浸漬金屬 的英文怎麼說

中文拼音 [jìnzìjīnzhǔ]
浸漬金屬 英文
impregnating metal
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 漬 : Ⅰ名詞1 （地面的積水） floodwater on low lying land 2 [方言] （積在物體上難以除去的油泥等） stain;...
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 金屬 : metal
  1. Aerospace series. non - metallic materials. resins, adhesives, reinforced plastics, preimpregnates. characterisation by liquid chromatography

    航空航天系列.非金屬材料.樹脂粘接劑增強塑料預浸漬劑.用液相色譜法的特性說明
  2. Aerospace series. composite and non - metallic thermoplastic impregnated materials. honeycom materials with tubular cells. technical specification. general requirements

    航空航天系列.復合非金屬熱固性塑料浸漬材料.帶管狀心蜂窩材料.技術規格.一般要求
  3. Filament winding machine is the key device which uses continuous fibre reinforced plastics to wind produce, its primary function is through which continuous fibre ( such as glass, aramid, carbon fibres and wire ) or fabric is wound on the mandrel surface on which produce is shaped according to needed pattern laws by special mechanical moves and controls

    纖維纏繞機是用連續纖維增強塑料來纏繞製品的關鍵設備，其首要功能是通過特定的機械運動和控制，將浸漬過樹脂膠液的連續纖維帶（如玻璃纖維、碳纖維、芳綸纖維、金屬絲等）或布帶，按照所要求的線型規律排布在制品成型的芯模表面上。
  4. Test method for testing nonmetallic seal materials by immersion in a simulated geothermal test fluid

    用模擬地熱試液浸漬法測試非金屬密封材料的方法
  5. Testing method of the chemical protective coatings of the ferrous metal for the light industrial products. dipping spot test

    輕工產品黑色金屬化學保護層的測試方法.浸漬點滴法
  6. Sintered metal materials. specifications. part 1 : materials, for bearings, impregnated with liquid lubricant

    燒結金屬材料.規范.第1部分:用液體潤滑劑浸漬的軸承材料
  7. Catalyst for ethanol synthesis. the results show that the reactive metals rh and mn are fixed on the catalyst surface by the interaction with si - oh, which can enhance the stability of highly dispersed metals. rh and mn interact with each other to form the acitve site with high ethanol synthesis activity. the surface si - oh was found to be of significance on the preparation of catalyst with high catalytic activity

    的性質，結果表明，活性金屬銠及錳經浸漬法擔載于載體上后即與表面羥基作用使金屬固定在氧化硅的表面上，保證了高度分散活性金屬的穩定性高度分散中的銠錳相互結合，構成了乙醇合成中的高活性位研究發現表面硅羥基在催化劑制備過程中起著重要作用。
  8. Laboratory immersion corrosion testing of metals

    金屬的實驗室浸漬腐蝕試驗
  9. The mo catalyst and the co catalyst prepared by impregnation reduction did not have zero - valent metals, the catalysts were not able to resist corrosion

    以硼氫化納（ nabh4 ）為還原劑的浸漬還原法制備的mo 、 co催化劑並不能得到單質的金屬，而且抗腐蝕性能不好。
  10. Catalysts were prepared by impregnation reduction, thermal reduction, advanced thermal reduction and sol - gel methods from these metals. electrochemistry measurements, xrd, tem were used to test these catalysts. the results showed that these metals have some electrocatalysis activities towards hydrogen oxidation reaction

    本文選擇了w 、 mo 、 co等金屬，採用浸漬還原法、熱還原法、改進的熱還原法以及溶膠凝膠法分別制備了這幾種金屬的碳載催化劑，對制備出的非貴金屬催化劑進行了電化學測試、 x -射線衍射（ x - raydiffraction ， xrd ） 、透射電子顯微鏡（ transmissionelectronmicroscopy ， tem ）等測試，研究結果表明:這些非貴金屬在硫酸體系中對氫氣的氧化反應均有一定的催化活性。
  11. Standard practice for exposure of metals and alloys by alternate immersion in neutral 3. 5 % sodium chloride solution

    在3 . 5 %氯化鈉中性溶液中用交替浸漬法的金屬及合金暴露的標準實施規程
分享友人
分享到 Line

分享到臉書