測長干涉儀 的英文怎麼說

中文拼音 [cèzhǎnggānshèyí]
測長干涉儀 英文
length-measuring interferometer
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 干 : 干Ⅰ名詞1 （事物的主體或 重要部分） trunk; main part 2 （幹部的簡稱） short for cadre Ⅱ動詞1 （做...
  • 涉 : Ⅰ動詞1 （徒步過水 泛指從水上經過; 渡） wade; ford 2 （經歷） go through ; experience 3 （牽涉） i...
  • 儀 : 名詞1 （人的外表） appearance; bearing 2 （禮節; 儀式） ceremony; rite 3 （禮物）present; gift 4 ...
  1. It is apparent that the michelson interferometer can be used to make extremely accurate length measurements.

    很明顯，可以用邁克耳孫干涉儀進行極精確的長度測量。
  2. The short - baseline interferometer ’ s angle measurement accuracy is influenced by phase difference measuring accuracy, the base length measuring accuracy, the system operating wavelength ( frequency ) and so on, the article analyzes the existing theory, and emphatically analyzes the influence of base length measuring accuracy to the precision of angle measurement

    短基線干涉儀測角精度受相位差測量精度、基線長度測量精度、系統工作波長（頻率）測量精度等因素的影響，文中，在對原有理論進行分析的基礎上著重分析了基線長度測量精度對系統角度測量精度的影響。
  3. Therefore, the three fundamentals required to obtain high precise measurements are : 1 ) frequency stability and frequency difference stability of the double - frequency laser source as well as the stable equivalent length of bore ; 2 ) the measuring beam and the reference beam are placed very co - axially ; 3 ) capability of recording the sub - division of the period of phase change and a reversible counter system

    因而干涉儀系統達到高精度的基礎是：頻率及頻差穩定的雙頻激光源、穩定的等效腔長；測量光與參考光合光後有很高同軸度的光路結構；能可靠記錄相位差變化周期數的細分及可逆計數系統三部分。
  4. Based on the principle of michelson interference a new integrative experiment apparatus to measure linear expansion coefficient and yang ' s modulus of metals is designed and manufactured primarily

    摘要在邁克耳孫干涉原理的兩條干涉光路中，分別設置可以精確測量金屬絲的拉伸長度和金屬棒熱膨脹伸長量的裝置，從而設計出一種可以分別測量金屬楊氏模量和線脹系數的新型綜合實驗儀器。
  5. The conclusions are as follows : the ultrasonic intensity is proportion to the laser intensity ; the ultrasonic induced by a laser line source has much more advantages than by a laser point source, such as stronger energy, higher snr, more directivity and shape ; the intensity of cfpi ' s output signal is linear with ultrasonic vibration velocity, and is effected by incidence angle and scattered angle ; snr will increase by reducing cfpi ' s bandwidth, reducing incidence angle, increasing cavity ' s length and reflectivity

    在分析點光源激勵聲表面波機理的基礎上，求出了線光源激勵的超聲振動的位移表達式，發現線光源激勵的近場區表面波具有波形好，信噪比高，指向性好，幅度強等特點。通過理論推導，得出共焦fabry - perot干涉儀的輸出光強除了與樣品表面的振動速度成正比，並與入射角和散射角有關；適當減小cfpi的帶寬，增加腔長，增大鏡面反射率，或者減小檢測入射角都可以提高系統的信噪比。
  6. It can be mounted on the three - coordinate measurement machine or other length measurement machine like interferometer to take measurement

    測頭不僅可以安裝在三坐標測量機上，也可以結合其它的測長儀如雙頻激光干涉儀進行表面形狀測量。
  7. The theoretical analysis shows that mz - ifog can be used to detect the rotation rate of moving objects. a systematic analysis of transfer characteristics of mz - ifog is made. performance - limiting factors, including the path - length difference, the disturbance of temperature fluctuation and stress from working environment, the quality of light source, are all discussed along with methods to reduce their effect on the output signal

    本文用系統的方法分析了mz型干涉式光纖陀螺儀的光傳輸特徵，指出了其較大的非互易性因素-臂長差的存在，分析了工作環境因素（溫度，應力） 、光源質量（輸出光束中心波長、光功率波動及偏振態波動）對系統工作性能的影響，並指出了減少系統非互易因素、抑制噪聲、提高檢測穩定性的措施。
  8. Very long baseline interferometer

    甚長基線干涉測量儀
  9. 2. based on interoferometric technique, a parasitic interference configuration was introduced to transpose the wavelength - shift signal into phase - shift signal ; the strains were demodulated by measuring the phase change of the signal with a phase - meter

    利用干涉技術，採用寄生干涉結構對傳感光柵的反射譜進行波長解碼，用相位計觀測波長漂移引起干涉儀兩臂間相位差的變化，進而監測作用在傳感光柵上的待測應變量。
  10. This research is aim at putting forwarding laser wavelength scanning interference testing method. processing and analyzing instantly - read interference pattern corresponding with continuous varying wavelength, the method overcomes the following disadvantage. for example, the longer referenced and measuring optical circuit in big - scale high - accuracy asphere testing, and the sensitive interferential system to the disturb, such as the oscillation of worklable, dithering of air, and so on

    研究的目的主要是針對大型高精度非球面面形檢測中干涉儀的參考光路和測量光路較長，干涉系統對工作臺振動和空氣抖動等外界干擾因素的影響敏感，干涉圖不穩定等問題，提出了激光波長掃描干涉測試方法，該方法通過對瞬間讀取的、與連續變化波長對應的干涉圖的處理和分析，克服了上述缺點，為大型高精度非球面的檢測提供了一種適用的方法。
  11. The paper studies mainly a new kind of measure method of aspheric surface - laser wavelength - scanning interference testing. this research is aimed at putting forwarding laser wavelength scanning interference testing method. processing and analyzing instantly - read interference pattern corresponding with continuous varying wavelength, the method overcomes the following disadvantage : the longer referenced and measuring optical circuit in big - scale high - accuracy asphere testing and the sensitive interferential system to the disturb, such as the oscillation of worktable, dithering of air, and so on

    研究的主要目的是針對在大型高精度非球面面形檢測中干涉儀的參考光路和測量光路較長，干涉系統對工作臺振動和空氣抖動等外界干擾因素的影響敏感，干涉圖不穩定等問題，提出了激光波長掃描干涉測試方法，該方法通過對瞬間讀取的、與連續變化波長對應的干涉圖的處理和分析，克服了上述缺點，為大型高精度非球面的檢測提供了一種適用的方法。
  12. Standard test method for in - plane length measurements of thin, reflecting films using an optical interferometer

    用光學干涉儀測量反射薄膜共面長度的標準試驗方法
  13. Laser interferometer systems are now in widespread use in engineering metrology for the measurement of length, displacement and other dimensional quantities

    在工程計量學上，激光干涉儀已被廣泛使用於測量長度、位移及其他與長度有關的量值。
  14. This thesis describes a all fiber optic accelerometer based on t - g double beam interferometer, the whole system include a coherent source whose wavelength is 1310nm, a flexural optic fiber disk act as sensing unit, photodetector, piezoelectric ceramic act as a phase modulator and signal processing circuit. the all fiber optic accelerometer described in the paper has many desirable engineering features which include : broad frequency response ; high sensitivity to measurands ; antielectromagnetic interference and small size

    本課題研究的是一種基於泰曼-格林（ t - g ）雙光束干涉儀原理的光纖加速度計，系統主要包括：中心波長為1 . 31 m的ld相干光源、起傳感作用的光纖柔性盤、光探測器（ pin ） 、相位調制用的壓電陶瓷以及信號處理系統。
  15. Dual frequency laser interferometer is the best precise and longest instrument to measure presently. with its good characteristic, the dual frequency laser interferometer is used in many fields, especially in the precise measurement of the long displacement and dimension

    雙頻激光干涉儀是目前精度最高、量程最大的長度計量儀器，以其良好的性能，在許多場合，特別是在大長度與大位移的精密測量中獲得廣泛應用。
  16. Experiments have demonstrated that, under the condition of constant temperature ( 20 ), the frequency error of double - frequency laser interferometer with two longitudinal modes could be controlled within 10 " 9 even with conditions such as with cool or hot air blowing, it can still be kept within 10 " 7. self - organised fuzzy control methods can be realised in a single - chip processor which contains fuzzy optimisation and self - organisation functions. the above - mentioned system possesses the following advantages : simple

    / znl （式中c為光速， l為諧振腔長， n為空氣折射率，其值約790mhz ） ，原理上對目前可能要求的測量速度都能滿足;它發出的光為一對互相垂直的線偏振光，與塞曼型雙頻激光干涉儀相比，它不用外加軸向磁場及1 / 4波片，因此結構簡單，造價低廉。
分享友人
分享到 Line

分享到臉書