滑移流動 的英文怎麼說

中文拼音 [gǔyíliúdòng]
滑移流動 英文
gliding flow
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 流動 : 1. （液體或氣體移動） flow; run; circulate 2. （經常變換位置） going from place to place; on the move; mobile
  1. Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.

    粘附滑移流動是一種密集顆粒的急跳式的運動，在壁面處，顆粒的速度稍低於呈桿狀的中心的速度。
  2. These forms may include pneumatic conveying, moving beds or stick-slip flow, fluidized solids transport and nearly always one or more fluidized beds.

    這些形式可以包括氣力輸送，移動床或粘附滑移流動，流化固體顆粒輸送，並且幾乎總是包括一個或多個流化床。
  3. The fieldworks and the test results show that there appears three failure models on the natural slope, that is, rotational slide, translational slide and earth flows. triaxal tests, including the isotropical consolidation drained and undrained compression and anistropically drained tests, are performed on loosely compacted specimens. the critical state line ( csl ) is obtained in the e - lgp " plot based on the results of the above tests

    在野外調查的基礎上，結合試驗成果分析，初步得出自然斜坡破壞的模式，包括旋轉型滑動、平移型滑動及土流等；並對暴雨滑坡轉化成泥石流的影響因素和碎屑物質的運動距離作了定性分析；初步分析了滑坡轉化成泥石流的流態化機理。
  4. In theoretical analysis, the motion of radially - emitted electron beam in diode region and drift region has been analyzed, and the relation between radial momentum or current of electron beam and the guiding magnetic field has also been studied, then the possibility to optimize the guiding magnetic field has been derived. the motion of radially - emitted beam electrons in smooth bore magnetron and smooth bore milo has also been studied theoretically. at last, the motion of radially - emitted beam electrons in compound axial and azimuthal magnetic field has been studied

    在理論分析中，初步分析了軸向發射條件下電子在二極體區域和漂移區的運動規律，電子徑向動量隨著外加磁場變化的規律，以及電子束電流隨著外加磁場的變化規律，還有二極體區域磁場優化的可能性;分別研究了有軸向磁場時以及有角向磁場時徑向發射的電子在光滑陽極結構中的運動規律，最後分析了在軸向和角向復合磁場中電子的運動規律。
  5. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  6. On every step, the maximum of the turbulence dissipation rate is at the step tip. because the interaction between the skimming flow and the step tips causes the energy to dissipate continuously, so that the step can have better energy dissipation results

    在每個階梯上，紊動耗散率的最大值出現在階梯的突角處，正是由於滑移主流與階梯突角之間的相互作用使能量不斷耗散，從而使階梯具有良好的消能效果。
  7. Fem analysis of associated and non - associated flow rules in theory of slip line field

    滑移線場理論中不同流動法則的極限分析有限元解
  8. And then in detail the paper explains the main technique in sliding construction, which includes jacking scheme, plan layout, assembly, transport and stacking of component, setting of sliding system, setting of track, conformation of falsework, traction facility etc. third, the paper researches on se veral key points which are sum - up about technics flow of sliding construction, the select of falsework by bearing capacity which was calculated through three methods, the theoretic discuss on auto - control, dynamic or static inspect and adjust

    然後對其中的重點問題作進一步的討論，包括滑移法工藝流程的總結；對胎架的選型參考腳手架的計算，運用規范、軟體程序等三種方法進行受力特徵分析，與已有腳手架試驗結果進行比較分析，得出較為符合實際的胎架承載力值；對滑移過程中的自動控制及動、靜態控制監測等做出了應用分析和理論上的探討。
  9. A separation in the boundary layer of fluid about a moving streamlined body, such as the wing of an airplane, causing a breakdown in the smooth flow of fluid and resulting in turbulence

    氣流分離移動的流線型的軀體上流體邊界層上的分隔物，如飛機的機翼，在平滑的流體流動中會引起故障和湍流
  10. The average slip ratio of droplet velocity to gas velocity across the gas core is about 0. 7 for oil - gas two - phase flow

    油氣兩相流動時氣核中液滴與氣相的平均滑移比約為0 . 7 。
  11. The movement law that abrasive fluid in centrifugal field is discussed through the analysis of experimental results of high - speed photography, and it is pointed out that in the course of abrasive moving both the moving of layer and the curve changing from front interface to slip are the important factors of influencing processing results

    文中通過對高速攝影實驗結果的分析，探討了磨料流在離心場中的運動規律，指明磨料流在運動過程中，其滑移層的運動及前沿界面曲線的變化是影響加工效果的重要因素。
  12. Analysis of gaseous slip flow and heat transfer in micro rectangular channels

    微矩形槽道內的氣體滑移流動和傳熱分析
  13. On the base of analyzing the work theory of braking system and the ac servocontrol technologies, permanent magnet brush - less motor is used as the electric drive component, the aircraft slippage ratio adjustor and permanent magnet brush - less motor ( pmbm ) speed / current adjuster is made to construct a tri - loop control system

    在詳細分析飛機剎車系統的工作原理和交流伺服技術的基礎上，採用稀土永磁無刷方波直流電動機作為驅動部件，飛機期望滑移率控制和電機轉速、電流控制的三環控制方式。
  14. A detailed analysis on the characteristics of the solution of the void fraction matched model for the slug - to - annular flow pattern transition at microgravity condition, which is based upon the drift - flux raletionship of slug flow and the momentum balance relationship of smooth annular flow, is presented

    摘要對基於微重力條件下，氣液兩相彈狀流滑移流率關系和光滑環狀流動量平衡關系的彈環狀流轉換空隙率匹配模型的解的特徵，進行了深入分析。
  15. Wall - slip phenomenon of lubricating grease flowing in steel tube

    潤滑脂在鋼管中流動的壁滑移研究
  16. Based on the reynolds " lubrication approximation, the small parameter method is introduced to approximately analyze velocity field and stress distribution between the two parallel disks with an interstitial second - order fluid. 3. squeeze flow between two parallel plates of a bingham fluid with partial wall slip is considered

    以reynolds潤滑理論為基礎，採用小參數法研究了存在滑移時兩剛性圓盤間二階流體的擠壓流動，導出了流體的速度場和壓力分佈，進而求出圓盤間擠壓力的解析表達式。
  17. The results show that the squeeze viscous force decreases with the slip parameter increases, rigid region of the fluid increases with the slip parameter increases. when the slip parameter tends to infinite, the results of the squeeze viscous force reduce to the case of the squeeze flow of rigid - plastic solid between two parallel disks

    結果表明，圓盤上的擠壓力隨著滑移參數的增加而減小，當流體全部處于流動狀態時，即為圓盤擠壓牛頓流體時的情況；當流體全部處于剛性狀態時，即為圓盤擠壓理想剛塑性介質時的情況。
  18. Numerical simulation of gas flow and heat transfer in rectangular microchannel in slip flow regime

    矩形微通道內滑移區氣體流動換熱的數值模擬
  19. Analysis of heat transfer for gas slip flow in triangular micro - channels with uniform heat flux

    定熱通量加熱下微三角形槽道中滑移流動的換熱特性
  20. Squeeze flow of a second - order fluid between two parallel disks with wall slip

    存在滑移時兩平行剛性圓盤間二階流體的擠壓流動
分享友人
分享到 Line

分享到臉書