滑動牽引 的英文怎麼說

中文拼音 [dòngqiānyǐn]
滑動牽引 英文
sliding traction
  • : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
  • : Ⅰ動詞1 (拉) lead along (by holding the hand the halter etc ); pull 2 (牽涉) involve; implic...
  • : Ⅰ動詞1 (牽引; 拉) draw; stretch 2 (引導) lead; guide 3 (離開) leave 4 (伸著) stretch 5 (...
  • 滑動 : slither; slippage; slipping; slide; sliding; run; sliding movement [motion]; glide; slump滑動閘門...
  • 牽引 : 1 (拉) tow; drag; draw; haul; pull; draft 2 [中醫] traction; 牽引車 [機械工程] drafter; tractor...
  1. Electric traction ; dropper clamp ; sliding dropper clamp for catenaries

    電力.掛線夾.吊索用掛線夾
  2. The amount of apparent sliding, known as "creep", is dependent upon the tractive effort.

    被稱為「爬行」的表觀的大小取決于力。
  3. The amount of apparent sliding, known as " creep ", is dependent upon the tractive effort

    被稱為「爬行」的表面的大小取決于力。
  4. According to the spread of nappe and relation between the nappe and depression, oblique - thrust fault zone was divided into three parts in this paper : sertengshan, lvliangshan and xitieshan. ( 3 ) according to macroscopic characteristics of fault zone, cleavage characters of fault zone, drag folds, the reverse " s " fold in the footwall, positive flower structures and small left strike - slip fault, the kinematics characters of fault zone of sertengshan - xitieshan are concluded : thrusting in section, left - slip fault in plane and the strike - slip displacement increasing from the west to the east

    ( 3 )根據斷裂斷裂帶的宏觀特徵、斷層帶劈理特徵、斷裂帶附近的褶皺和斷層下盤的平面反「 s 」型褶皺以及斷層上盤剖面正花狀構造和平面左行小型平移斷層,認為賽什騰-錫鐵山斷裂帶運學主要表現為剖面上的逆沖、平面上的左行走特點,並且走量具有自西向東增大之勢。
  5. A board pulled over the water by a motorboat and ridden by a person standing up

    水板由機水面上的板,並由站在上面的人乘坐操縱
  6. Asr focuses on avoiding driven wheels " skidding to attain good directional stability and speedup capability through traction control in the course of vehicle acce leration or startup

    Asr著眼于在驅過程中通過力控制來防止驅車輪發生轉,獲得良好的加速性能和行駛方向穩定性。
  7. This paper covers key problems in design of the chain conveyor with trolleys being able to travel back automatically and vertically and their spacing adjustable, including chain tension calculation, trolley passing ability and interference when traveling back automatically and vertically, rail slope, etc

    摘要對臺車間距可調及自垂直返回鏈式輸送機設計中的關鍵計算,如鏈條最大張力計算、臺車垂直自返回的通過性及干涉性、坡降曲線、前臺車塊裝置行程計算等作了細致分析並導出了公式。
  8. It comes with extra - deep and widepattern to reduce sliding, enhance stability and increase traction force. its service lifeis longer than e - 3

    其超深寬花紋可減少,增加穩定性和力。使用壽命較e - 3長。
  9. A right lateral strike slip, which is shown by mapview distribution of the whole fault zone, displacement of the strata, drag folding, s - c fabric and association of subsidiary faults, forms the mainly deformational mechanism

    右行走的主要標志包括斷裂帶的平面展布、地層錯褶皺、 s - c組構、次級破裂組合等。
分享友人