溫度降低 的英文怎麼說

中文拼音 [wēndùjiàngdī]
溫度降低 英文
fall of temperature
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 溫度 : [物理學] temperature
  • 降低 : reduce; cut down; abate; debase; drop; lower; lessening; reducing; reduction; depression; tarnish
  1. The calculagraph will be cleared if the outdoor machine temperature is higher than defrost start temperature when timing, and it begins to time again when the outdoor machine temperature is lower than defrost start temperature next time

    在計時過程中如果外機溫度高於「化霜啟動溫度」則清除計時器，到下次外機溫度降低到「化霜啟動溫度」以下時從頭開始計時。
  2. A new technology for improving hot blast temperature and decreasing fuel consumption with high emissivity coating on the regenerator of blast furnace ( bf ) hot stove were introduced

    摘要介紹一種可以進一步提高熱風爐熱風溫度，降低燃料消耗的新技術。
  3. As compared with the pressure of carrier gas, the subatmospheric pressure is more favourable condition to atomize the hydride, so the atomization temperature was lower ( about 650 )

    由於硒化氫的原子化是在負壓下完成的，它將比常壓或載氣壓力下更有利於氫化物的原子化，因而使硒化氫原子化的最佳溫度降低。
  4. Thermosetting powder coating of low - temperature curing type is a newly - developed powder coating which is used on the things that are not suitable for high - temperture baking. this type of powder coating opens up wider application by lowering curing temperature to 108 - 130. it can be used for surface coatings on such things as flaw detectors, auto water tanks, springs, electrical appliances with coils, instruments, equipment with tin welding seams. it can also be used on the products made of aluminum and magnesium materials, glass, plastics and wood etc

    低溫固化型粉末塗料是針對那些不宜高溫烘烤的產品，而最新研製的新品種，它不僅具備一般粉末塗料的特徵，而且可以把固化溫度降低到108 - 130 ，從而拓寬了粉末塗料的應用領域；適用於擦傷機械、汽車水箱、發動機、彈簧、線圈電器、儀器儀表、錫焊條接縫設備、鉛鎂材質、玻璃、塑料、木材等製品的表面塗裝。
  5. It has a good compensation to shrinkage, and can improve the anti - cracking and anti - penetrating performance of concrete. it is often added to concrete to produce expanding concrete or the anti - cracking and anti - penetrating concrete, which are widely used in such engineering as waterproofing, anti - penetrating, mending etc. the expansion admixture include at present sulphoaluminate such as uea, ea - l etc ), calcium oxide, and some composite expansion admixtures

    混凝土膨脹劑在普通混凝土中可抵消干縮或溫度降低引起的拉應力，起到良好的補償收縮作用，能提高混凝土的抗裂防滲能力，常用於配製膨脹混凝土或抗裂防滲混凝土，廣泛地應用於防水、抗滲、修補等工程中。
  6. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  7. ( 5 ) since 3100 ab. r, through comprehensive analysis of these proxy climatic substitute indexes indicates : this was a dry and cold period in which the temperature fell the precipitation decreased ; the vegetation may be forest prairie ; human civilization further developed and the human " s influence on the environment was greater in intensity and wider in range

    今，綜合多氣候代用指標和本期人類活動明顯加強情況的分析表明：本期氣候再次出現溫度降低、降水量減少的變化，在趨于乾冷氣候條件下，在前期氣候較適宜期發育的森林植被發生了退化，當時的植被可能為森林草原或乾草原。
  8. And got the results consistent with the experiments. it is argued that the successive deepening of pseudogap with decreasing temperature leads to that hall coefficient attains to a positive maximum at the temperature a little higher than

    正常態霍爾系數的溫度行為，得到與實驗相符的結果。指出贗隙隨溫度降低的不斷加深導致了霍爾系數在比
  9. 7mpa / km in the center of the zone ( 6 ) in the hot dry rock geothermal energy extraction system, after the system start to operate, the normal stress of crack show the pronounced influence depending on the temperature ' s change in a month, there are a marked drop in temperature nearby the injection well, forming a lower stress area, with the heat extraction, the temperature ' s change even gradually, but the temperature descend quickly nearby the production well, forming a new lower stress area

    （ 6 ）高溫巖體地熱開發中，裂縫面法向應力受溫度變化的顯著影響，在系統開始運行的一個月內，注入井附近區域其溫度降低較快，形成低應力區;隨開采時間的延長，其溫度變化逐漸平緩，而生產井附近區域溫度降低加快，逐漸形成新的低應力區。
  10. Dsc and x - ray diffraction results show that after pan - milling, the crystallinity and the size of micro crystals of pa6 decrease. melting point increases and crystallization temperature decreases

    表現為結晶度降低，微晶尺寸減小；熔融溫度降低，結晶溫度升高；球晶尺寸減小。
  11. Of the currently available coolers for electronic products with a high heat flux, microchannel heat sinks have been proved to be able to provide the best heat transfer performance and are one of the most promising coolers. the manifold microchannel ( mmc ) heat sink has many advantages such as low thermal resistance, compact structure, little amount of coolant, low flow rate, uniform temperature distribution along the flow direction and many others, so it is able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference

    在目前高熱通量電子產品冷卻器中，微通道熱沉已被證實是傳熱性能最佳且最具應用潛力的冷卻方式之一，而歧管式微通道熱沉因具有低熱阻、結構緊湊、所需冷卻液量小、沿流動方向溫度分佈均勻等優點則成為減小電子元器件換熱表面最高溫度、降低溫度變化的一種有效方法。
  12. Ice increases its volume as its temperature decreases

    當溫度降低時，冰的體積會增加。
  13. 1 hours at 20 and less at higher temperatures

    1小時（ 20時） ，並隨環境溫度降低而變長。
  14. The temperature dropped two or three degrees. i can smell the moisture

    溫度降低了兩三度我能嗅到那股濕氣
  15. Dennis ? nomad buoy 431 1 is showing a temperature drop of 1 3 degrees

    丹尼斯？流浪者型浮標4311號顯示溫度降低了13度
  16. On titan, this so - called antigreenhouse effect cools the surface by seven degrees c or so

    在土衛六上，這種所謂的反溫室效應，使其表面溫度降低7左右。
  17. Numerical simulation on non - steady transport processes caused by steel - liquid temperature decrease in continuous casting tundish

    注入鋼液溫度降低時中間包非穩態過程數值模擬
  18. The repair effect were compared with various type of repair parameters such as thermal residual stress loading, temperature

    熱應力對修補效果有顯著影響， j積分值隨溫度降低而下降，且呈直線變化。
  19. The temperature of waste fume are reduced from 200 to 60 in order to increasing recovery rate of waste heat further in htac

    為了進一步提高煙氣余熱回收率，進行了將排煙溫度降低到60的實驗。
  20. Because calculated dew point of gas is about from 85 to 110, so we should consider low temperature corrosion

    計算了陜北天然氣露點為85 ? 110 。因此將排煙溫度降低到60后，考慮了低溫腐蝕的問題。
分享友人
分享到 Line

分享到臉書