濾波電阻 的英文怎麼說

中文拼音 [lǜbōdiànzǔ]
濾波電阻 英文
filter resistance
  • 濾 : 動詞（除去液體雜質） filter; strain
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. In this paper, the design of a practical sort of high performance biquadrates elliptic active band - pass filters is emphasized, and then the design techniques and how to calculate the resistors and capacitances, how to make computer simulation and tolerance analysis with computer are described in detail

    摘要本文我們重點介紹了一種實用的雙二次型高性能橢圓函數有源帶通濾波器的設計方法，詳細介紹了該濾波器的設計步驟及阻容元件的參數計算，並對設計出的電路用計算機進行模擬模擬和容差分析。
  2. The trained neural network model can be used to solve a variety of problems emerged in rf / microwave circuit design, such as in microwave circuit cad, the established model structure can be used to characterize the nonlinear behavior of microwave circuits

    如用於微波電路cad ，可用所建立的模型結構來描述這么一類微波電路的非線性行為特徵；如用於微波電路設計，則可進行如共面波導、晶體管、傳輸線、濾波器和放大器等的設計；如用於微波電路優化，則可用所建立的電路模型優化電路參數，進行阻抗匹配等。
  3. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  4. A cicuit or device whose purpose is to control electrical energy at a given frequ - ency or over a range of frequencies, groups of passive components are commonly used to construct many types of filters, these passive components include resistors, cap - acitors and inductors

    指一電路或裝置其功能是在一特定頻率或頻帶下控制電能，不同種類的被動元件常被用來組成不同的濾波器，這些被動元件包含電阻，電容及電感。
  5. The paper first reviews the research background and actuality of the filter " s design in china and other country, introduces the meaning of the project and the work of the paper, narrates the theory of the switched - capacitor network and the basic switch building blocks, analyses the related factors of the design of sc filter. such as the selection of the architecture, the trade off of the opamp " s gain, bandwidth, phase margin, slew rate and setting time, the effect of the switch " s on resistor, how to reduce the charge injection and the clock feed - through, the power consumption and the selection of the sampling frequency and so on

    本文首先回顧了濾波器設計的國內外研究背景和現狀，介紹了本課題提出的意義以及本文的主要工作，論述了開關電容網路原理和基本開關模塊，分析了開關電容濾波器設計的相關因素：電路結構的選擇，對運算放大器設計中高增益、寬帶寬、相位裕度、轉換斜率和建立時間等的折中考慮，開關的打開電阻對電路的影響，開關電容電路中怎樣減少電荷注入和時鐘饋通，以及整個電路的功耗問題和采樣頻率的選擇等。
  6. Equipment under test to the measurement terminal. the high pass filter output signal is switched from either conductor to the measurement terminal

    大體上講，電源阻抗穩定網路從檢測設備eut向測試埠看，是一個高通濾波器。
  7. The scattering parameters of two proposed electromagnetic stop band filters have been fitted by this method

    本文提出了兩種電磁阻帶結構濾波器，並用該方法擬合了它們的散射參數。
  8. By use of coupling - of - modes model, this paper computers the characteristic impedance, then puts emphasis on the feedthrough effect which affects saw performance and some advice is given

    本文就是順應軍用和民用技術需求進行的工作，通過耦合模模型求解了saw濾波器的特徵阻抗，由此重點研究了影響saw器件性能比較嚴重的電磁直通效應，並提出了改善措施。
  9. Then a thorough analysis to the bias - magnetic of ppfc is made. the retraining effects of the main parameters ( include clamping capacitance c, output filter inductor lf, load r, the leakage inductor ls and source winding resistance r ) are studied under the conditions of different von, different ton and different winding parameters. then a conclusion can be drew, that the smaller lf and the bigger r are, the better the bias - magnetic is restrained and c has a best value to retrain the bias - magnetic

    分別對管壓降不同，導通時間不同以及兩原邊繞組參數不一致（包括漏感、電阻、激磁電感三種情況）的情況下，主要參數（包括箝位電容c 、輸出濾波電感lf 、負載r 、原邊繞組漏感ls 、原邊繞組電阻r ）對偏磁的抑制作用進行了模擬分析研究，得出lf越小， r越大時激磁磁勢偏移量ni越小， c在其他參數確定時對抑制偏磁有最優值等結論，為參數的優化設計提供了依據。
  10. Ultrasonic wire bonding was applied to connect the contacts and sub - miniature - a ( sma ) connectors. also a suitable shield box has been designed for the test of hts filters

    對于超導濾波器的焊接，採用超聲點焊焊接sma的接頭和高溫超導濾波器的接觸電極，實現了較小的接觸電阻和較好的機械強度。
  11. Equivalent circuits of two proposed electromagnetic stop band filters have been developed. and their parameters have been optimized using this method

    本文對兩個新提出的電磁阻帶結構濾波器建立了等效電路，並用該方法優化了相應的參數。
  12. Measurement error of thermistor compensated by nonlinear inverse filtering

    熱敏電阻測量誤差的非線性逆濾波器補償
  13. Design the good - working signal processing circuit of the sensor, including the signal collecting circuit of three output polars the coupling circuit using capacitance and resistance the alternating amplify processing circuit and the stabilization voltage supply circuit

    設計了性能良好的信號處理電路（包括銻化銦磁阻三端輸出型信號採集電路、阻容耦合型交流濾波放大電路和穩壓電源電路三個部分） 。
  14. This paper analyzes the operation principle, discusses the design of the block capacitor and the output inductance. a prototype converter rated 1. 2kw is built in the lab to verify the effectiveness of the cdr zvs pwm h - fb tl converter

    論文詳細分析了該變換器的工作原理，討論了開關管實現zvs的條件、阻斷電容以及濾波電感值的選取等，最後進行了實驗驗證。
  15. The design of the circuit ? key parameters including pulse width in the level shifter part and delay time of the filter circuit, and the necessity to add a limiting current resistor at source the ldmos were emphatic analyzed. author finished the design of each sub - circuit

    對電路關鍵參數高低壓電平位移脈沖寬度、高端濾波電路濾波寬度的設計及在ldmos源端加入限流電阻的必要性進行了重點分析，完成了各單元電路的設計。
  16. The purpose : the high voltage ac filter capacitor is connected together with filter reactor, resistor to form ac filter unit to filter harmful harmonic current out in power system and improve the power factor of system

    高壓交流濾波電容器與濾波電抗器、電阻器等設備連接在一起組成交流濾波裝置，用來濾除電力系統中的有害諧波電流並改善系統的功率因數
  17. Quantitative analysis of the action of electronic filter resistance in power source

    電源電子濾波電阻作用的定量分析
  18. Signalling on low - voltage electrical installations in the frequency range 3 khz to 148. 5 khz - low voltage decoupling filters - impedance filter

    頻率范圍為3khz至148 . 5khz的低壓電氣設備的信號傳輸.低壓去耦濾波器.阻抗濾波器
  19. Signalling on low voltage electrical installations in the frequency range 3 khz to 148, 5 khz - part 4 - 4 : low voltage decoupling filter - impedance filter

    頻率范圍為3khz至148 . 5khz的低壓電氣設備的信號傳輸.第4 - 4部分:低壓去耦濾波器.阻抗濾波器
  20. It could be a battery source ; however, in most case, the input is a diode rectified ac line voltage with a large filter capacitance, to provide a low internal impedance and low - ripple dc voltage source

    該直流電壓源可能是一個電池，然而在大多數的情形是一個經二極體整流的交流電壓再加上一個大的濾波電容，用以提供一個低內阻、低脈動的直流電壓。
分享友人
分享到 Line

分享到臉書