濾光計 的英文怎麼說

中文拼音 [lǜguāngjì]
濾光計 英文
filter device
  • 濾 : 動詞（除去液體雜質） filter; strain
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. Verification regulation of photoelectric colorimeter with filter

    濾光光電比色計檢定規程
  2. They are basic foundations of this thesis because pif, achromatic wave plates and polarization beam splitter have indivisible relationship with the properties of birefringent crystals

    無論是偏振干涉濾光片，還是消色散延遲片或者是偏振分束器，都是基於晶體的性質而設計的。所以本章是本論文的基礎之基礎。
  3. It is also found that replacement of substrate and adjustment of film stack structure would lead to the change of drift, this will enhance the temperature stability of filter

    同時經過計算分析發現通過更換膜系基板和調整膜系結構可以改變濾光片中心波長的漂移，這個結果有助於提高濾光片的溫度穩定性。
  4. On the basis of analyzing the several traditional algorithms, the efficient design method, the self - initiated weighted least squares ( swls ) combined with adaptive simulated annealing ( asa ), are proposed explicitly for the design of pif. this chebyshev criterion based optimal approximation method has not only very fast computing speed but also high accuracy and good controllability

    在對這些演算法特性分析比較的基礎上，系統完整地提出適用於lcos投影分合色偏振干涉濾光片設計的最高效方法? ?自啟動權值最小二乘演算法（ swls ）結合自適應模擬退火演算法（ asa ） 。
  5. Standard test method for estimating stray radiant power ratio of dispersive spectrophotometers by the opaque filter method

    用不透明濾光器評估色散分光光度計雜散輻射功率的標準試驗方法
  6. This part of work involves several key problems as follows : - 1 ) coupling technology of laser source with the optical fiber ; 2 ) the construction of the sampling device and the selection of relevant parameters ; 3 ) the technical platform for the treatment and modification of fiber / capillary annular column sensing element ; 4 ) the selection of the size or parameters, design, machining and assembly of the sensing instruments ; 5 ) the construction of the multichannel detection system, the collection and processing of the digital signals and the exploiture of relevant software ; and so on

    傳感裝置各部件尺寸或參數的選擇，設計、加工和組裝；一5多通道檢測系統的構造，數字信號的採集及軟體的開發；等等。根據我們的設想，我們研製出了基於通用和快速檢測的裸光纖模式濾光傳感裝置和基於多組分同時選擇性響應的修飾光纖模式濾光色譜傳感裝置。
  7. Film system design for shortwavelength pass filter

    短波通濾光片膜系設計
  8. The convergent infrared optical monitor and controller were designed to monitor and control the film thickness in multilayer growth in fabricating immediate and far infrared band - pass filters

    摘要針對平行光紅外光學系統存在光斑大、能量損失大等不足，設計了主要用於中遠紅外帶通濾光片膜厚監控的會聚光紅外光學系統及其光控系統。
  9. Applying the ways of adjusting the bandwidth, minimizing the pass band ripples and group delay ripples, a 50ghz filter is designed. in the paper, we also discuss the temperature stability of dwdm thin film narrow band - pass filter

    本文總結了波分復用濾光片的各種設計方法，運用帶寬調整、通帶波紋的減小和通帶群延遲波紋減小的方法設計出了50ghz的波分復用濾光片膜系。
  10. The emulations displayed high etendue efficiency and proved that the four designs have potential values in 0. 5 - 0. 7 inch slm project display. dividing colors and recombining colors system with dichroic filter system fulfilled the analysis of color balance by lighttool

    對分色合色分系統和投影鏡頭分系統設計進行了初步研究，結合二向色濾光片分色合色系統，利用lighttools軟體的照明模塊實現了投影顯示系統的顏色特性分析。
  11. At the end of the paper, we extend the utilities of pif and design several innovative polarization interference devices, such as broad - band polarization rotator, interleave and polarization vector integrating device. all these exploratory researches will promote the further development of pif

    最後對偏振干涉濾光片用途進行合理拓展，利用偏振光的干涉特性，設計了幾種實用的偏振器件，例如寬波段偏振旋轉器、交錯復用器和偏振整合器等。
  12. The approach is that we first calibrate the filter radiometer with cryogenic radiometer and measurement equipment of relative spectral responsivity and then calculate the absolute spectral responsivity. because the drift in blackbody temperature directly influnces measurement accuracy, so we adopt a feedback system to stabilize blackbody temperature through controlling the current of blackbody that improves measurement accuracy greatly

    該方法首先要用低溫輻射計及相對光譜響應度測量裝置對濾光輻射計進行標定，經計算可得到濾光輻射計的絕對光譜響應度；由於黑體溫度的漂移直接影響到測量精度，我們採用反饋系統通過控制黑體的加熱電流，來穩定黑體溫度。
  13. The measurement system is made up of optical system, comparison system, control system and cooling system in the course of the temperature measurement of high temperature blackbody, we use filter radiometer that is a new approach to measure radiation temperature. the approach was adopted by ptb, npl and vniiofo in 1997 when they made international comparisions of spectral irradiance

    在測量高溫黑體溫度的過程中，使用了新型的輻射測溫法，濾光輻射計測量方法，該方法在1997年光譜輻照度國際比對時被ptb 、 npl 、 vn ofo等國家所採用，並得到一致認可。
  14. The calculating formulas of central wavelength drift based on thin film microstructure and thermal - stress deformation are deduced, the drift of dwdm filter 15 calculated with these formulas

    論文還討論了波分復用濾光片的溫度穩定性問題。推導了薄膜微觀結構和熱應力形變模型上的中心波長漂移計算公式。
  15. As emphasis, the paper introduces the choice of film materials, coating design, and deposition process

    並且重點介紹了長波通濾光膜的膜層材料的選取、膜系設計和製作工藝。
  16. Plastic optical lens filter designing and manufacturing technology

    塑料制光學鏡片濾光片設計製造技術
  17. The near arc area image is catched by a ccd camera through a specially designed visible light compound filter system

    由ccd攝像機通過特殊設計的復合濾光系統攝取近弧區圖象。
  18. Biochemistry analyser is frequently used in the clinical testing of human body fluids in a variety of substances, such as blood sugar, blood lipid, inorganic ions, serum enzymes, hepatic function, protein and non - nitrogen compounds and other types of conventional biochemical index. because of the lag in the development experience and the overall level of domestic processing industries backward, automatic biochemical analyser production technologies are dominated by japan, the united states, italy and other medical equipment manufacturers

    由於國內廠商尚無成型的全自動生化分析儀生產技術，加之老式生化分析儀採用機械轉動式濾光盤的分光結構，測量速度慢、無法完成部分測量功能，因此我們設計了測量速度更快，技術上更接近全自動生化分析儀要求的新型半自動生化分析儀，為將來開發國產全自動生化分析儀做出一定的技術準備。
  19. Optical fibre amplifiers - basic specification - test methods for out - of - band insertion losses - filtered optical power meter

    光纖放大器.基本規范.譜帶外插入損失測試方法.濾光計
  20. Optical fibre amplifiers - basic specification - part 7 - 1 : test methods for out - of - band insertion losses - filtered optical power meter

    光纖放大器.基本規范.第7 - 1部分:譜帶外插入損失的試驗方法.濾光計
分享友人
分享到 Line

分享到臉書