液體粘度理論 的英文怎麼說

中文拼音 [yètǐniándùlǐlún]
液體粘度理論 英文
liquid viscosity theory
  • 液 : 名詞（液體） liquid; fluid; juice
  • 體 : 體構詞成分。
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 液體 : liquid; liquor; fluid
  • 理論 : theory
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  3. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  4. Using smoluchowsky and mooney ' s rheology theory we analyze that without magnetic field 77 will increase as s andv increase ; using the rosensweig ' s formula and hydromechanical theory, we can illustrate that in the magnetic field and the outside temperature being certain, 77 will increase as the magnetic field increase, when the magnetic fluid ' s s and v are determined

    在外磁場的作用下，綜合rosensweis公式及流體力學理論很好的解釋了在外界溫度一定時，基液質量百分比濃度s和磁性微粒體積分數人確定的磁性液體，其粘滯系數司隨外磁場的增加而增加的原因。
  5. The author makes a mathematics model by viscous hydrodynamics and so on theories of the flowing material a and b on the board, and deduces the formulas of the film thickness and perfusion measure. i also analyze the surface tension of liquid, in order to find out the best technical parameters and to control

    作者利用粘性流體力學等理論建立了a 、 b混合料在太陽能電池板上流動的數學模型，從而推導出薄膜的厚度和灌注量的計算公式，並對所形成液面的表面張力進行分析，以找出最佳的技術參數，以便對其進行控制。
  6. The inserting method and properties of the composite materials in consist of omt and poly ( styrene - butyl acrylate ) had been researched ; the ultra - fine organic rigid particles crosslinked polystyrene ( xps ) has been synthesized by emulsion polymerization, the effect of the synthesis process on the size of organic rigid particles was discussed. the cause of the increasing mechanical properties of pp composite materials, which were strengthened and toughened with organic rigid particles and elastomer, had been investigated. the results of studying viscosity and precipitate height of sio2 nano - particles suspension showed that the sio2 nano - particles are very good dispersed by dp270 or cat 639w dispersant

    通過粘度法和沉降法測定結果的一致性，說明分散劑dp270和cat639w對sio _ 2納米粒子有較好的分散性， dp270的最佳用量為0 . 2時懸浮液粘度從35 . 1mpa ? s降為23 . 3mpa ? s ， cat639w最佳用量為0 . 4時懸浮液的粘度從35 . 1mpa ? s降為23 . 1mpa ? s ；通過研究分散劑存在下納米粒子的苯丙乳液聚合動力學，發現納米粒子的存在對乳液聚合有一定的緩聚作用，並討論了乳化體系、溫度、引發劑、表面處理劑以及納米粒子用量對聚合的影響。
  7. On the basis of the analysis abovementioned, the quantitative relation between the compositional distribution of sediment body and initial experiment parameters including powder characteristics ( density, size and size distribution etc. ) and settling parameters ( density and viscosity of suspension, heights of suspension and liquid, etc. ) have been established corresponding to the physical model selected

    在此基礎上，結合選用的顆粒共沉降的物理模型，通過理論推導，建立了粉末特性（粉末的密度、粒度以及粒度分佈等）和沉降參量（懸浮液的密度、粘度和高度以及清液的高度等）同沉積體組分分佈之間的定量關系。
  8. Rheology instrument is a type of blood ’ s clinical test instrument based on hemorheology theory. it is a special instrument which is used to diagnose disease by measuring blood viscosity

    血液流變儀是在血液流變學的理論基礎上發展起來的一種血液臨床檢測儀器，是一種通過檢測人體血液粘度來進行疾病早期診斷的專用檢測儀器。
  9. While integrating with the characteristics of microbial growth and biological reaction, this thesis presents a theoretical and applied study of several new system based on the response of one - face contacting liquid piezoelectric quartz crystal sensor to the viscosity and density of solution, and the response of spqc sensor to the conductivity of the solutioa the creative works are summarized four aspects as follows : 1

    本文充分利用單面觸液型壓電傳感技術對溶液粘度和密度的響應以及串聯式聲波傳感器（ spqc ）對溶液電導率和介電常數的響應，與微生物生長和生化反應特徵相結合，對幾個新的體系進行了理論與應用方面的研究。在下述四個方面取得了一些創新性的成果： 1
  10. And at the same time, considering the situation of varying oil viscosity and oil - flow inertia, this paper analyzes flowing properties of fluid in bearing clearance, which provide theory reference for more reasonable design and application of hydrostatic bearing in the equilibrium of axial force, and then carries out computer simulation a nd experiment verifying

    同時，在考慮油液粘度變化和油流慣性的情況下，分析了支承縫隙中流體的流動特性，並進行計算機模擬和實驗驗證，這為靜壓支承在軸向力平衡中的進一步合理設計和應用提供了理論參考。
分享友人
分享到 Line

分享到臉書