測量容積的 的英文怎麼說

中文拼音 [cèliángróngjīde]
測量容積的 英文
bulkmeter
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Such trilateration is liable to rapid accumulation of azimuth error.

    這樣的三邊測量鎖的方位誤差容易迅速積累。
  2. Packaging - flexible carrier bags for the transport of various retail goods - general characteristics and test methods for the determination of volume and carrying capacity

    包裝.各種零售商品運輸用軟包裝袋.一般特性和測定容積和裝載量的試驗方法
  3. The vapor from the upper container is condensed, the condensate is collected and its volume measured.

    上面容器中的蒸氣冷凝，將凝結液集中並測量其體積。
  4. A metering tank is an elementary method of measuring volume flow.

    量筒是測定容積流量的基本方法之一。
  5. The three - order modulator has a 2 - 1 cascaded structure and 1 - bit quantizer at the end of each stage, the modulator is implemented with fully differential switched - capacitor circuits. and then, the discussion will begin by exploring the design of various circuit blocks in the modulator in more detail, i. e., ota, switched - capacitor integrator, quantizer, two - phase non - overlapping clock signal, etc., at the same time, these circuits will be simulated in spectre and hspice. at last, the whole cascaded modulator will do behavioral level simulation by matlab soft and simulink toolbox

    本論文中，首先介紹模數轉換器的各種參數的意義，以及一階sigma - delta調制器和高階sigma - delta調制器的原理;給出解決高階單環sigma - delta調制器不穩定性的方案，引入級聯結構調制器，特別針對級聯結構調制器中的失配和開關電容積分器的非理想特性進行詳細的討論;本設計的sigma - delta調制器採用2 - 1級聯結構和一位量化器，調制器採用全差分開關電容電路實現;同時對整個調制器的各個模塊進行了電路設計，包括跨導放大器、開關電容積分器、量化器、兩相非交疊時鐘等，並利用hspice和spectre模擬工具對這些電路進行模擬測試;最後，利用matlab軟體和simulink工具對整個級聯調制器進行行為級模擬。
  6. During the process of measuring compression ratio, the viscous fluid instead of burning gas is applied to measure the maximal volume. residual volume and working volume of the engine combustion cylinder respectively

    在壓縮比測量裝置中，採用粘性液體，代替發動機工作燃氣，分別測量出發動機燃燒工作室的最大容積、余隙容積和工作容積，方便地計算出發動機的壓縮比。
  7. Using the multiple volume expansion method, the co2 content is determined at two different volume expansions of the measuring chamber

    使用多次容積膨脹法，測量池在兩次不同的膨脹中測定co2含量。
  8. Metallic powders. determination of apparent density. part 2 : scott volumeter method

    金屬粉末.表觀密度的測定.部分2 :斯可特容積測量法
  9. Standard test method for resin solution dilutability by volumetric gravimetric determination

    容積重量測定法測定樹脂溶液稀釋度的標準試驗方法
  10. Nuclear energy - measurement of environmental radioactivity - air - determination of the volumic activity of iodine in the atmospheric environment

    核能.環境放射性的測量.空氣.大氣環境中碘容積活性的測定
  11. Measure the space where the existing electric water heater now sits ( including necessary plumbing, venting and gas connections ) and note its existing tank size

    測量現有的電熱水器所佔有的空間（包括必要的管道，通風和燃氣連接） ，注意現有的熱水器容積大小。
  12. Cereals - determination of bulk density, called " mass per hectolitre " - reference method

    穀物.容積密度"百升質量"的測定.參照法
  13. Passenger cars - luggage compartments - method of measuring reference volume

    乘用車行李艙標準容積的測量方法
  14. Determination of uncertainty for volume measurements made using the gravimetric method

    採用重力測量法測定已測容積的不準確度
  15. Normally gravimetric method will be used for volumetric determination at the capacity of 20 l or below, whilst volumetric method will be used for measurements above 20 l

    重量分析測定法一般用於測定20公升或以下容積的容量，而容積法則用於測定20公升以上容積的容量。
  16. Standard test method for measuring maximum functional wet volume of utility vacuum cleaners

    測量通用真空吸塵器最大功能濕容積的測試方法
  17. Liquid hydrocarbons. dynamic measurement. statistical control of volumetric metering systems

    液態烴.動態測量.容積式計量系統的統計控制
  18. Standard test method for determining the volume of bulk materials using contours or cross sections created by direct operator compilation using photogrammetric procedures

    用斷面或用由攝影測量學過程直接操作者應用產生的交叉部分測定散裝材料容積的標準試驗方法
  19. Standard specification for laboratory glass volumetric apparatus

    實驗室玻璃容積測量器具的標準規范
  20. The volume of the test volumetric vessel is determined from the number of " dumps " of the standard measure required to fill the test measure

    容積法則需一個標準（經校正）量器，由填滿測試量器所需傾倒標準量器的次數可測定測試容器的容量。
分享友人
分享到 Line

分享到臉書