溶液陶瓷 的英文怎麼說
中文拼音 [róngyètáocí]
溶液陶瓷
英文
solution ceramics-
Testing method for corrosion of fine ceramics in acid and alkaline solutions
細陶瓷在酸堿溶液中耐腐蝕性的試驗方法The disperse degree of the ceramic can greatly affect uniformity of the composite, which limit the poling voltage and affect the piezoelectricity. in this paper, the relationships among constitutes, microstructures, dielectric and piezoelectric properties were calculated by employing the banno unit cell mode ; pzt ceramic were synthesized by the hydrothermal method and the appropriate solution was selected according the adsorption of pvdf on the ceramic particle surface ; then, relationships between the disperse degree and the fabrication process were studied. base on these, the pzt / pvdf composites intermingled some pan were prepared and the microstructures were investigated
論文首先利用bannounitcell模型，計算了pzt pvdf壓電復合材料的組成、結構、與其壓電和介電等性能之間的關系；針對壓電復合材料存在的均勻分散性差的缺點，選用水熱法制備的粒度均勻的pzt陶瓷粉末，並採用溶液混和法與聚合物pvdf進行分散復合，重點研究了不同工藝條件下陶瓷的均勻分散性及其與材料微觀結構之間的關系。In this study we adopt a novel coordination - gel method to prepare zro2 - ni nanocrystalline composite powder. compared to the traditional methods such as coprecipitation, combusting solution synthesis and sol - gel method, coordination - gel method avoids the disadvantages such as bad uniformity of phases " buildup and difficulty of controlling the craftwork
本文採用一種新的絡合-凝膠法制備zro _ 2 - ni納米復合粉末，與傳統的共沉澱法、溶液燃燒合成法、溶膠-凝膠法相比，絡合-凝膠法克服了其它制備方法中金屬相和陶瓷相分佈不均、工藝難以控制的缺點。In this paper, the characteristics of the electroless nickel plating, the composition and fuction of the plating solution were introduced. at this base the low emissivity material was successfully prepared by the electroless plating method. the sample detected by edxa, sem, aes, ifr
本文在系統介紹了化學鍍鎳工藝的特點、溶液組成及各組份的作用的基礎上，採用化學鍍方法制備低發射率材料，成功地在羰基鐵粉體和陶瓷粉體上實施了化學鍍鎳。In this paper, the ceramic coatings were prepared in situ on ti - 6al - 4v alloy by micro - plasma oxidation ( mpo ). the phase composition, microstructure and corrosion resistance of the ceramic coatings were studied in detail and the technology of corrosion resistant coatings was optimized. the dissolution of the substrate and the changes of the elements in the electrolyte during the mpo process were studied to discuss the growing characters and the structure of the ceramic coatings
本文通過微等離子體氧化（ mpo ）方法在ti - 6al - 4v鈦合金表面原位生長陶瓷膜，系統地研究陶瓷膜的相組成、微觀結構及膜層耐腐蝕性能，並優化耐蝕性陶瓷膜層制備工藝;分析基體在mpo過程中的溶解現象和電解液中離子濃度變化特點，探討電極表面陶瓷膜層生長規律和結構特點;研究膜層的等效電路、膜層結構與耐腐蝕性能的關系，並對優化工藝條件下制備的陶瓷膜層進行進一步的耐腐蝕性能測試和耐腐蝕機制研究。Different electrolyte solution has different working voltage, with which the coating ' s thickness, hardness, porosity and protection ability change subsequently
研究了4種不同溶液體系對微弧氧化陶瓷膜的厚度、生長速度和硬度的影響。分享友人