測量用電橋 的英文怎麼說

中文拼音 [cèliángyòngdiànqiáo]
測量用電橋 英文
measuring bridge
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  • 用電 : electricity utilization
  1. This measurement amplifier with relay outputs works as a uniform voltage amplifier for strain gauge measuring bridges

    這款測量放大器帶有繼電輸出，它像恆定電壓放大器那樣工作，用於應變測量電橋。
  2. The bonded-foil gage monitored with a wheatstone bridge has become a highly perfected measuring system.

    用惠斯登電橋監測的粘貼箔式應變片已成為高度完善的測量系統。
  3. The bonded - foil gage monitored with a wheatstone bridge has become a highly perfected measuring system

    用惠斯登電橋監測的粘貼?箔式應變片已成為高度完善的測量系統。
  4. In the paper, through the calibration test of ground load, the relationship between outputs of electrical resistance of strain gauges and the external load applied on the structure has been gotten, and then the load history can directly be deduced from the measured strain history. so the fatigue load can be compiled

    本文所建立的應變法實測疲勞載荷，其主要方法是通過進行地面加載標定實驗，確定所設計應變電橋輸出量與結構上作用的外載荷之間的關系，再由實測應變歷程直接得到載荷歷程的方法。
  5. Loss angle measuring bridge

    損耗角測量用電橋
  6. This paper introduces the initiation principles and c alculates the burst current of bridge foils that is measured by rogofiski coil, a nd the results are consistent with those computed initiation model. this s hows the validity of measurement results and the accuracy of experimental models

    介紹了橋箔起爆機理，計算了爆發電流，採用羅果夫斯基線圈對橋箔的爆發電流進行測量，其結果與計算值符合得很好，說明了橋箔起爆模型的準確性和測量結果的有效性。
  7. Abstract : this paper introduces the initiation principles and c alculates the burst current of bridge foils that is measured by rogofiski coil, a nd the results are consistent with those computed initiation model. this s hows the validity of measurement results and the accuracy of experimental models

    文摘:介紹了橋箔起爆機理，計算了爆發電流，採用羅果夫斯基線圈對橋箔的爆發電流進行測量，其結果與計算值符合得很好，說明了橋箔起爆模型的準確性和測量結果的有效性。
  8. - the focal point of this paper is studying the problem of cargoes ? weight measurement, besides the component of mechanical system, the component and control of electric - control system, the full - digital dc speed adjustment system and the hardware and software design of plc control system. this paper puts forward the project of current static measurement method and corrects it with acceleration dynamic measurement

    本文除分析介紹了集裝箱橋吊的機械繫統組成、電控系統的組成及控制、全數字直流調速器以及plc控制系統的軟硬體設計外，重點研究了集裝箱裝卸橋中的貨物稱重問題，提出了應用電流靜態測量法的稱重方案，並且採用了加速度動態測量法對其進行動態校正，在實際應用中取得了令人滿意的效果。
  9. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  10. It will effect the system in safety and running economy directly > test of tradition past the method is an usage to give or get an electric shock the bridge method or direct current to press to decline the method to proceed to measure, and the electric current for producing of is only in the ma class which ca n ' t broke through the oxidize surface

    高壓斷路器是電力系統中最重要的控制和保護設備之一，它對系統的安全、經濟運行有著直接的影響。以前傳統的測試方法是使用電橋法或直流壓降法進行測量，所產生的電流僅在ma級，不能擊穿觸頭氧化膜。
  11. An experimental study of the measurement of resistae by applying unequilibrium electric bridge

    應用非平衡電橋測量電阻實驗的研究
  12. Dc bridges for measuring resistance ; amendment 2

    電阻測量用直流電橋.第2次修訂
  13. D. c. bridges for measuring resistance

    電阻測量用直流電橋
  14. They use a bridge to measure the impedance of the transducer

    他們用電橋來測量傳感器的阻抗
  15. To the concrete two - phase flow - crude oil, its temperature, speed and capacitance value are measured by flat capacitance sensors, fluke rlc instrument and other auxiliary appliance. assessing the characters of crude oil and predicting the solidifying point is the result of using fuzzy information arithmetic

    針對具體的兩相流? ?原油，用平板電容器、 fluke精密電橋和其它輔助傳感器分別測取了原油的熱處理溫度、降溫速率和電容值，利用模糊信息融合演算法對測量值進行處理和尋優，從而進行原油熱處理的綜合評定和凝點的在線預測。
  16. The measurement of deflection of a bridge is crucial constituent part in the monitoring of bridges. the majority of existing methods about bridge deflection measurement can not accomplish the real - time and long - range measurement. the ultrasonic method based on connected pipes still has shortage in precision and speed of measurement. to satify the need of deflection measurement of the dafosi bridge of changjiang river, an opto - electronic measurement method is to be used to improve on the method based on connected pipes. furthermore, we will design an automatic opto - electronic deflection measurement system based on connected pipes which can be practised in the long - span bridge

    大型橋梁的安全監測具有重要的現實意義，而撓度監測是橋梁監測的一個重要的組成部分。目前現有的許多撓度測量方法還不能實現實時遠程監測，已有的連通管式超聲波法還存在著精度較低，測速慢等不足。針對大佛寺長江大橋撓度測量的需要，在此採用精度較高的光電測量方法結合連通管的優點加以改進。
  17. In this paper, a kind of improved practical active linear bridge circuit with platinum resistor is used to eliminate the error mentioned above, and the precise temperature measurement can be made

    本文採用鉑電阻改進型實用有源線性化橋路克服了上述誤差，實現了高精度的溫度測量。
  18. In the pressure characteristic test, a new method of testing pressure difference is brought out. with an entire bridge circuit and two pressure sensors, the structure is simple but the result is of high precision

    電液伺服閥壓力特性實驗中，提出利用兩只壓力傳感器通過全橋電路測量差壓的新方法，該方法硬體結構簡單，測試精度高。
  19. Based on the testing principle of wheatstone bridge, a simple testing system is set up with two cascaded amplifiers and two cascaded butterworth lowpass filters. the varying voltage is tested by the system as the pressure is changed. experiment data are obtained, which also prove the feasibility of the design and the process flow

    5 .基於惠斯頓電橋的測量原理，利用兩級放大電路和兩級巴特沃思低通濾波電路搭建了一簡單的測試電路系統，成功地檢測出了輸出電壓的微小變化值並得出了一些初步的實驗數據，驗證了晶元設計和工藝流程的正確可行性。
  20. And then, a method of load - flow low - pressure measurement was proposed in the light of the hydraulic - resistance theory of servo valve. the validity of the method was proved by the experimental results. therefore, the measurement of the characteristic of load - flow and no - load flow can be realized by using this method

    然後根據電液伺服閥的液橋理論提出了一種負載流量低壓測量方法，在所開發的測試系統上，利用電液比例閥模擬流量測量裝置對所提出的方法進行了試驗驗證，實現了利用低壓流量計和壓力傳感器進行電液伺服閥負載流量特性和空載流量特性的測量。
分享友人
分享到 Line

分享到臉書