滯后損耗 的英文怎麼說

中文拼音 [zhìhòusǔnhào]
滯后損耗 英文
hysteresis loss
  • 滯 : Ⅰ動詞（使停滯; 使不流通） stagnate; block up Ⅱ形容詞（停滯; 不流通） sluggish; slow-moving; stagnant
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. The net effect of the connecting system is to introduce losses and lags in response.

    連接裝置的凈影響造成損耗和響應滯后。
  2. Hysteresis loss coefficient

    滯后損耗系數
  3. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  4. Firstly, the basic theory of full - bridge phase - shift zvs pwm converters are expatiated and another three kinds of circuits of full - bridge phase - shift zvs pwm converters are discussed. there are four kinds of problems which are emphasized : how to expand the zvs range ; how to reduce the circulation in the primary side of the transformer in order to minimize the on state losses ; how to decrease the loss of effective duty circle and how to eliminate the parasitic oscillation of the output rectifiers

    本文首先分析了基本的全橋移相zvsdc dc變換器的工作原理，為解決滯后橋臂不易實現零電壓開關（ zvs ）的情況，討論了另外三種全橋移相zvsdc dc變換器的電路拓撲，重點分析並解決了四個方面的問題：如何擴大zvs的負載范圍；減小變壓器原邊環流，降低變換器系統通態損耗；減少變壓器次邊有效占空比丟失；消除輸出整流二極體的寄生振蕩。
  5. The method is proved to be a practical way of implementation with expected precision. a new type device is presented to measurement of the magnetic properties of the single sheet, after a detailed account of the parameter of magnetic characteristic and relevant measurement

    在詳細介紹磁性材料的特性的相關參量，及交流磁化曲線和磁滯回線的測量方法和磁損耗的測量方法后，提出對于龜機鐵芯磁性能測試不僅要進行整體測試，應在疊鉚前對單片硅鋼片測試。
  6. The other is to simulate simple lc filters which call ideal and real inductors model, then we can get the simulating results such as time 、 phase movement and amplitude - frequency specifications are very different mainly due to hysteresis. in all, this paper presents some called real inductors models and provides a design method of real inductor model

    模擬結果表明，調用磁芯電感模型的模擬曲線比調用理想電感的情況滯后、幅值小，反映了磁芯電感元件的電感量、磁滯效應和磁滯損耗都影響濾波器的時移、相移和幅頻特性。
分享友人
分享到 Line

分享到臉書