溶液壓力 的英文怎麼說

中文拼音 [róngyèyālì]
溶液壓力 英文
solution pressure
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 溶液 : solution; liquor; scald; aqua
  1. Other liquids that are used in manometry are water, organic liquids and bromide compounds.

    壓力計中所用的其它液體有水，有機溶液以及溴化物溶液。
  2. In this paper, the mechanism and forming process of the cracks in view of the stress corrosion were analyzed accounting for the pressure vessels working in the atmosphere of wet hydrogen sul - phide, sodium hydroxide or liquidized ammonia

    本文分析了壓力容器及設備在濕潤硫化氫、氫氧化鈉溶液和液氨介質中應力腐蝕開裂的機理和應力腐蝕開裂的過程。
  3. With gelatin liquor as adhesive and wheat meal as granulation material, the effects on spray granule ' s strength of fluidizing gas velocity, bed temperature, nozzle air pressure and adhesive concentration were studied experimentally in a batch conical fluidized bed spray particle generator

    本文在一間歇錐形流化床噴霧造粒器中，以食用小麥澱粉為原料，以明膠的水溶液為粘結劑，實驗研究了流化氣速、床層溫度、噴嘴霧化空氣壓力、粘結劑濃度對噴霧造粒顆粒強度的影響。
  4. Test method for insoluble contamination of hydraulic fluids by gravimetric analysis

    重力測量分析液壓油不溶性污染試驗方法
  5. The process normally involves treating the yarn or woven article with a cold, concentrated sodium hydroxide solution under tension

    絲光處理的過程一般包括在壓力環境下用冷的，濃縮的氫氧化鈉溶液處理紗線或都已織好的布料。
  6. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  7. The factors that affect the concentration of ozone water, mass transfer efficiency and effective dissolving efficiency such as ozone gas concentration, gas to liquid ratio, system pressure and dissolving methods are discussed

    討論了應用臭氧量、氣液比、系統壓力和氣液溶解方式對臭氧水濃度和臭氧有效溶解效率的影響。
  8. Tank wagons for the carriage of liquefied or under pressure dissolved gases. identity and loading plate

    液體的或壓力溶解的氣體運輸用罐車.標識和裝載標牌
  9. The result indicates that displacement characteristics of unsheared polymer solution is better than the same viscosity polymer solution after sheared, the injection pressure of the unsheared polymer solution is higher than the same viscosity polymer solution after being sheared in the same permeability core, the lower the permeability, the bigger the molecule weight and the bigger the difference, as to the every layer of the secondary oil layer, it is feasible to displace oil with the polymer solution after sheared, and the eor of the polymer flooding can increase more than 9. 84 %

    結果表明：未經剪切的聚合物溶液的驅油效果好於經剪切之後的相同相對分子質量的聚合物溶液的驅油效果；對于相同滲透率的巖心，未經剪切的聚合物溶液比經過剪切相同相對分子質量聚合物溶液的注入壓力高，而且滲透率越低，相對分子質量越大，差異越大；對於二類油層的各滲透率小層，進行經剪切后聚合物溶液驅油是可行的，聚驅采出程度提高幅度均超過9 . 84 % 。
  10. As the ratio of alcohol to water descends, both of them rise. as the solution concentration of nitrates descends, the crystalline size firstly descends and then rises. the nozzle pressure brings forth little affluence on the crystalline size of the powder, but the elevated pressure can enlarge the quantity and the size of the agglomeration

    隨酒精和水的比值的減小，粒徑和顆粒粒徑都增加；粒徑隨溶液濃度的減小，先減小后增加；一次粒徑隨壓力的變化，變化很小，但隨壓力和流量的增加，團聚體增多、團聚粒徑增大。
  11. Electrospinning origins from that electrically charged fluid is forced jets in the high voltage electrostatic field. electrospinning occurs when the electrical forces at the surface of a polymer solution or melt overcome the surface tension and cause an electrically charged jet to be ejected. when the jet dries or solidified, an electrically charged fiber remains

    電紡絲技術是基於高壓靜電場下導電流體產生高速噴射的原理發展而來，其基本過程是：聚合物溶液或熔體在幾千至幾萬伏的高壓靜電場下克服表面張力而產生帶電噴射流，溶液或熔體射流在噴射過程中乾燥、固化，並保持一定電荷量，最終落在接收裝置上形成纖維氈或其它形狀的纖維結構物。
  12. Plastics piping systems - injection - moulded socket fittings for solvent - cemented joints for pressure piping - test method for resistance to a short - term internal hydrostatic pressure

    塑料管道系統.壓力管道溶劑膠粘接頭的注射模塑承口連接管件.短期內部液壓壓力的試驗方法
  13. Transport and materials handling. road tankers for non - refrigerated liquefied and dissolved gas under pressure. floor filling and draining devices

    運輸和裝卸.未冷凍壓力溶解液化氣道路罐車.下部裝卸裝置
  14. Octadecanoic acid ( oa ) / octadecylamine ( oam ) mixed monolayer were absorbed by hsa from the observation of surface pressure - molecule area ( n - a ) isotherms, differentiated curves of 0a / 0am monolayers and uv - vis, ft - ir spectra and fluorescence emission spectra of 0a / 0am lb film. the property change of 0a / 0am monolayer led to the change of crystal growth induced by the monolayer. when the concentration of hsa in subphases containing cac2o4 supersaturated solution rises from 0. 00 % ( wt % ) to 0. 10 %, cot, cod and com form beneath oa / oam monoalyer, respectively

    通過比較含不同濃度人血清蛋白（ hsa ）的草酸鈣過飽和溶液亞相上十八酸十八胺（ oa oam ）混和單分子膜的壓力?單分子面積（ - a ）等溫線，微分曲線及oa oam混和lb膜的uv - vis光譜、 ft - ir光譜以及熒光發射光譜，可以看出， hsa吸附於oa oam膜上，使oa oam膜的性質改變，並且影響到oa oam單分子膜對草酸鈣晶體生長的誘導作用。
  15. This means the saturation degree of concrete is different. by means of analyzing the l9 ( 34 ) orthogonal table, the air content is the chief factor, the second factor is water binder ratio and the third is mineral admixture in both high water pressure and low water pressure. the water saturation degree of concrete in damaging point ( e6 / e0 = 60 % ) can be found by measuring the dynamic modulus of elasticity after six freezing - thawing cycles

    採用l9 （ 34 ）正交表對水膠比、含氣量和摻合料三個因素進行分析，試驗結果表明:在自然情況下，影響混凝土水飽和系數的主要因素是水膠比，而影響混凝土在鹽溶液中飽和系數的主要因素則是含氣量;在水壓力作用下，無論壓力大小，混凝土水飽和系數的影響次序依次為含氣量、水膠比、摻合料。
  16. By using the method of orthogonal table, the water binder ratio, air content and mineral admixtures which affect the saturation degree are analyzed in this paper. meanwhile in freezing and thawing cycle circumstance including water environment and 3. 5 % nacl liquor, the saturation degree and the saturation rate are also analyzed. moisture content of the concrete is different by varying water pressure

    本文採用正交分析方法，研究了自然飽水和壓力飽水條件下水膠比、含氣量和摻合料三個因素對混凝土飽和系數的影響規律，並研究了混凝土在純水和3 . 5 % nacl溶液中受凍后飽和系數的變化規律。
  17. This also produced a similar, but smaller reaction in the olfactory neurons

    他們還發現：逐漸降低無氣味溶液噴入的壓力，嗅覺神經元的反應隨之減弱。
  18. The samples were characterized contrastively by sem, tem, saed, positron annihilate and the different mechanism for two methods were preliminarily discussed. the experimental results showed that nano - cuo prepared by sol - gel method was spherical, which was agglomerated badly and can aging easily. however, nano - cuo prepared by pressure - hydrothermal method has loose and thin - piece appearance structure

    結果表明，溶膠-凝膠法制得的氧化銅粉末呈類球形，團聚嚴重，易老化；而壓力-熱液法制得的氧化銅具有疏鬆的、薄片狀的外觀結構，粒子厚度約為20nm ，分散性較好、抗老化能力強；壓力-熱液法制備的氧化銅比溶膠-凝膠法制備的氧化銅缺陷濃度小。
  19. In this paper, an experimental investigation of the removal of volatile organic compounds ( voc ) from dilute aqueous solutions was presented by vacuum membrane distillation ( vmd ). experiments were carried out using aqueous mixtures of ethanol with hollow fiber module. the influences of operating variables such as feed concentration, flow rate, temperature and downstream pressure on the flux and separation factor were investigated

    本文對膜蒸餾脫除水溶液中的揮發性有機化合物（ voc ）進行了試驗研究；文中以乙醇水溶液為研究對象，採用真空膜蒸餾法，膜材料為中空纖維膜，研究膜通量及分離因子與原料液的溫度、濃度、流速，冷側壓力的關系，並對真空膜蒸餾的傳熱傳質機理進行了初步探討。
  20. As a main product of our company, spraying drying set is a kind of centrifugal or pressurized, which atomizes liquid materials such as solution, suspension, emulsion or paste into timy droplet ( surface area increased ) and dry them into powder product an once ( several to dozens of seconds ) by contacying hot air

    噴霧乾燥機組是一種用離心式或壓力式霧化器，將溶液、懸浮液，乳濁液或漿料等料液霧化成細微液滴（表面積顯著增大） ，經與熱風接觸得以急速乾燥（幾秒到幾十秒） ，從而直接得到粉末產品的裝置。
分享友人
分享到 Line

分享到臉書