混合纖維 的英文怎麼說

中文拼音 [húngěxiānwéi]
混合纖維 英文
blend fiber
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  • 纖維 : fibre; staple; filamentary
  1. Due to the requirements of complex configuration of spatial curved surfaces and of continuity of fiber laying have becoming a difficult problem in cad technology for bicycle body frame of hybrid fibered compound material with multi - branch special shaped entire - body and sections of hollowed thin wall

    摘要對于多分支整體異形空心薄壁斷面混雜纖維復合材料自行車車架，由於復雜的空間曲面構形和纖維鋪設連續性要求成為其cad技術難題。
  2. Hybrid fiber coax inside plant status monitoring scte - hms - hmts - mib management information base definition

    混合纖維同軸內置設備狀況監控scte - hms - hmts - mib管理信息庫定義
  3. The fibers are glass fiber and core - spun yarn

    混雜纖維由玻璃纖維和復合包芯紗混雜構成。
  4. Identification of mixed fibers by subtractive infrared spectroscopy

    紅外差譜技術用於混合纖維鑒定的研究
  5. Studies on electromagnetic properties of the hybrid composites

    透波性混雜纖維復合材料性能研究
  6. It is showed that by using the phenolic resin and the fiber, the clutch friction materials could be manufactured with good properties such as stable friction coefficient, low wear rate, high fade resistance at 350, and suitable porosity

    結果表明，採用三組份酚醛樹脂和混雜纖維可以制備出摩擦性能良好， 350不發生熱衰退的離合器摩擦材料，且材料具有合適的孔隙率。
  7. And another brake material formula also can be achieved in which the carbon fiber was replaced by the wood fiber based on the researching of the effect of fibre, resin and filler in multi - fibres hybrid composite test result shows that the formula material have a relatively suitable friction coefficient ( ranging around 0. 35 ), good fade resistance and recovery as well as low wear ratio. by comparing the formula material with the product of national and abroad sold in the market, its low cost and excellent properties make a bright prospect

    在研究各種纖維、樹脂和填料對混雜纖維復合摩擦材料摩擦學性能影響的基礎上，本文研製開發出分別適用於中重型車與中小型車用的剎車摩擦材料的最佳配方和一種含木纖維的多種纖維混雜復合摩擦材料的最佳配方。將所選配方的剎車材料與市售的國內外品牌剎車片進行對比，結果表明本課題所開發研製的摩擦材料的摩擦系數都在0 . 35左右，具有很好的摩擦系數穩定性和抗熱衰退性，磨損率也較小，綜合考慮到配方試樣原料成本較低，在性價比上具有一定的優勢。
  8. The expansive experiment shows steel slag can compensate the concrete shrinkage during a long time and hybrid fiber restrains the concrete shrinkage

    鋼渣摻合料對混凝土收縮具有長期補償作用，混雜纖維起到抑制混凝土收縮的作用。
  9. The result of macro - quality experiments show : mineral admixtures markedly slow the hydrating velocity of cement slurry, decrease and delay the hydrating max - temperature, in which steel slag is more effective ; expansive agents compensate concrete shrinkage, enhance the concrete dense degree, strengthen the interfacial layer between fiber and cement matrix and improve the physical mechanics qualities of acic ; minimal admixtures markedly improve the concrete workability property, increase the concrete later intensity & density and the capability of anti - chemical attack and anti - permeability ; hybrid fiber reinforces the toughness of obviously acic by the means of anti - cracking effect of fiber with different sizes and different properties in the corresponding construction levels

    實驗結果顯示：鋼渣摻合料能顯著減緩水泥漿體水化速率，降低砂漿的水化溫升並延遲最高溫升時間；補償混凝土收縮，提高混凝土密實度，加強纖維與水泥石的界面粘結，增強混凝土力學性能，但不能明顯改善混凝土韌性。混雜纖維通過纖維的不同尺度與不同性質在相應的結構層次上產生阻裂效應，增韌鋼渣防滲抗裂混凝土；增加混凝土的破壞極限能，極大提高混凝土抗彎曲能力和韌性指數，改善混凝土脆性。
  10. By utilizing the finite element analytical calculation and impacting fatigue test, hybrid ratio and mode of hybrid of bicycle frame in hybrid fiber compound materials were determined, and the optimal design was carried out

    利用有限元分析計算和沖擊疲勞試驗，確定了混雜纖維復合材料自行車車架的混雜比、混雜方式，並進行了優化設計。
  11. Quantitative analysis method of cashmere, wool andtheir mixture fibers

    山羊絨綿羊毛及其混合纖維定量分析方法
  12. Quantitative analysis method of cashmere, wool and their mixture fibers

    山羊絨綿羊毛及其混合纖維定量分析方法
  13. Research on damping properties of hybrid fiber composites

    混雜纖維復合材料阻尼性能的研究
  14. This paper analyses the problem of concrete cracking and leakage, and set up the model of the middle or low - strength steel slag anti - cracking and impermeable concrete ( acic ) on the base of the analysis. the four principles of water permeable resistance character, volume stability character, toughness and anti - chemical corroded character have been put forward for raw materials selection and durability design of acic, acic is designed by the theory of composite material and the theory of fiber - reinforced, and two series of acic, such as fly ash series and steel slag series, have been manufactured by means of mineral admixture, hybrid fiber and chemical admixture. hydrating heat, macro - mechanics quality, durability and microstructure of the acic have been researched

    本文對中低標號大體積混凝土滲透開裂問題進行了研究，從混凝土自身結構形成與經濟角度指出大摻量粉煤灰與膨脹劑復合配製大體積混凝土的問題所在，提出採用鋼渣微細礦粉配製中低標號防滲抗裂混凝土的思路，運用復合材料理論設計中低標號防滲抗裂混凝土，提出了低水化熱、抗滲性能、體積穩定性、韌性和抗沖磨性能是中低標號防滲抗裂混凝土材料選擇和耐久性設計的主要原則，採用鋼渣微細粉復合混雜纖維、化學外加劑的技術路線，配製了適合於深水等特殊環境中的大體積中低標號鋼渣系列防滲抗裂混凝土，對其進行水化特性、宏觀物理力學性能、耐久性和微觀結構研究。
  15. The results show that the order from large to small of the early - age crack resistance of concretes with high content mineral admixtures is high performance expensive concrete with fiber > high performance concrete with fiber > high performance concrete with hybrid fibers > high performance expensive concrete with hybrid fibers > high performance expensive concrete

    結果表明，大摻量礦物摻合料混凝土的早期抗裂性大小順序為：纖維增強高性能膨脹混凝土纖維增強高性能混凝土混雜纖維增強高性能混凝土混雜纖維增強高性能膨脹混凝土高性能膨脹混凝土。
  16. Preparation of reinforcement of aramid fiber and fiberglass

    關于加固混凝土用混雜纖維復合材料耐久性的討論
  17. It is suggested in this paper that phenolic resin with three components and hybrid fiber were used to prepare clutch friction materials by cold - press process

    摘要提出採用三組份改性酚醛樹脂和混雜纖維冷壓工藝制備離合器摩擦材料。
  18. Experimental study on reinforced concrete extended beam strengthened with composite fiber reinforced polymer

    復合纖維抗彎加固混凝土外伸梁試驗研究
  19. Creation of saint - gobain technical fabrics, a group of affiliated companies having specific expertise in fabric making ( glass fiber, polyester, carbon, aramid, hybrid fibers combination )

    1999年:成立聖戈班技術織物部，組成該集團的分公司均以纖維生產為專長（玻璃纖維、聚酯纖維、碳纖維、聚酰胺纖維、混合纖維等） 。
  20. Conventional methods for fiber differentiation, which are often carried out by hand touch and eyeballing, have the disadvantages of low accuracy, bad robustness and inefficiency. therefore, developing a set of intelligent automatic analyzer for fiber quality inspection is of great significance

    傳統上對羊絨及其混合纖維的檢驗與測試多利用投影顯微鏡法，這種方法人為因素干擾大，準確率不高，且勞動強度大，因此開發一套羊絨和羊毛混合纖維自動檢測系統，對客觀評定纖維的品質及數量具有重大意義。
分享友人
分享到 Line

分享到臉書