滑動分流器 的英文怎麼說

中文拼音 [gǔdòngfēnliúqì]
滑動分流器 英文
slider shunt
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 滑動 : slither; slippage; slipping; slide; sliding; run; sliding movement [motion]; glide; slump滑動閘門...
  1. The exciter system of traditional dc exciter has some weaknesses, whose commutators and carbon brushes often need examining, repairing and maintaining timely

    對傳統直流勵磁機的勵磁系統而言，其帶有滑動接觸部分的換向器和炭刷等薄弱環節，需要定時檢修與維護。
  2. Full - flow lubricating oil filters for internal combustion engines - method of test for vibration fatigue

    內燃機用全流式潤滑油濾清器.第7部分:振動疲勞試驗方法
  3. Simulating results reveal that hydrodynamics of catalysts in riser reactor is very complex due to the effect of injection and catalysts backmix dramatically near the nozzle, reaction products unevenly distributie along the riser height, there exists apparently temperature gap between gas - phase and solid - phase near the nozzle and the temperture of two phase is nearly equal at middle - top part

    模擬結果表明，由於原料油射流的影響，提升管反應器內催化劑顆粒的流動特徵非常復雜，在噴嘴附近的催化劑顆粒存在明顯的滑落返混；裂化產物濃度沿提升管存在非均勻分佈；氣粒兩相間溫差在噴嘴附近顯著，在中上部氣粒兩相溫度幾乎相等。
  4. The at 2 scale based on the internal area - time lower bound of the viterbi decoder is analyzed. and the at 2 scales of three vlsi realization algorithms ( m - step decoder algorithm, flow and block decoder algorithm, and sliding block decoder algorithm ) are deduced. in succession, a fully new algorithm named ring - vd algorithm designed by ourselves is put forward, and its at 2 scale is also fetched

    分析並推導了viterbi譯碼器基於內部信息流的vlsi面-時下界at2尺度;推導了已有的三種viterbi譯碼器的vlsi高速實現演算法（ m步譯碼演算法、流水式塊譯碼演算法和滑動塊譯碼演算法）的at2尺度;提出了一種新的環形vd演算法，並推導了它的at2尺度;對四種viterbi譯碼器的vlsi高速實現演算法進行了比較分析。
  5. By analyzing and rat testing on the current negative feedback, the voltage negative feedback and the electricity - powered loudspeaker, this paper shows that the current negative feedback can decrease the distortion of the loudspeaker, makes the frequency - response plot more smooth and improves the audio quality greatly

    摘要本文通過對電流負反饋和電壓負反饋兩種電路與電動式揚聲器構成的系統進行對比分析，並進行實時分析測試，證實了電流負反饋對電動式揚聲器失真能從實質上得到改善，從而使頻響曲線更加平滑，音響系統的性能明顯提高。
  6. Pneumatic fluid power. compressed air lubricators. part 2 : test methods to determine the main characteristics to be included in supplier ' s literature

    氣動流體動力.壓縮空氣潤滑器.第2部分:測定供應商資料中應包含的主要特性的試驗方法
  7. Pneumatic fluid power. compressed air lubricators. part 1 : main characteristics to be included in supplier ' s literature and product - marking requirements

    氣壓流體動力.壓縮空氣潤滑器.第1部分:供應商資料中應包含的主要特性和產品標記要求
  8. Pneumatic fluid power - compressed air lubricators - part 1 : main characteristics to be included in supplier ' s literature and product - marking requirements

    氣液流體動力.壓縮空氣潤滑器.第1部分:預定列入供應商資料中的產品主要特性和標記要求
  9. This thesis discusses detailedly the flow process of ip multicast, error discovery method and error recovery method, and also proposes a new error control method to implement reliable multicast in computer supported cooperative design system : serial integrates with timer are used to discover error, arq mechanism based on nak feedback is modified to correct error, " sliding window " mechanism is imported to make up the drawbacks of traditional nak, and " slotting and damping " technique is used to resolve the question of " feedback implosion " which results from multicast reliability control

    詳細研究了ip多播傳輸的流程、數據傳輸的差錯檢測方法及差錯恢復方法，提出在協同設計系統中實現可靠多播的控制方法：利用序列號和計時器相結合的方法進行傳輸數據的差錯檢測，改進了基於nak反饋信息的arq重傳機制來實現差錯恢復，並引入了滑動窗口機制來解決傳統nak方法的不足，採用「時間分槽?抑制」技術來解決由於進行多播可靠控制而產生的「反饋內陷」問題。
  10. 3. based on the comprehensively deep research on the pmsm ' s mathematics model, a newly equivalent sliding mode current controller is presented used by field - oriented control, which improves the stator - current waveform of pmsm, decreases the torque ripple. the conclusion above is verified by the simulation results

    3 、在對永磁同步電動機（ pmsm ）的數學模型進行分析的基礎上，利用矢量控制原理，設計了一種新型等效滑模電流控制器，以改善pmsm的相電流波形，減少轉矩脈動，模擬結果驗證了該方法的有效性。
  11. First, the dynamics characteristics of the heat - exchanger unit is analyzed carefully by using the knowledge of the fluid dynamics and heat transfer etc., and makes some reasonable simplicities and assumptions. so it establishes the mathematical model of the working process of the heat - exchange unit, and applies the recurrence parameter estimator to identifying and proving

    本文首先綜合應用流體力學、傳熱學等方面的知識，分析了換熱機組的動力學特性，通過合理的簡化和假設，建立了換熱機組工作過程的數學模型，並使用遞推參數辨識器對其主要參數加以估計和驗證，從而得到換熱機組的carma （受控的自回歸滑動平均）或carima （受控的自回歸積分滑動平均）模型。
分享友人
分享到 Line

分享到臉書