液壓櫃 的英文怎麼說
中文拼音 [yèyāguì]
液壓櫃
英文
hydraulic tank-
The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced
論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。Based on this method, design the system oil circuit and constant - pressure hydraulic power station as well as the hydraulic manifold block, measuring platform, electrical cabinet and reclaiming oil tank
在此油源方案的基礎上，設計出測量系統油路、油源泵站系統，同時進行了液壓集成塊、測量臺架、電氣控制櫃和漏油回收油箱的設計。Based on remaining the dismantling and loading, we make full of the equipped instrument, and fall the whole cycle into three modules : speed - adjusting module, pressure module and multi - execution instrument module. we must compile the related plc control program and pc control program, and redesign the control cabinet and re - fix the electric cycle. we complete the auto - control of the hydraulic experiment table through the loading and recapitulate debugging
在保留其元件可裝拆性的基礎上，我們充分利用現有液壓實驗臺的液壓元件，對其基本迴路進行重新組合，分為調速、壓力和多執行元件控制迴路三個模塊，並編制可編程式控制制器程序和上位機數據採集程序控制迴路動作，重新設計該實驗臺的電氣控制櫃，並進行現場接線和安裝調試，實現所有教學必須實驗迴路的自動控制。The following equipment need buffer room ( the buffer room is used for safe cabinet of gas cylinder and noisy compressor and keeping cleaner ) : aas, afs, gc - ms, and lc - ms
5需要設緩沖間的儀器（緩沖間用來放置安全氣櫃瓶和有噪聲的壓縮機以及保持清潔）原子吸收，原子熒光，氣相色譜質譜，液相色譜質譜。Hydraulic pressure principle and structure characteristics of new type mechanical governor cabinet
新一代調速器機械櫃液壓原理及結構特點分享友人