測量的頻率 的英文怎麼說

中文拼音 [liángdebīn]
測量的頻率 英文
frequency of measure
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • : 4次方是 The fourth power of 2 is direction
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  • 頻率 : frequency; rate
  1. In consideration of the crises of both the industrial water and the domestic water in the estuarial areas of the yangtze river caused by the decrease of the channel runoff and the intrusion of the sea water during the dry season in dry year, the concept, method and planning framework of the water resources allocation for the areas mentioned above along the main stem of the river are put forward herein based on the preliminary prediction of the future water demands by taking the water resources allocation therein during the dry seasons as the actual case in combination with the status quo of the water environment and water resources utilization concerned

    摘要針對枯水年枯水季,因河道徑流較少,鹽水入侵和強度顯著提高而引起長江河口沿岸地區生產生活用水安全,文中結合長江口地區水資源利用和水環境現狀,以大通以下長江幹流地區在枯水季水分配為實例,在初步預未來河口地區水資源需求基礎上,提出長江口地區水資源配置思路、方法及方案框架。
  2. A way of frequency measure based on isa - bus interface

    總線介面方法
  3. Intelligent electricity quantity concentration display instrument is a kind of intelligent instrument used to measure combined parameter of ac electricity quantity, which can simultaneously measure each phase electricity parameter in the tri - phase ac loop such as voltage, current, active power, reactive power, apparent power, power factor, frequency, active kilowatt hour, reactive kilovolt ampere - hour and so on

    智能電集中顯示儀是一種用於交流電綜合參數智能儀表,它可以同時三相交流迴路每一相電壓電流有功功無功功視在功因數有功電度無功電度等參數。
  4. The method can be used in the measurement of periodic and nonperiodic signal. according to the high accuracy and fixed gate - time measurement method, based on the multiple period synchronization method, the high speed, high accuracy and continuous frequency measurement is accomplished

    將其再與一種從多周期同步法發展而來高精度、定閘門法相結合,從而實現了高速、高精度、連續,這非常適合非傳感信號
  5. Preferred frequencies, frequency levels, and band numbers for acoustical measurements

    聲學優先選擇級和帶數
  6. This method of diesel engine fault diagnosis is feasible theoretically. while the fault diagnosis system using this method is rare, just because the crankshaft instantaneous angular acceleration measurement is demanding, such as, good frequency response, high precision

    這種柴油機故障診斷方法在理論上是可行,但目前這種成型系統不多,究其原因是曲軸瞬時角加速度需要系統具有良好響應特性與高精度。
  7. Backed up by the soplat theory based on particle kinematics, the second chapter of this paper presents with analysis and simulation of several single observer passive measurement models, which uses such relative movement parameters as bearings changing rates and centrifugal acceleration information on the basis of bearings measurements. in the third chapter, the observability of location respectively using bearings and its changing rates information and centrifugal acceleration information is analyzed, and its observable condition is got. the fourth chapter puts forward the modified covariance extended kalman filtering ( mvekf ) against the defect of traditional extended kalman filtering ( ekf ), whose performance is simultaneously compared in the chapter with the performance of ususal tracking algorithm such as ekf, mgekf, iekf by computer simulation

    在近年來提出基於質點運動學原理單站無源定位理論基礎上,本文第二章提出了幾種在角度基礎上增加角度變化及相對運動離心加速度等運動學參數單站無源模型,並對它們進行了分析和模擬;第三章分別對利用角度及其變化信息定位和利用離心加速度信息定位可觀性進行分析並得到了相應可觀條件;第四章針對傳統擴展卡爾曼( ekf )方法缺點,提出了一種修正協方差擴展卡爾曼濾波( mvefk )方法,並將其和ekf 、 mgekf 、 iekf等常用單站無源定位濾波方法進行了性能模擬比較;第五章通過引入雷達機動目標跟蹤方法和模型,提出了利用角度及其變化對機動輻射源跟蹤多級噪聲自適應方法和imm方法;第六章主要對角度變化和離心加速度參數獲取技術進行了研究,提出了幾種高精度脈沖序列多普勒變化方法。
  8. In the end, the system experiments were conducted, and the results show that the system can be used for short - distance ranging

    最後採用延遲線閉環系統聯調,實驗結果表明所設計距方案能夠用於近距距離,差信號反映了距離信息。
  9. Based on that penetration depth of eddy current is theoretically different for different operationalfrequency, the flaw depth quantitive measurement method based on the characteristicalfrequency was expounded. to find the best testing model and position, it analysed and discussedthe factors which effected measurement. the mathematic relationship between the specialfrequencyand flaw depth was established to realize the accureate measurement of flaw depth. it primarily researched the technology of alternating current magnetic field leakage testing ( ac - mfl ) in our country

    在利用掃描技術基礎上,提出了基於拐點渦流檢缺陷深度方法,對影響多種因素進行了分析和實驗研究,得到了最佳試位置和試方法,建立了拐點和缺陷深度關系,為深度提供了新途徑。
  10. To avoid the serious electromagnetic interferer, the analog signals are transformed to frequency pulses which are transferred to the kernel of the system. in the measure of the groove voltage, the method of float - ground is adopted to avoid the high common signal and the range switch circuit is designed to solve the conflict of the wide dynamic range and the high precision. least square curvefit is adopted to reduce the system error

    鋁電解生產現場電磁干擾非常嚴重,為此我們將需要模擬信號就近轉換為脈沖后再傳送到控制核心;採用浮地接入方式消除槽電壓信號中共模成分;設計了程自動切換電路以解決槽電壓動態范圍寬和精度高矛盾;用最小二乘法進行曲線擬和以降低系統誤差。
  11. Measuring frequency of received signal by a spectrum line ratio method

    譜線比值法接收信號
  12. Supported by heilongjiang province natural science foundation projects " research on the errors mechanism of time division a. c. power measurement " ( no. e9719 ), " research on theory of analog digital mixed sampling power energy measurement " ( no. e01 - 15 ) and foundation for university key teacher by the ministry of education " the research on the low audio frequency a. c. power measurement smart instrument " ( no. 1087 ), in this dissertation it is made that a systematic and deep study on power measurement model errors and instrument errors about analog sampling, digital sampling and mixed sampling measurement, and fully experiments about mixed sampling measurement

    本學位論文在黑龍江省自然科學基金資助項目「時分割交流功原理誤差產生機理理論研究」 (編號: e9719 ) , 「模擬數字混合採樣功與電能理論研究」 (編號: e01 - 15 )和教育部高等學校骨幹教師資助計劃項目「中電功智能儀器研製」 (編號: 1087 )資助下,以電功模擬采樣、數字采樣和混合採樣方法為對象,對電功原理誤差和儀器誤差進行了系統和深入理論研究和有關實驗研究。
  13. This paper deals with the method of stress wave to measure the elastic modulus, loss modulus and their dispersion relationships against frequency of materials

    摘要用應力波方法建立一維木材動彈模色散關系方程,並和分析了兩種木質材料動彈模色散關系。
  14. Research of high - speed cinema photograph frequency in photoelectric tracker

    光電跟蹤設備高速攝影機攝影研究
  15. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身特點設計了單元,根據pid調節各個環節特點,以及調速器動態特性、靜態特性對實時性和精度要求不同,利用s7 - 200plc基本單元中內置高速計數器以及相應外圍放大整形、分電路,實現了水輪發電機組;在軟體上,對微機調速器整個程序框架、並聯pid離散化過程進行了分析,選用改進pid演算法實現了變參數、變結構pid調節模式;調速器機械液壓隨動系統具有步進電機電液轉換元件,採用五相反應式步進電機,根據其驅動特性設計了變調壓驅動器,實現plc與步進電機驅動器之間數字介面。
  16. Pulse step return loss from measurement in the frequency domain using the inverse discrete fourier transformation

    反向不連續傅里葉傳輸區域內脈沖分步回損
  17. According to the high dispersedness and low precision of measurements when using the traditional time difference method in small diameter and low flow rates conditon, this paper brings forward a new method based on high - speed data acquisition technique. the time difference comes out accurately with high resolving ability of time by using the method and the signal processing algorithms. the developed ultrasonic detection system is composed of two ultrasonic detectors, a transmitting and receiving ultrasonic unit, a high - speed data acquisition unit and a computer

    本文針對傳統時差法在小管徑、低流速時,具有時結果分散性大、精度受計數影響大等不足,創造性地把高速數據採集技術應用在超聲波流、壓力上,用信號處理演算法求時差,使時差成為一個統計,有效地克服了超聲波傳統時差法精度差、不能小管徑、低流速流體流缺點,提高了時差解析度和精度。
  18. Impedance, reflection coefficient, return loss, and vswr test procedure measured in the time and frequency domain for electrical connectors, cable assemblies or interconnection systems

    電連接器電纜附件或互連系統在時間和域中阻抗反射系數回程損耗和vswr試驗程序
  19. In order to realize the flaw identification of link - thread bolt, it establised the flawidentification method which depended on the local maxima abstracted from detecting signal. itsorted all flaws into three kinds, and assayed the characteristics of signal and expounded thecriterion for each kind of flaw

    綜上所述,本文在研究場掃描技術基礎上,利用同一硬體系統實現了渦流檢和交變漏磁檢缺陷識別和深度,同時也實現了螺紋緊固件缺陷檢
  20. The improved method is used to predict the existence and the approximate location of the crack by using relative changes of frequencies and modal shapes of the damaged platform, in the absence of parameters of the intact structure

    提出了利用2次變化檢側方法,在無未損傷模型參數情況下也可以發現損傷存在,並對損傷進行初步定位;同時提出利用不完全振型相對變化,判斷某些構件斷裂。
分享友人