滑轉子 的英文怎麼說

中文拼音 [gǔzhuǎnzi]
滑轉子 英文
collar
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 轉 : 轉構詞成分。
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  1. Repair of the slip ring on the alternator rotor

    交流發電機轉子滑環的修復
  2. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式蒸發冷卻電機楔形氣隙中的流體流動、傳熱現象。本文在定子套筒和轉子表面光滑的假設下，針對蒸發冷卻電機定子套筒壁面基本恆溫的特點，將實際蒸發冷卻電機簡化為同軸套筒內筒加熱旋轉、外簡靜止定溫的物理模型。
  3. By analyzing and experimentally verifying the model, new ways of improving mixer performance were put forward. ( 1 ) heat water should be used in the mixer ' s temperature control to make the mixer work with optimal parameters. ( 2 ) the surface materials of the mixing chamber and rotors should be chosen rationally to change material surface energy and increase friction on them. ( 3 ) when the compound was processed under higher pressure of floating weight, shallow groovers or stripes parallel to the axle of the rotor should be made on the mixing chamber internal wall to increase the real contact area and improve mixing effect

    通過對模型的分析和實驗驗證，提出了提高密煉機混煉效果的新途徑： （ 1 ）密煉機溫度控制採用溫水冷卻，使密煉機處于最佳工作狀態； （ 2 ）通過合理選擇密煉室和轉子表面材料以改變材料表面能來增大膠料與它們之間的摩擦力； （ 3 ）在上頂栓壓力較大的條件下，在密煉室內壁與轉子軸線同方向加工淺的光滑槽可明顯改善混煉效果。
  4. Failure situations on bearing bushes from october of 1999 to the two units are generalized, the main causes are divided into four classes : bearing bushes with low quality, overproof on dynamic balance, bad crapping to bearing bushes, and bad fluid oil

    通過對該廠1999年10月投產以來的兩臺離心鼓風機的軸瓦失效情況進行的統計，將造成軸瓦失效的主要原因分成4類，即：軸瓦質量差、轉子動平衡超標、研刮不良以及潤滑油油質不佳等。
  5. The ultrasonic motor is a kind of direct driver which is uses the converse piezoelectric effect of the piezoelectricity ceramics, by using transformation and the coupling of each kind of expansion and contraction vibration pattern enlarging the material microscopic distortion by resonate effect and transforming it to macroscopic movement of the rotor or the slide by the friction coupling

    超聲波馬達是一種利用壓電陶瓷的逆壓電效應，通過各種伸縮振動模式的轉換與耦合，將材料的微觀變形通過共振放大和摩擦耦合轉換成轉子或者滑塊宏觀運動的直接驅動器。
  6. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  7. Eccentric rotary pump with sliding sleeve

    滑閥型轉子泵
  8. The stress of the sliding vane, the axe and the valve are analyzed through ansys, finite element analysis software. it is certain that this paper is of some reference value in designing such kind of sliding vane compressor with a spliced rotary cylinder

    接著分析了轉缸鉸接滑片壓縮機中的滑片和轉缸的運動規律，並對滑片進行了受力分析，利用有限元分析軟體ansys分析了滑片、轉子和排氣閥片的強度。
  9. According to the law of mass moment of inertia and of momentum moment, the conditions for the complete dynamic balance of rotor inertial forces and moment of inertia in the rotary piston vacuum pump are put forward, with the rotor movement in single cylinder analyzed as basis

    根據質量矩定理和動量矩定理對單缸滑閥真空泵的轉子運動狀況進行了分析，分別提出了轉子慣性力和慣性力矩完全動平衡的條件。
  10. The solution formula of dwell time is deduced by using the pulse iteration method and the smoothing fourier transition method, and the formula can be simplified referring to workpiece shape. according to the anastomotic status of the tool and workpiece surface, we present the new model of the inherent relation among local pressure density, removal rate, convergence ratio and residual errors, and the corresponding formulas are given. the forming cause of the edge effect in the polishing process is analyzed, and the means which reduces the edge effect is put forward

    2 、針對計算機控制光學表面成形（ ccos ）的加工方式、誤差收斂特點，研製了去除函數呈高斯分佈的雙轉子結構研拋模；採用脈沖迭代法、平滑因子傅立葉變換法推導出駐留時間的演算法，求解過程中根據工件面形的特點作了各種形式的簡化；提出了工件表面和研拋模的吻合誤差與局部壓強、材料去除率、收斂比之間內在關系的數學模型，並推導出相應的計算公式；分析了邊緣效應產生的原因，在加工過程中採用相對壓力因子對去除函數進行修正，可以消除邊緣效應的影響。
  11. Because of the advantages of small size, light weight, fewer moving parts and hi performance, the rotary compressor, such as the sliding compressor, the rolling piston type rotary compressor and the scroll compressor, is widely used in the air conditioner and refrigeration system. but these rotary compressors still have many disadvantages

    回轉壓縮機，如滑片壓縮機、滾動轉子壓縮機、渦旋壓縮機等，因其體積小、重量輕、零部件少及性能好等優點，被廣泛應用於空調、製冷行業中，但這些壓縮機自身仍存在許多不足之處。
  12. A new sliding vane compressor with a pinned rotary cylinder driving the rolling piston is presented in this paper. this paper analyzes the structure characters and the structure parameters of the new sliding vane compressor with a pinned rotary cylinder driving the rolling piston by means of contrasting with other compressors. a means that designs the suction and exhaust in the new sliding vane compressor with solid works and excel is brought forward

    本文介紹了一種新型結構的滑片壓縮機? ?轉缸驅動轉子滑片壓縮機，通過與其它型式壓縮機在結構及工作過程上的對比，詳細分析了這種壓縮機的結構特點和結構參數，並提出了一種結合三維軟體solidworks和電子表格excel設計吸排氣口的新方法。
  13. Contrasting with the sliding vane compressor and the rolling piston type rotary compressor, the character of the new structure and its working principle are introduced in detail. the facts that affect its working process have been analyzed. the kinetic process of the sliding vane and rotary cylinder are studied

    文中通過對比轉缸鉸接滑片壓縮機與滑片壓縮機、滾動轉子壓縮機的在結構及工作過程上的相同與不同之處，詳細介紹了這種壓縮機結構方面的特點和工作原理，並分析了影響這種轉缸鉸接滑片壓縮機工作過程的各種因素。
  14. The way to eliminate chaos phenomenon through adjusting system parameters is indicated. the nonlinear dynamic behavior of journal bearing - rotor system in large parameter space is studied in numerical integral method and floquet theory and the first and second bifurcation behavior of nonlinear rotor system are discussed ; the concept is advanced that realizing the controllable nonlinear stiffness with sfd with the soft - nonlinear of sma in the super - elasticity state to make the vibration amplitude of system always be in the small solution state to reduce the vibration amplitude of rotor system

    運用數值積分方法結合floquet理論對滑動軸承-轉子系統的大參數范圍非線性動力學特性進行了全面的研究，詳細地討論了系統的一次和二次分岔行為； 5 ）提出了用形狀記憶合金在超彈性狀態下的軟非線性，結合擠壓油膜阻尼器實現系統剛性的非線性可控，降低系統在非定常狀態下的最大振幅的構想。
  15. When generator runs at conversation states from synchronous speed to super - synchronous speed, the excitation current of oppositional phase sequence should ensure the current waveform smoothly transform

    當發電機運行於同步速向超同步速過渡轉換狀態時，需向轉子饋入反相序的勵磁電流，且保證勵磁電流的波形平滑連續。
  16. The main module of sensorless pmsm vector control such as voltage sensing, current sensing, smo rotor position estimation, speed calculation, generation of sine and cosine, vector coordinate transformation, pi regulators, svpwm vector modulation are all accomplished in the pwm interrupt service routines

    永磁同步電機無位置傳感器矢量控制的主要模塊如電壓采樣、電流采樣、滑模轉子位置估算、速度計算、正餘弦值生成、矢量坐標變換、比例積分調節器、空間電壓矢量脈寬調制等都是在pwm中斷服務子程序中完成。
  17. But because the slipping increasing of this kind of motor is realized by increasing the rotor resistor, it raises the motor ' s slipping loss and cuts down the motor ' s efficiency. the softer the feature of motor is, the lower motor ' s efficiency is

    但是由於該種電動機的轉差率增大是通過增加轉子電阻來實現的，這就增大了電機的滑差損耗，降低了電機的效率，電機特性愈軟，效率愈低。
  18. As a rigid rotor with special configuration, the crank is always integrated with its accessory components such as shaft and piston when it is under working conditions

    曲軸作為結構特殊的剛性轉子，在運行中總是與連桿，滑塊一起構成一個整體的曲柄連桿機構。
  19. Second, a jeffcott rotor model supported by two seals bearings in its two ends is established to simulate the shafting of simple turbines ( only short - and - straight - blades are included in the shafting ). and periodical response of the system is obtained by using the newmark method. then, the dynamic characteristics of rotor system at the certain rotate speed and the certain physic

    其次，建立了一個用來模擬簡單汽輪機軸系（只含有短直葉片）的兩端用滑動軸承支撐的jeffcott轉子模型，並用newmark方法求得了系統的周期響應，根據系統的周期響應、 poincare映射圖、頻譜圖、分岔圖等，分析了系統在特定轉速及特定的轉子系統參數下的運動特徵。
  20. The magnetic bearing ( mb ), widely used in high speed rotation field, has the advantage over conventional mechanical bearing in many aspects, such as no mechanical contact between the rotor and the bearing, no lubrication, no pollution, long - life span and so forth

    由於磁軸承的轉子和軸承之間沒有機械接觸，無須潤滑，無油污染，使用壽命長，這些特點使它在高速旋轉領域獲得了廣泛的應用。
分享友人
分享到 Line

分享到臉書