無向量軸 的英文怎麼說

中文拼音 [wúxiàngliángzhóu]
無向量軸 英文
scalar axis
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  1. The results indicate that : the high positioned air inflow do good to heat transfer in rotator disk ; different size of radial outflow have small effects on flow and heat transfer ; the heat transfer near rotating disk increases as rotating reynold number increases or non - dimensional mass flow rate increases

    結果表明，高位軸向進氣對轉盤換熱有利；不同的徑向出口大小對盤腔內的流動換熱影響不大；隨旋轉雷諾數和無量綱質量流量增加，轉盤盤面的換熱效果增強。
  2. By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established

    （ 2 ）針對一典型的徑向、軸向進氣，徑向出氣的轉-靜盤腔結構，系統研究軸向進氣位置、徑向出口大小、旋轉雷諾數、無量綱質量流量和軸向垂直預旋進氣等對盤腔內流動和換熱的影響，整理出轉-靜盤腔內轉盤平均努謝爾數與旋轉雷諾數無量綱質量流量之間的準則關聯式。
  3. The result of md simulation means that : ( 1 ) the microstructure in the amorphous carbon has no obvious change, the slippage which is parallel to the fiber axes in the graphite slices of the pyc interphase was found ; ( 2 ) bulk moduli of every part of interphase diminished, young ' s moduli in all three direction of amorphous carbon diminished, young ' s moduli of the graphite slices in the direction of parallel to the fiber radial decreased, and ones in the direction of parallel to the fiber axes increased

    分子動力學模擬結果表明， （ 1 ）界面相內部無定形碳部分微結構無明顯變化，石墨片層部分沿纖維軸向滑移； （ 2 ）界面相模量發生變化，界面相區域各部分的體積彈性模量降低，無定形碳部分及石墨片層部分垂直於纖維軸向的楊氏模量降低，平行於纖維軸向的楊氏模量升高。
  4. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  5. In the last part of the paper, we derive the euclidean equation of motion of the magnetic vector in a theoretical magnetic film consisting of biaxial - anisotropic molecular ferromagnets, which is reduced to the 2 + 1 dimensional sine - gordon field equation in the strong anisotropy limit. we obtain various domain structures which are the static solutions of the sine - gordon field equation

    最後考慮由雙軸各向異性分子磁體形成的理想無界膜，在強各向異性極限下，採用半經典近似方法，將磁化矢量的時空運動方程約化為2 + 1維sine - gordon場方程，從而得到各類疇結構。
  6. Because the field caused by the eddy - current transducer in the dissertation is not only axially symmetrical, but also plane symmetrical, there is no normal component of the electrical field strength and we cannot apply the condition en = 0 to solve such a problem

    由於本文中的渦流傳感器模型，其電磁場不僅是軸對稱場，而且還是平面對稱場，不含有電場強度的法向分量，所以無法利用邊界條件e _ n = 0來求解。
  7. In chapter 2, an accurate modified reynolds equation is derived. the modified reynolds equation is solved numerically with the finite different method, the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the rectangular screw are obtained. at last, using numeral methods and coordinate graphs, the influences of rectangular screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第二章，首先推導了非牛頓流體的變形雷諾方程，化簡了雷諾方程，得出了矩形螺紋下有限差分方程；還推出了矩形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，最後用數值計算方法求解，通過坐標圖分析了矩形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  8. For the first time, the solenoid collecting magnetic field optical transducing principle is presented in this paper, and it is proved that the way to measure current by polarized light encircling conductor and that by polarized light threading solenoid axes are equivalent

    為了解決aoct的長期運行穩定性問題，首次提出了「螺線管聚磁光學傳感原理」 ，證明了偏振光圍繞著無限長通電導體測量電流與偏振光通過通電螺線管的軸向方向測量電流，在光學傳感測量電流的意義上是等價的。
  9. In chapter 4, the modified reynolds equation is solved numerically with the finite different method, and the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the serrate screw are obtained. at last, using numeral methods and coordinate graphs, the influences of serrate screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第四章，首先求出鋸齒形螺紋下數值計算所需的有限差分方程，再推出了鋸齒形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，最後用數值計算方法求解，通過坐標圖分析了鋸齒形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  10. This paper first expounds the principle of the bearingless induction motor, gives the mathematical model of bearingless induction motor and analyzes the rotor flux orientation vector control system of the bearingless induction motor

    本文闡述了無軸承異步電機的基本工作原理，並建立了無軸承異步電機的數學模型，分析了無軸承異步電機的轉子磁場定向矢量控制系統。
  11. The main contributions of this work are included as follows : ( 1 ) numerical tests of the outside axial and helical flows were carried out respectively. the velocities and pressure profiles and shear distributions have been obtained and they were compared due to the different flow field. it is concluded that when no particles are deposited, the helical flow would lower the pressure on membrane surface to some little extent but not markedly

    （ 1 ）對外軸向流和外切向流兩種方式下膜器環隙內流場進行變參數數值實驗，作出流場及切應力的分佈規律，分析無顆粒沉積時層流條件下流動結構對過濾通量的影響，認為：採用外旋流的方式將對膜面壓力有削弱作用，但並不明顯。
  12. 3 ) a custom filed function module was complied to study the influence of non - dimensional mass flowrate changed with time in stair shape on flow and heat transfer inside rotator - stator cavity with axial inflow and radial outflow. average nusselt number takes on a sharp up - down process when the mass flowrate changes from stabile status as to the following change of flowrate, the average nuselt number changes greatly in the initial stage and then changes gradually

    （ 3 ）自編用戶程序模塊，研究在軸向入流、徑向出流的轉-靜盤腔中，無量綱流量隨時間呈階梯型改變對盤腔流動和換熱的影響。當流量從某個穩定狀態改變時，轉盤上的平均努謝爾數會產生一個明顯的上升再降低過程；在每一次流量改變的初始階段，平均努謝爾數存在一個較大幅度的變化。
  13. In chapter 3, the modified reynolds equation is solved numerically with the finite different method, and the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the trapezoidal screw are obtained. at last, using numeral methods and coordinate graphs, the influences of trapezoidal screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第三章，首先求出梯形螺紋下有限差分方程，然後推導了梯形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，並用數值計算方法求解，通過坐標圖分析了梯形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  14. This direction finding algorithm may resolve uncorrelated monochromatic sources, but it assumes that all signal frequencies are distinct. it requires no a priori knowledge of the signals " frequencies, suffers no frequency - doa ambiguity, and pairs automatically the x - axis direction cosines with the y - axis direction cosines

    該演算法用單矢量水聽器，在無需知道信號先驗信息的條件下，可以實現對多個不相關信號的方位角估計，並且不受頻率模糊度的影響，自動匹配x軸、 y軸的方向餘弦。
  15. Both qualitative analysis to the changing trend of droplet axial velocity profile and quantitative comparison with experimental data demonstrate the rationality of this model

    計算與實驗結果表明：無論是從液滴軸向速度分佈變化趨勢的定性分析，還是從與實驗數據的定量比較來看，建立的模型都是合理的。
  16. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - axial compression

    光纖互聯裝置和無源部件.基本試驗和測量程序.試驗.軸向壓縮
  17. Fibre optic interconnecting devices and passive components. basic test and measurement procedures. part 2 - 11 : tests. axial compression

    光纖互連裝置和無源元件.基本試驗和測量程序.第2 - 11部分:試驗.軸向壓力
  18. Basic environmental testing procedures ; part 2 : tests ; test ee and guidance : bounce iec 68 - 2 - 55 : 1987

    纖維光學互連器件和無源器件基本試驗和測量程序第2 - 11部分：試驗軸向擠壓
分享友人
分享到 Line

分享到臉書