激光反射鏡 的英文怎麼說

中文拼音 [jīguāngfǎnshèjìng]
激光反射鏡 英文
laser mirror
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. This paper analyses the coupling wastage in columniform wave guide gas laser, and gives the function between the coupling wastage of laser guide modulo eh11 and the position and radius of reflector

    摘要分析了圓柱形波導氣體激光器中的耦合損耗，給出了最低階波導模eh11的耦合損耗與反射鏡位置、曲率半徑的函數關系。
  2. Based on an amplified spontaneous emission ( ase ) source, a ring - cavity fiber laser, in which sensor element acted as the reflector of the cavity, was achieved with high - signal noise ratio ( snr ) and high - power. it was demonstrated that the output power was maximum, when output coupler ratio of the coupler was seventy percent

    實驗證實耦合器的輸出耦合比選為某一個最佳值70 ，當980nm泵光工作電流為50ma時，其輸出功率達3 . 5mw ，且輸出激光波長與作為反射鏡的光纖光柵中心波長相同。
  3. Optical waveguides and micro - mirrors were successfully induced inside fused silica glass and k9 glass, respectively, by focusing femto - second pulse laser. the change of refractive index was determined to be 0. 001 to 0. 008 in the fused silica glass and 0. 006 in the k9 glass

    用聚焦的飛秒激光成功地在石英玻璃中寫入了條型光波導，並首次在k9玻璃中寫入了微反射鏡。
  4. At first, modeling of these divvies by rate equations to obtain expressions for threshold and slope efficiency is given. on the case of this theory, the large numbers of literatures and datum are consulted, and the laser is home studied. through rationally selecting and improving the reflector surface, ensuring the beam quality, increasing farthest the absorption path, and improving effective pumping frequency ; through designing the water cooler of yag bar, the volume of laser is half the same internal and international production, and the output power is get to the extremum of the same international production

    並在此基礎上查閱了大量文獻和資料，對該種激光器進行了深入的研究，通過對yag棒直徑的合理選取併合理地改進反射鏡面，從而既保證了光束質量又最大限度的增加了吸收長度，有效的提高了泵浦效率；在不影響泵浦的前提下，通過有效縮短yag棒的長度減小輸出損耗；對yag棒的水冷系統進行優化結構設計，使激光器體積減小到國外同類產品體積的一半，而輸出功率已達到國外同類產品的極限值。
  5. This paper gives a description of discharge tube, mirror, laser head and laser power supply of an air cooling argon laser which output is over 1w, and shows its properties

    介紹輸出功率超過1w的風冷氬離子激光器的放電管、反射鏡、激光器頭部和激光電源的設計考慮，給出了它的性能。
  6. The laser's basic structure, also called the resonant cavity, is essentially a long tube with mirrors at each end.

    激光器的基本結構（也稱為諧振腔）實質上是一根兩端都有反射鏡的長管。
  7. In this paper, micro - cavity semiconductor laser ( mcsl ) with pillar vertical - cavity surface - emitting structure ( vcsel ) which has potential applications in optical communication and optical interconnect is theoretically analyzed, the calculation model that used to discuss the modal performance of rectangular columnar and cylinder vcsel with oxidized aperture is established by using vector field model. the numerical simulations in the case of cylinder structure show oscillating wavelength and threshold gain against inside and outside radius of laser, the layer refractive index and pair number of bragg mirror, thickness, position and oxidized material ' s refractive index of oxidized aperture, in detail. more practically, considering dos shell of laser as non - perfect one, or supposing that dos shell is separated from the laser, we can obtain more significative results

    本工作以矢量場模型出發，對具有誘人應用前景的柱形垂直腔面發射結構（ vcsel ）的微腔半導體激光器（ mcsl ）進行了理論分析，建立了用於分析方柱形和圓柱形結構具有氧化孔徑層的激光器的模式特性的理論模型；對圓柱形結構情況進行了數值模擬，得到了振蕩波長、閾值增益隨激光器內外半徑、 bragg反射鏡層折射率、周期數以及氧化孔徑層厚度、位置和氧化物折射率的詳細變化規律；為使理論計算更接近實際，將外加金屬包殼視為非理想導體，或將金屬包殼與激光器結構隔開，分別對這兩種情況下的結果進行了討論。
  8. In the srlois, a sphere reflector taking the place of the traditional lens is taken as the scanning optical system, the measuring range of the system is extended, and the problem of laser non - contqct measurement of larger diameter for workpiece

    本系統用球面反射鏡代替傳統透鏡作為掃描光學系統，擴大了系統的測量范圍，解決了工件較大徑向尺寸（直徑）的激光非接觸檢測問題。
  9. The influences of the thermal deformation of resonator mirrors induced by absorption of laser energy on geometric structure parameters of unstable resonators and intensity distributions of the far field were theoretically analyzed using finite difference methods

    摘要利用交替方向隱式有限差分法分析了高能激光器虛共焦非穩腔反射鏡的溫度場及熱變形的數值計算方法。
  10. Process analysis of laser reflective mirror and induce transmittance filter

    激光反射鏡與誘導透射濾光片工藝分析
  11. With the development of infrared tunable opo, its application is more and more wide. lt is possible for us to estimate the quality of resonant mirrors in laser with high energy and to improve the output energy of laser, by measuring the reflectivity of resonant mirrors of coil and df laser by cavity - ring - down which use output wave of opo as the laser source, instead of coil and df laser with high price and huge space

    用opo紅外輸出激光作為光腔衰蕩的光源代替價格昂貴、體積龐大的氧碘和氟化氖激光器，對其諧振腔鏡的高反射率進行測量，以達到對高功率激光器腔鏡高反膜質量的評價，為改進膜系設計、鍍膜工藝優化和提高激光器的輸出能量提供理論依據。
  12. With the furthermore development of ultra thin film technology, soft x - ray multilayer mirrors was applied in many fields, such as astronomy, microscope technology, euv lithogrphy, x - ray laser, icf diagnosis and so on

    隨著軟x射線超薄膜制備技術的不斷發展，軟x射線多層膜反射鏡已在多個領域中投入研究與應用，如天文學、生物醫學顯微鏡、極紫外投影光刻技術、 x射線激光、高溫等離子體診斷等等。
  13. High - energy laser system involves an optical train consisting of reflectors and windows, in which temperature increment, stress and deformation may happen because of the absorption of some fraction of the incident laser beam - energy so that the beam quality and transmission of energy to far - field will be affected

    高能激光系統中，由一系列反射鏡和窗口組成的「光學鏈」 ，不同程度地吸收部分激光能量，產生溫升、應力和變形，影響光束質量和光能量的遠場傳輸。
  14. The sg - iii prototype facility is a experiment facility that is applied for the inertial confinement fusion ( icf ). the electrical control reflective mirror is the last adjust equipment when the laser enter the final optics module. so the adjust precision of the reflective mirror directly affects the shooting quality

    神光-原型裝置為我國用於慣性約束核聚變（ inertialconfinementfusion ， icf ）研究的試驗裝置，電控反射鏡架為入射激光進入終端光學組件的最後一套調整裝置，該裝置調整精度的高低直接影響激光打靶的質量。
  15. Based on the character of the eof gain at 1550 nm, a laser diode ( ld ) worked at 980 nm and acted as the pumping source, a eof employed as gain medium, and a fiber grating used as reflector, an ring - cavity all - fiber laser worked at 1562. 5 nm was demonstrated with an output power of 2. 0 mw and a bandwidth of 0

    本文主要基於摻鉺光纖在1550nm波段的增益特性，利用帶尾纖的980nm半導體激光器作為泵浦源，鉺光纖作為增益介質，布拉格光纖光柵作為諧振腔反射鏡，實現了波長為1562 . 5nm的環形腔光纖激光器，得到了2mw的激光輸出。
  16. Focus lens, reflect lens, yag laser whole / semi - reflect lens ： they are all used import material to process, which insure the lens have long service life and low waste during the laser transmission

    聚焦鏡、反射鏡片、 yag激光全反射鏡片等產品介紹：採用進口原料進行生產加工，確保鏡片使用壽命長、激光傳導中損失量小。
  17. Abstract : in this paper, the problems of the window set - up, the forward receiving method by mirror and the way of side direction receiving, when ldv is used to measure the velocity of water flow inside a circular tube, are discussed and some practical experience in the measurement is summarized

    文摘:使用二維激光多普勒測速儀（ ldv ）對圓管中水流進行測速時，對于窗口的設置、利用反射鏡前向接收的方法和側向接收方式等問題，本文進行了探討，並總結了測量中的一些實際經驗。
  18. So it is very important to study the method and technology by dual frequency laser interferometer without orbit. and it is a significative task to study a kind of instrument to measure automatically without orbit. this paper adopts a measurement project to track the measurement reflector mirror without orbit by theoretical analyzing and simulant experiment

    本文通過理論分析和模擬實驗，確定採用一種外置光路激光跟蹤測量的方法，即：在雙頻激光干涉儀前面，設置一個兩維跟蹤反射鏡，當測量反射鏡移動時，測控系統驅動控制兩維跟蹤反射鏡旋轉，跟蹤測量目標靶鏡的運動，保證測量信號不中斷，從而實現跟蹤測量。
  19. Humid environment reflective lenses rust easily, or are likely to cause a short circuit sparking discharge laser

    潮濕環境容易使反射鏡片生銹，同時也容易造成電路短路或激光器放電打火。
  20. ( 3 ) properties of yag laser q - switching by sbs were experimentally investigated, and the laser without back reflective mirror was devised, and laser pulse was obtained at repetition rate ihz and 5hz by optimizing lens focal length, length of cell and position of lens focal. point, resulting quality of pc is ideal

    （ 4 ） 、實驗研究了sbs的yag激光器，設計了無後向反射鏡的sbsyag激光器。在泵浦能量17j 、重復頻率分別為1hz 、 5hz時，得到穩定輸出的能量為19mj 、脈寬為10 . 7ns 、光束質量很好的激光脈沖。
分享友人
分享到 Line

分享到臉書