火熱性感 的英文怎麼說
中文拼音 [huǒrèxìnggǎn]
火熱性感
英文
hot sexy-
Parents - rachel who was born in southampton, england ryko who was born in yugoslavia surprise fact : holly s grandfather was cousin of the late british comedian, benny hill. fave places : brighton beach, bars and restaurants around melbourne, victoria
在kiss kiss音樂錄像帶中顛倒眾生千嬌百媚的holly valance其實並沒有露點,但穿著緊身衣的畫面與勾魂雙眼透過攝影技術的確讓男性觀眾看的瞠目結舌,營造一絲不掛的惹火感覺,作品一上架就奪下英國單曲榜後座,掀起英國歌壇的「 holly valance熱」 。In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective
火電廠熱工儀表普遍存在非線性特性,為了提高參數測量的準確度和儀表顯示的精確度,基於智能控制理論,文中提出了熱工儀表非線性校正的新方法: bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
文摘:運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區The main topic of this thesis is to deposit the lacamno3 films using the pulsed laser deposition ( pld ) technique, and to improve the properties of the films through a serials of processes including the post annealing treatments. at last, the relation between the physical properties and the film making processes of the materials are discussed and some possible applications explored
本論文的任務就是利用脈沖激光沉積lacamno _ 3薄膜,並通過退火等一系列工藝處理提高薄膜性質,最終製作測輻射熱儀的敏感元件,同時也對材料的物性展開討論,以探尋更多的應用。Experiment results show that such burners are safe enough, feature good adaptability in operation and ease of use, have litter investment, are provided with good economical benefit, etc. they have broad prospects for use in utility boilers that consume no oil for ignition and maintain the stability of flame
試驗結果表明,本燃燒器具有安全可靠、適應性強、操作方便、投資小、經濟效益高等優點,在電站鍋爐無油點火方面有著廣泛的應用前景。本文應用電磁感應加熱無油直接點火技術,對吉林熱電廠5號爐進行實際工程應用設計,並取得點火成功。Founded in september 1997, the company occupies an area of 35000 square meters and has 50 staffs, including 3 engineers, 2 vice senior engineers and 4 engineers. with the help of some domestic specialists who engaged in the research on induction heated quenching - tempering treatment in weapon and space industries. we developed the first induction heat oil tempered elastic wire production line in china by ourselves. this production line was put use in august 1998, and was enlisted in the spak programme in 2000 serial number : 369, programme code : 00b101d691004
創建於1997年9月,佔地35000平方米,員工50名,其中研究員級高工3名,高工2名,工程師4名。依靠國內一批在軍工企業長期從事感應加熱調質處理研究的專家,自行研製成功國內第一條彈性線材感應加熱油淬火-回火生產線,並於1998年投產。Valance and her character became an instant fan favorite and remained so for the next three years. but while a steady job on a hit soap was great, she opted not to renew her contract in 2002. instead, she set her sights on a singing career, something she had been practicing for since she was 13
在kiss kiss音樂錄像帶中顛倒眾生千嬌百媚的holly valance其實並沒有露點,但穿著緊身衣的畫面與勾魂雙眼透過攝影技術的確讓男性觀眾看的瞠目結舌,營造一絲不掛的惹火感覺,作品一上架就奪下英國單曲榜後座,掀起英國歌壇的「 holly valance熱」 。Due to the rapid heating rate, the time for wire stayed in high temperature zone is very short and no enough time for grain grows largely, hence the structure size of continuously induction heated wire is smaller than that of conventional heated wire and grain size is 2 to 4 level higher. due to the fine grain size, the induction heat oil tempered spring wire can acquire more reasonable comprehensive mechanical properties under same strength
可見,由於加熱快,在高溫停留時間短,組織晶粒來不及長大,因此,連續感應加熱鋼絲的組織晶粒尺寸比一般加熱小,晶粒度高2 - 4級。由於組織晶粒尺寸細小,因此,感應加熱油淬火-回火鋼絲,在同樣強度下,具有更高的綜合b力學性能。Induction heat oil tempered wire and rod can be directly used in the manufacture of spring and pusher and the quenching - tempering process thereafter can be omitted, thus the quality problems such as deformation of workpiece, decarburization, un - stability and un - qualification of mechanical property can be avoided and the quality stability and reliability of product can be improved
感應加熱油淬火-回火鋼絲及線材,能直接用於繞簧和製造推桿,可省去一般材料繞簧和推桿加工成形后的淬火-回火工序,避免了由此帶來的工件變形脫碳及力學性能不穩定甚至不合要求等質量問題,提高了產品的質量穩定性和可靠性。Compound wood can keep fire, heat out and no rot. it is similarly to the wood, and in various colors
木塑復合材料具有抗紫外線、耐火耐腐、隔熱絕緣、質感接近木材、著色性良好等特點。Execution standard : the equipment is heating by intermediate frequency influence. it can test salg resistance of refractories by soaking and crucible, and test multi - sample
製作依據:該設備採用中頻感應加熱,可用侵入法和坩堝法測試耐火材料的抗渣蝕性,並可同時做多個試樣的測試。Purpose : the equipment is used for mensurating corrosion resistance of blast furnace refractories to molten slag by means of heating of intermediate frequency influence
用途:該設備用中頻感應加熱的方法模擬測試耐火材料抗渣蝕性能。分享友人