液膜系數 的英文怎麼說

中文拼音 [shǔ]
液膜系數 英文
liquid film coefficient
  • : 名詞(液體) liquid; fluid; juice
  • : 名詞1. [生物學] (像薄皮的組織) membrane 2. (像膜的薄皮) film; thin coating
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : 數副詞(屢次) frequently; repeatedly
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱孔內傳質機理的研究,最後得到了真空蒸餾脫除水溶中voc全過程的學模型。
  2. Digital temperature transmitter, digital level, explosion - proof electric contact manometer figures generally used manometers, vacuum table, table vacuum pressure, oxygen forms of electric contact manometer, explosion - proof electric contact manometer seismic contact ammonia electricity connections. contact monometers assisted magnetic, seismic, heat - resistance, acid and alkali resistance, chlorine, sulfur - resistant, stainless steel pressure gauge. divide manometer shenyang city, the total, precision manometer, out of the wind pressure gauge, film boxes pressure gauge, diaphragm pressure gauge

    主要產品包括:字壓力表,盒壓力表,字溫度表,字壓力變送器,字溫度變送器,位計,字防爆電接點壓力表,一般用壓力表真空表壓力真空表氧氣表電接點壓力表防爆電接點壓力表耐震電接點氨用電接點磁助式電接點壓力表耐震耐高溫耐酸耐堿耐氯耐硫全不銹鋼壓力表隔壓力表沈陽市優質產品精密壓力表出風壓力表盒壓力表片壓力表全不銹鋼片壓力表鈦壓力表及出口全不銹鋼,充油全不銹鋼列壓力表,壓差表,壓力變送器,各種軸向軸向帶邊法蘭連接等多種形式。
  3. The humidity sensitive characteristics of these sensors prepared by means of self - assembly have been investigated and the effects of electrode structures, concentration of humi - sensing solution, number of bilayers, materials of the outer layer and inner layer on humidity response were discussed

    測試了不同體濕敏的感濕特性,探討了電極結構、感濕濃度、離子強度除閂電翻動復合、最外層材料、最內層材料等因素對濕敏元件響應特性的影響。
  4. The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell

    對磺化的研究分析表明:的性能參如離子交換容量、吸水率、水合、形體穩定性、導電性能、化學與熱穩定性等依賴于中苯乙烯含量,且接枝苯乙烯相互間的位阻效應對性能影響很大;的性能可與nafion相比較;質子在中的傳導遵循「似體」質子傳導機理;電滲析與擴散作用使保持水平衡。
  5. The factors, such as feed solution concentration, stirring speed, strip solution concentration and the ph value of feed solution, have been discussed when the membrane phase only contained membrane solvent

    相中不含載體時,分別考察了攪拌速度、料相濃度、反萃取濃度和料相ph值等因素對滲透的影響。
  6. Finite difference time - domain method is used to calculate the reflection for these probes and absorbing boundary condition is used to deal with the singularity in the axis of the coaxial - line in the simulation. by comparing the reflection of different probes, the best probe has been selected according to sensitive requirement. the influence of parameters : such as thickness of protective film, length of protruding inner conductor of the coaxial - line probe to the measurement has been studied

    通過時域有限差分法進行值模擬分析,並採用吸收邊界處理同軸線軸心奇異點,計算出各種探頭測量相同溶的反射,根據其測量的靈敏度,選出最優設計;並通過分析所選探頭的各種設計參,如薄厚度、內導體伸出長度等的變化對測量結果的影響,找出該探頭各參的最佳范圍,使其具有高度靈敏性,以適用於測量化學反應溶的介電常
  7. Studies have been made shown that under water stress, not only root weight, root specific surface area, root - shoot ratio, root growing potential, root water potential, root vessel diameter, etc which express the indexes of wheat root morphology and architecture have significantly changed, but also bleeding sap, root respiratory rate, root plasma membrane permeability, plasmalemma peroxide level, root protective enzymes and its isoenzymes etc which express root physiological indexes have changed correspondingly

    過去進行的研究表明,乾旱脅迫條件下,不僅表達小麥根形態和構型建成指標的根量、根比表面積、根冠比、根生長勢、根水勢、根導管直徑等發生顯著變化,而且表達根生理指標的傷流、根呼吸速率、根透性、脂過氧化水平、保護酶及其同工酶等也發生相應改變。
  8. The results denote that the sand layer can greatly enhance heat transfer in high temperature region because it changes film boiling to liquid film evaporation in the sand layer

    在高溫金屬面上覆蓋砂層后,可將高溫面上的沸騰轉化為砂粒表面的蒸發,從而大幅度提高表面換熱,強化冷卻能力。
  9. This work studied the preparation process of aluminum coating and the factor of the properties of the aluminum coating such as processing condition, pre - treatment, electroplating system, current density, and current efficiency and electroplating time etc. it is shown that alcl3 + lialh4 organic solution system can be fabricated aluminum coating and processing parameter of having high reflectivity aluminum coating is obtained

    對鋁的制備工藝及影響鋁性能的因素如工藝條件、預處理過程、電鍍、電流密度、電流效率及電鍍時間等進行了研究,確定了通過alcl _ 3 + lialh _ 4有機溶可用來鍍制鋁及獲得高反射率的工藝參
  10. The factors affecting the permeability coefficient are investigated, and the mass transfer model across the supported liquid membrane is established, by which the mass transfer is simulated

    考察了各因素對滲透的影響,並對傳質滲透過程進行模擬。同時建立了支撐中的相流失行為的動態阻抗監測方法。
  11. The effectiveness of a membrane mass exchanger increases with the increase in the so solute mass transfer coefficient, ultrafiltration flux and dialysate flow rate, as well as with the decrease in the retentate flow rate

    質量交換器之效率隨溶質質傳、超過濾濾速、及透析流量之增加,或隨保留流量之降低而增加。
  12. Study on the permeability coefficient of ammonia through hollow fiber supported liquid membrane

    氨在中空纖維支撐內的滲透
  13. ( 2 ) the permeation process in the flat - sheet supported liquid membrane under intermittent operation is investigated

    ( 2 )採用平板型支撐,測定各種操作條件下的滲透p 。
  14. Secondly, the permeation coefficient in the flat - sheet supported liquid membrane under batch operation was measured

    ( 2 )採用平板支撐,間歇操作,測定各種操作條件下的滲透
  15. Exerting the model of two mechanism heat transfer, the formulation for heat transfer coefficient of liquid film which in smooth tube and equipped with spring inserts is given in this paper. heat transfer coefficient is presented which not only has relation to reynolds number, temperature difference, liquid characteristic, but also is greatly influenced by structure parameter of the spring inserts. experiments indicate the heat transfer coefficient of tubes equipped with spring inserts is 25 % higher than smooth tube

    實驗表明,傳熱雷諾、傳熱溫差、料物性參利彈簧插入物的結構參有關,實驗條件下,安裝有彈簧插入物的豎管降蒸發側的傳熱比光管的傳熱可高達25左右,但某些結構參的彈簧插入物會造成傳熱的惡化。
  16. The factors affecting the permeation coefficient which contain original feed solution concentration, stirring speed, the original ph of strip solution and the original ph of feed solution have been discussed when the membrane phase only contains membrane solvent

    相中不含載體時,分別考察了料相初始濃度、攪拌速度、反萃取初始ph值和料相初始ph值等因素對滲透的影響。
  17. And also the factors, such as carrier concentration, feed solution concentration and strip solution concentration, also have been discussed when the membrane phase contained solvent and carrier. based on the double membrane theory, the model of phenol transport in supported liquid membrane was established, and the parameters of the

    在此基礎上,採用雙理論來解釋苯酚透過平板支撐的過程,在穩態假設下,建立苯酚在支撐內的傳質模型,並求解內擴散等模型參
  18. Based on the j c chen double mechanisms superposition model, the experimental formula of the heat transfer coefficient on the evaporation side in the smooth tube was obtained. considering the influence of spring to the falling film, the formula of heat transfer coefficient on the evaporation side in the vertical tube with spring inserts was obtained. the predicated heat transfer coefficient through this two formulas was finely accord with the experimental result, and the error was basically under 10 %

    在jcchen雙機理加和模型的基礎上,得出了光管降蒸發側傳熱的實驗關聯式,並考慮了螺旋線對降落的影響,得出了管內插入螺旋線的降蒸發側傳熱關聯式,這兩個關聯式預測的傳熱與實驗值吻合良好,誤差基本在10以內。
  19. The mechanism of phenol transport through the supported liquid membrane ( slm ) and the factors affecting the permeability coefficient were investigated. the method dynamic impedance monitor was established, and the stability and the loss process of membrane liquid of slm were investigated by this method

    研究探討了苯酚在支撐中的傳質機理,考察了各因素對滲透的影響;建立了研究支撐穩定性的動態電阻監測法,並對支撐體流失情形進行了研究。
  20. ( 1 ) partition coefficient, membrane phase conductance, and reversible reaction equilibrium constant when the membrane phase contains carrier are determined. furthermore, the operation factors affecting these parameters are also investigated

    ( 1 )測定包括分配體的電導率以及相中含有載體時的反應平衡常等基礎參,並分析了各操作條件對它們的影響。
分享友人