滲塗層 的英文怎麼說

中文拼音 [shèntúcéng]
滲塗層 英文
cementation coating
  • 滲 : 動詞（液體慢慢地透過或漏出） ooze; seep
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 塗層 : paint-coat; paintcoat; coat; coating; covering; lining; wrapping flux
  1. The hydrogen permeation experiment of manet ii with hot dipping aluminized coating was performed in temperature range of 300 to 450, in gas phase and in liquid pb - 17li phase

    在300 450溫度范圍內，分別在氫氣相和液態鉛鋰合金相中開展了帶熱浸鋁塗層manet馬氏體鋼的氫滲透性能研究。
  2. Glass flake coating for internal protection, wire spirall - wound complex pipe or nitridizing technology were suggested to be countermeasures

    就試驗結果和目前的技術發展來看，建議採用玻璃鱗片塗層或採用鋼骨架復合管或滲氮工藝進行管線保護。
  3. Paints. thick plastics coatings. test for blister formation under water vapour diffusion

    塗料.厚塑料塗層.在水蒸氣滲透作用下塗層起泡的試驗
  4. Standard test methods for water vapor transmission of organic coating films

    有機塗層薄膜水蒸氣滲透性標準試驗方法
  5. Abstract : in lost foam process, liquid metal crushing coating is the important cause of metal seeping defects

    文摘:金屬液壓潰塗層是消失模鑄造中滲金屬缺陷形成的最重要原因。
  6. The most effective solution is to increase the coating thickness or to use high strenteh coating at high tempreture

    增厚塗層或使用高溫強度高的塗料是防止滲金屬的最有效方法。
  7. Test method for water penetration into pipeline coatings

    管道塗層滲水性的試驗方法
  8. Dtu 42. 1 - work execution standard - repair of existing facades using polymer based impermeable coatings - part 1 : technical clauses book

    Dtu 42 . 1 .施工標準.使用聚合物基不滲透塗層修理原表層.技術條款手冊
  9. Dtu 42 - 1. work execution standard. repair of existing facades using polymer based impermeable coatings. part 3 : instruction manual

    Dtu 42 - 1 .施工標準.第404部分:聚合物基不滲透塗層原表層的修理.第3節:結構說明書
  10. The pressure dependence of permeation flux indicates strong surface contribution. the way of filling hydrogen by continuous flow and / or bubble can increase permeation flux

    從滲透通量與樣品上游氫壓的關系來看，塗層使得表面效應對滲透過程的影響很大。
  11. Low voltage plasma discharged alloying ceramic coatings in liquid medium

    低電壓等離子體放電熔滲陶瓷塗層的研究
  12. 2 nano ceramic material is infiltrated into plasma - spraying coatings by laser - cladding nano - material. the microstructures of the coating series gotten are studied in detail with x ray diffraction, scanning electron microscopy. it is concluded that after laser cladding the density of the nano material infiltrated coating is improved and superior to density of laser - remelting coating

    （ 2 ）在等離子塗層的基礎上，利用激光熔覆將納米陶瓷材料熔滲到等離子塗層中，然後採用x射線衍射、掃描電鏡、能譜儀等，對陶瓷系列塗層的微觀組織與結構進行了詳細分析。
  13. The distribution and infiltration depth ( greater than 70 micron ) of the nano material in the coating gotten are tested to prove the technology and the mathematic model built once more

    測試了納米顆粒在塗層中的分佈及滲入的深度（ 70 m以上） 。驗證了各種參數選擇的合理性與數學模型的正確性與準確性。
  14. Using nano structured material powder as the coating stuff, laser is employed to remelt the plasma spraying coating basis so that the nano structured powder material could be clad on the surface of the plasma spraying base or infiltrated to the plasma spraying coating

    提出了一種納米改性塗層的復合工藝方案和技術路線。以納米為填料，在激光重熔等離子塗層的同時，將納米材料熔覆在等離子噴塗層表面或滲入等離子噴塗層內部。
  15. On the basis of analyzing characteristics of the cement - based capillary crystalline waterproof materials, the article points out that both waterproofing and leak - stopping ability of this kind of materials should be simultaneously functioned in order to enhance quality of coating layer, ensure its thickness and effectiveness

    在分析水泥基滲透結晶型防水材料應用特點的基礎上，指出在此類材料的應用中，應重視同時發揮其防水和堵漏的功能，提高防水塗層質量，保證塗層厚度，以確保應用效果。
  16. Coated fabrics for use in the manufacture of water penetration resistant clothing

    生產防水滲透布料用的塗層織物
  17. With the hardness tests, it is indicated the hardness of the nano alumina or nano silicon carbide coating is improved to 1. 6 - 2. 5 times as that of the plasma spraying coating. with the wearing tests, it is indicated that low laser power employed, the wearing performance of the coating without nano material increase to 1. 3 times as that of the plasma coating, at the same time, the wearing performance of the coating with nano material increase 2. 3 - 6 times as that of the plasma spraying coating, the wearing mechanism is further analyzed. with the erosion tests, it is indicated that the erosion performance of the coating with nano material increase five times as that of the plasma spra

    與相應等離子噴塗層相比，硬度測試表明，含納米al _ 2o _ 3或sic的各種復合塗層硬度提高了0 . 6 - 1 . 5倍左右；耐磨性測試表明，小功率下單純的激光重熔耐磨性提高了30 ，而納米滲入后塗層的耐磨性提高了1 . 3 - 5倍左右，對耐磨性提高的機理作了進一步的探索和分析研究；耐蝕性測試表明，經激光熔覆納米滲入后的各種塗層耐蝕性能提高了4倍以上，同時塗層厚度、表面質量對腐蝕性能有影響。
  18. The corrosion resistance of organic coatings and the relevant mechanism were studied by using water vapor transmission rate technique and electrochemical impedance spectroscopy ( eis )

    摘要通過測試塗層滲水率以及塗層交流阻抗圖譜，評價塗層的耐腐蝕性能，並就其機理進行了初步探討。
  19. Paints. thick plastics coatings. retardation of dripping water diffusion

    塗料.厚塑料塗層.滴水滲透的阻滯
  20. Paints and varnishes - coating materials and coating systems for exterior wood - part 4 : assessment of the water - vapour permeability

    塗料和清漆.外部木材用塗料和塗層系統.第4部分:水-蒸氣滲透性的評估
分享友人
分享到 Line

分享到臉書