不同程度的增濕形。造成了許多工程事故。
  7. Abstract : this paper introduces a new class f epoxy glass - cloth laminate. the synthesis of a epoxy adhesive and the production process were studied. the properties of the laminate were compared with those of some similar products abroad. the results show that the laminate has higher adhesive strength 、 resistivity in moist conditions 、 dielectric strength and mechanical strength in higher temperatures. it is applicable for electric equipments, especially those to run in higher moisture or higher temperature conditions

    文摘:本文介紹了最近開發成功的一種新型f級耐高溫層壓板,研究了環氧樹脂膠粘劑的合成,層壓板的製造工藝及其性能,並與國外同類產品進行了對比,結果表明,它具有粘接強度、后絕緣電阻及耐電壓、高溫機械強度高等特性,可用作大型高壓電機、輸電設備以及核電工程、低溫高真空工程中絕緣結構材料,尤其適用於高電壓、高溫、高機械強度的工作環境。
  8. Aerospace series. parachute fabric. tests on braided ropes braids and narrow fabrics. determination of dimensional variations after immersion in cold water

    航空航天系列.降落傘織物.編織繩編帶和窄幅織物的試驗.入冷后尺寸化的測定
  9. A method is proposed to calculate expansive deformation of soils round fissures by time - travel expansive curve, and then to determine fissures " healing progress

    提出了利用膨脹時程曲線計算裂隙周圍土體的膨脹形量來確定裂隙隨愈合過程的方法。
  10. Numerical simulation and auto - generation of random fissures network are conducted by monte carlo method. secondly, one - side immersion swelling tests are carried out, and time - travel expansive process regulations are obtained

    然後,進行了非飽和膨脹土的單向膨脹試驗,研究得出了單向條件下非飽和膨脹土的膨脹形隨時間發展的規律。
  11. The colour of the film will change after immersion in water

    塗膜在后,顏色會發生化。
  12. Through the static and standard traffic cyclic loads, the responses of the pavement and subgrade have been attained. the studies on these responses such as elastic deformations, accumulative settlements and stress have been made under the changed characters of subgrade, such as moisture content, relative compaction of subgrade. the results of the experiments show that superfluous moisture content increases the vertical stress and the settlements of the construction under the similar relative compaction

    通過靜力加載和模擬路面承受的豎向交通荷載的重復加載試驗,研究了路面路基結構在雙輪車輛荷載作用下的動靜態響應,分析了路面路基結構在狀態(土層含量增加)和壓實密度降低等不利因數的影響下,路面路基各結構層的動靜力學響應特性,如彈性形、累積下沉、土壓應力等的化規律。
  13. 2. if it is very dirty. soak it in disinfecting water every 15 days. wash it by washing machine to disinfect it and the tissue will become very clean

    2 .很臟的話,可以每15天一次泡在放好消毒裡,用洗衣機洗滌,即可消毒,而且除塵滾筒也會得很乾凈。
  14. The basic physical and mechanical properties, mineral composition, micro structures, swelling potential, consolidated drained triaxial shear strength, parameters of constitutive model and residual strength of the soft clayey rocks were tested in laboratory with a large number of natural samples. the changing trend of the strength about these rocks is obtained by modeling the condition of softening due to immersion. from the principles of modern soil mechanics, the structural and swelling characteristics of soft clayey rocks were analyzed systematically

    本文通過現場調查,查明風化泥質軟巖的宏觀結構特徵,利用現代試驗測試手段,取原狀土系統進行特殊土室內土工試驗,測定土的基本物理力學特性、礦物成分及微觀結構、膨脹性、三軸排剪強度及本構模型參數、軟化殘余強度,並模擬土體在長期軟化后的強度化趨勢,測試該類土的軟化殘余強度。
  15. The effect of wind chill and lower water temperatures during the winter season can result in hypothermia after only even a relatively short period of immersion

    留意天氣狀況可急速改。冬季寒風及低的溫下浮中短暫時間也可引致低溫癥。
  16. As the surface deteriorates, water in any form, dew, humidity, rain, wash and rinse water, as well as other microscopic destructive elements such as acids and alkali substances, enter into the microscopic pores, fissures, cracks and other surface imperfections and begin to attack, or breakdown the molecules that make up your car ' s paint

    隨著漆面的惡化,、露、濕氣、下雨、清洗和漂洗的,還有其它看不見的具有破壞性的物質如酸雨、堿性物質,都會入到小孔、裂縫、裂紋和其它表面不完整的地方也開始化或者分解車漆的分子。
  17. Paper. measurement of dimensional change after immersion in water

    紙張.后尺寸化測定
  18. Method for measurement of dimensional change of paper after immersion in water

    后尺寸化的測量方法
  19. Wood based panels. determination of water absorption and dimensional variations after immersion

    木基板.后尺寸化和吸性的測定
  20. Wetting experiments as well as rheological experiments of rockfill materials are carried out, aimed at their deformation behavior especially rheological characteristics and their effect on the deformation of dam body of concrete face rockfill dam ( cfrd ). the main contribution includes : ( 1 ) the development of cfrd and its study actuality are reviewed

    本文較為系統地分析研究了堆石料的工程特性,開展了堆石料的形試驗和流試驗研究,重點研究了堆石料的流特性及其對混凝土面板堆石壩應力形的影響。
分享友人