測量的誤差 的英文怎麼說

中文拼音 [cèliángdewùchā]
測量的誤差 英文
absolute gravimeter
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 的 : 4次方是 The fourth power of 2 is direction
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  • 誤差 : error
  1. The slight difference in response time of 1 msec would not be perceivable, and is likely due to measurement variability

    響應時間的差異只有1 msec ，可以無需考慮，而且可能是由於測量的誤差引起的。
  2. Based on the error theory of point measurement are the identifying of the error range set, sketch of the error ellipse, analysis on displacement of the monitoring sites and error detection, providing a fundamental theory infrastructure for dynamic assessment of surface displacement and gray prediction

    根據點位測量的誤差理論，確定定誤差值域范圍，繪出誤差橢圓；對各監測點進行位移與誤差判別分析，為地表位移動態分析和灰色預測提供理論基礎。
  3. In this section, you can set a limit to the astrometric and photometric residuals of the reference stars

    在這里，你可以設置一個有關參考星的天文測量和光度測量的誤差值。
  4. In the thesis, i introduce the theory and application of gps carrier phase measurement, analyze the errors in the observation of gps signal, study the ways to reduce these errors, specially for the error caused by multipath

    論文介紹了gps載波相位測量技術的原理和應用，分析了gps觀測量的誤差，研究了減小和消除各種誤差的方法，重點是減小多徑效應的影響。
  5. Algorithms of insar data processing are also key factors, which related directly to the quality of dem and differential interferometric products, so it is necessary to develop advanced data processing algorithms and evaluate the accuracy of sar interferometry

    數據處理演算法的優劣，直接影響到所提取的dem及差分干涉測量產品的質量。因此，發展更為完善的數據處理演算法及對干涉測量的誤差進行評估，是目前干涉測量研究的必需，也是干涉sar遙感創新研究的需要。
  6. On the other side, measuring errors of grounding resistance and solution of current voltage electrodes reversing has been compared with horizontal two layers and vertical delaminating ( three layers soil )

    比較分析了電流電壓極反向布置、在水平雙層和垂直分層或三層土壤結構中接地電阻測量的誤差和解決辦法。
  7. Based on analyzing the recent research status and future developments of error compensation techniques for cmm in the world, non - rigid errors of cmm are analyzed by means of the stress distortion analysis for components of cmm bridge - type cmm, and a new idea for die error compensation of high precision cmm is provided

    本論文在分析目前國內外三坐標測量機測量誤差補償技術研究的現狀和發展趨勢的基礎上，通過對坐標測量機構件的受力變形建模分析，詳細研究了測量機非剛性效應運動誤差，為高精度坐標測量機誤差補償技術奠定理論基礎。
  8. Testing and error analysis of plastic injection molding machine clamp force

    注塑機合模力的測量及誤差因素分析
  9. The results show that these algorithms for attenuation correction can work well in the valid range and their effects on attenuation correction are almost identical. when attenuation is strong or measurement error of real echo is large, however, the result from the h - b algorithm for attenuation correction is not good

    結果表明：在有效的訂正范圍內，幾種訂正方法均能得到很好的訂正，並且訂正效果幾乎保持一致，但h - b演算法在衰減作用很強或實際回波測量值誤差很大時，其訂正結果就變得不可靠了，從而造成訂正能力下降。
  10. The thesis aims at a muliti layer residence project of in jinan baihua small region. according to the heating system of the separating doors in this building controlled by heat meter measurement, it studies the feasibility of the various abstracted cosfficient of the communal heating load calculation. also it studies the difference from the practice. according it, we can draw conculution that the communal heating load calculation are abstracted and allocated averagely according area and added to the variable heating load calculation, taking for the charging heating load calculation

    本文將濟南市百花小區的一棟多層住宅為研究對象，根據該住宅室內分戶控制按熱表計量的供暖系統，研究其耗熱量中公共耗熱量各項提取系數的可行性及其與實際測量的誤差，得出將公共耗熱量提取出來，然後按面積分攤到各住戶的可變耗熱量中，作為計費耗熱量的合理性結論。
  11. The error in measuring the moment of inertia using three - string pendulum

    用三線擺方法測試物體轉動慣量的誤差問題
  12. Error and quality control in clinical electrolyte analysis measurements

    臨床電解質分析測量的誤差與質量控制
  13. Based on the difference of measuring errors between spectrum and a single pulse, the article introduces a procedure which can improve the specification of non - linearity of commercial adc for spectrum measurement without channel - width - everaging circuit

    摘要根據放射性能譜測量的誤差並不等於對單個脈沖測量的誤差的特點，提出一種先測出模數變換器的道寬，然後利用軟體方法進行道寬均勻的技術。
  14. Both can improve the performance of state estimation. due to former condition, the method that the power equations are resolved directly to decide the placement is applied. the method, which reduce covariance errors of the measurements, is adopted under the later condition

    前者採用使系統功率方程直接可解的方法確定pmu的測點布置；後者採用減小狀態估計量測量的誤差方差的方法宋確定pmu的測點布置。
  15. Those features have not been archived in domestic products of the same type, the two parameters of which are manually determined and the testing results could be quite different from person to person. the design discussed in the paper solved the problem by removing the factor of the interferences from the operators

    目前國內所有超生探傷儀對這兩個參數都是人工標定，使得測量結果因人因時而不同，本設計對這兩個參數的自動標定使得人為測量的誤差大大減小。
  16. Abstract : the paper proposes a mathematical model of a / d converter with quantizing error, nonlinearity and differential nonlinearity errors for computer simulation, and based on the model, the errors caused by voltage change, current change and phase change in the power measurement are analyzed by computer simulation for both the asynchronous and quasi - synchronous sampling algorithms

    文摘:本文提出了具有量化誤差、非線性誤差和微分非線性誤差的a / d轉換器的數學模型，在該數學模型的基礎上，模擬分析了非同步采樣法、準同步采樣遞推演算法各種情況下的誤差，包括功率測量中電壓線性、電流線性、相位變化誤差及電壓測量的誤差。
  17. Several misunderstandings a bout measuring the outer funace wall temperature, and measures for decreasing the measurement error have been pointed out, and two measuring point structures for scientific and reasonable measurement of outer furnace wall temperature being recommended

    同時，指出了幾種爐外壁溫測量的誤解和減小測量誤差的措施，並推薦了兩種科學合理的壁溫測點結構。
  18. According to the measured values of the joint angles and the end - effector positions, jacobian matrix is calculated, and errors between the desired and the measured positions of the end - effector are exported to the least square method to determine the compensation for the dimensional parameters of the robot

    通過機器人關節角和末端手爪位置的測量數據，計算雅可比矩陣以及手爪位置理論值和實測值的誤差，採用最小二乘法對機器人的尺寸參數進行補償量的計算。
  19. The monitoring error analysis of thermoluminescence detectors and the quality control

    熱釋光探測器在個人劑量監測中的誤差分析及質量控制
  20. In order to reduce the adverse influence of nlos error to location performance, this algorithm firstly makes initial mobile position estimation by mean tdoa / toa measurements, then estimates nlos error within tdoa / toa measurements by parameters of tip 1 channel model, smoothes and reconstructs tdoa / toa measurements, and finally utilizes two step wls computation. the application of this algorithm under different cellular environments is also discussed and its effectiveness is demonstrated by simulation results. finally, the basic location method, location method implementation, network architecture, signaling protocol and interface, and location procedures of wcdma network mobile location are analyzed

    百臼主回大學槽士扭允生攀幢伍丈第v頁接著，通過對tdo咖a測量值誤差的分析，本文提出了一種首先利用tdo咖a平均測量值對移動臺位置進行初始估計，並利用tipi通道模型參數估計出thoafl 』 oa測量值中nlos誤差的大小，然後對tdo … a測量值進行平滑與重構，再採用兩次wls計算，以降低nlos誤差對定位性能不利影響的的定位精度提高演算法，討論了這種演算法在蜂窩網路不同環境條件下的具體實施方法，通過詳細模擬驗證了這種演算法的有效性。
分享友人
分享到 Line

分享到臉書