液壓梯度 的英文怎麼說

中文拼音 []
液壓梯度 英文
flowing-pressure gradient
  • : 名詞(液體) liquid; fluid; juice
  • : 壓構詞成分。
  • : Ⅰ名詞1 (梯子; 樓梯) ladder; stairs; steps; staircase 2 (姓氏) a surname Ⅱ形容詞(形狀像樓梯的...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 液壓 : hydraulic pressure液壓泵 hydraulic pump; 液壓表 hydraulic pressure gauge; hydraulic pressure indi...
  1. Ultrafiltration is the movement of the liquid passing through the half film when the liquid is affected by the pressure grads, which can be described precisely as the molecule moves from the blood to the dialytic solution

    體在作用下通過半透膜的運動,稱為超濾,具體是指水份從血側向透析側移動。
  2. The key items include the car sinking, constant speed characteristics, inspection function, auto relevelling function and level accuracy, etc. the research contents focus on the following three parts : firstly, research on effects of system parameters on car sinking has been completed. secondly, the constant speed performance with the compensation of internal leakage of pump / motor is improved. lastly, research on improvement of the car level accuracy and contrast to that of traction elevators is presented, and the reasons of low car level accuracy of hydraulic elevators are discussed

    重點研究了三方面內容:一是研究了停層沉降特性及影響電轎廂停層沉降特性的各種因素;其次是通過負載力補償泵馬達內泄漏來改善電轎廂速穩定性;最後是平層精的理論和實驗研究,並與曳引電的理論模型進行了對比,闡述了平層精低的原因,理論探討了影響平層精的主要因素。
  3. This dissertation focus on a innovation methods for inverter controlled hydraulic elevator system applying pressure accumulator as the " pressure - energy transformer ". the required power supply and running energy can be reduced remarkably when accumulators storing and releasing pressure oil. then the key items about hydraulic speed control system based on the ens 1 - 2 and other hydraulic elevator standards are investigated in detail

    本論文主要研究了採用蓄能器-泵馬達構成的「力-能量轉換裝置」來儲存釋放變頻驅動系統的能量,從而降低裝機功率和運行能耗的新方案;在此基礎上,根據國內外的標準進行了與速控制相關的關鍵項目測試,最後針對本課題研製的節能控制系統與當前市場上幾種典型的控制系統進行了能耗對比研究。
  4. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模,並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究,主要針對影響系統特性的主要參數變化,動態分析系統的輸出特性,在上下行工況中,分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路泵馬達內泄漏系數、蓄能器氣體容積、缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響;最後對軸向柱塞泵馬達的流量力脈動對電轎廂速的影響和蓄能器內油體積損失機理進行了理論研究。
  5. This machine is a kind of radial riveting machine, the machine adopted the advanced radial technology, and its movement path likes the 11 pieces of plum blossom s shape, and using the screw pole to ascend and descend the work bench the head part is fixed, and the t - slot of bench can fix the clamping apparatus available, the center hole of bench and axis are coaxial, the one - way adjusting valve of liquid current is effectively controlled riveting speed

    Jm12 - c是類中重型徑向鉚接機,除應用有第五代徑向鉚接技術外,該機加長了鉚接行程,該項參數由普通機型的30mm加至60mm ,可滿足長行程深孔內鉚釘鉚接的要求。工作臺,並具有夾具形槽,工作臺中心孔徑與主軸軸線同軸,可用於夾具定位。氣路加裝雙向調節閥,有效控制鉚接速
  6. A convenient model of pressure gradient calculation of gas - liquid slug flow in vertical wellbore

    垂直井筒氣段塞流的簡便演算法
  7. Study on the total activity of amylase of sprouting maize seeds affected by treatment of electrostatic field

    技術研究高靜電場凈化油應用研究靜電作用下體表面張力的研究
  8. Chapter 2 describes the working theory of the hydraulic elevator control system, and introduces the components of this system, especially the vsvii integrated valve, which could be regulated by the controller of single chip processor with flexible control strategy. also the mathematical models for the hydraulic elevator control system with vsv ii valve are derived and the simulation is made

    論文的第二章主要介紹採用轎廂速反饋電比例控制的的工作原理,分析了本課題所採用的控制系統的各個組成部分,特別介紹了本課題組自行研製的vsv型專用比例閥和計算機監測系統,並對控制系統進行了建模和模擬。
  9. The demarcation point of, which is the parameter in erf ' s yield stress equation, is 2. 0. for, the dynamic characteristics of the clutch are remarkably different from those for. thirdly, the linear stability of plane shearing flow with non zero pressure gradient is studied

    論文第三部分對電流變非零平板剪切流動的穩定性進行了分析,提出流場對屈服應力達到飽和的概念;並得出平板壁面剪切運動以及電流變屈服應力的提高,都將使流動穩定性增強的結論。
  10. Hydraulic elevator is a typical electrohydraulic control system, and the speed feedback control method is advanced technology

    是一種典型的電控制系統,直接轎廂速反饋控制是一項先進的技術。
  11. The proportional flow valve control system with speed - electric feedback applied in hydraulic elevators can eliminate disturbances of nonlinear source such as oil temperature and load change. in this system, the proportional valve plays a key role

    採用轎廂速一電大閉環反饋控制方法的電比例閥控系統,可以排除油溫及負載變化等因素引起的非線性干擾,極大地提高了的工作性能。
  12. The application of programmable logic device in hydraulic elevator velocity control system

    可編程邏輯器件在控制系統中的應用
  13. In chapter 5, the author focuses on the experiment of the hydraulic elevator control system and analyzes the closed loop control results of system

    論文的第五章是單片機控制的控制系統實驗研究,介紹了實驗流程,並對實驗現象和結果進行了分析。
  14. A number of overall correlations have been developed for the prediction of the pressure gradient in the vertical flow of gas-liquid mixtures.

    為了預測氣混合物垂直流動的,已經得出了許多整體相關規律。
  15. The experimental techniques ( such as sedimentation equipment, controlling the size and size distribution of powders, the concentration of suspension ) have been devised subtly. on the basis of theoretical and densification design, the w - mo - ti fgm has been obtained by particle settling and hot pressing sintering. the structures of specimen were observed by electron probe

    通過對實驗工藝,如沉降設備、原料粒及粒分佈的控制、懸浮等方面進行精細的設計,在理論設計和緻密化研究的基礎上,通過顆粒共沉降得到沉積體,並通過真空熱燒結得到w - mo - ti功能材料。
  16. Using matlab, the step response characteristics of the valve in the elevator system is simulated, comparing the effect of its performance with different structure parameters of the pipe rupture valve, such as hydraulic resistance, diameter of the valve, and spring rigidity, and comparing the valve ' s dynamic performance under different operating conditions, such as environment temperatures, number of passengers, and emergencies of the hydraulic system, so the paper offers a general and systematic analysis for the pipe rupture valve of the elevator system

    另外,在不同的工況下,對該閥的動態性能進行了模擬對比研究,如不同環境溫、不同乘客人數、不同系統意外,以及不同的油體積彈性模量,比較全面系統的分析了限速切斷閥在電系統中的性能,根據這些模擬結果,可以分析該閥正常工作的工況要求和環境要求。
  17. This study we acquired the coding region of hcv ns5b gene by pcr of hcv full length genome and construct the recombinant plasmid pegep n3 - ns5b ; with the different concentration of g418 in the culture medium, we think the selection concentration of g418 for hepg2 cell is 800 g / ml ; the recombinant plasmid was transfected into hepg2 cell by lipofectamine2000 cells containing stable transformants were selected by the ability of resistance to g418 and isolated with the limited dilution. the stably transfected cell line expressing ns5b - egfp fusion protein was obtained by the detection under fluorescence microscope and rt - pcr

    本研究首先從hcv基因組中擴增出nssb基因,構建了nssb基因與報告分子egfp (增強型綠色熒光蛋白)基因的融合基因真核表達質粒pegfpn30 ;通過含有不同g418濃的培養培養hepgz細胞,確定了篩選用g4181作濃為800pg ml ;利用脂質體法將該重組質粒轉染hepgz細胞,經過有限稀釋法和g4力選擇,應用熒光顯微鏡和rtpcr檢測,獲得可穩定表達nssbegfp融合蛋白的hepgz細胞克隆。
  18. The liquid phase is coupled device is the low voltage gradient itself in a high - pressure pumps add ratio valves in the atmosphere will be set according to the proportion of online several solvents mixed, then pump into the gas system

    相色譜中的低洗脫裝置就是在高泵之前加上一個比例閥,在常下將幾種溶劑按設定的比例在線混合之後,再泵入色譜體系。
分享友人