無量綱比值 的英文怎麼說

中文拼音 [wúliánggāngbǐzhí]
無量綱比值 英文
dimensionless ratio
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 綱 : Ⅰ名詞1 （提網的總繩 多用於比喻） the headrope of a fishing net 2 （比喻事物最主要的部分） key lin...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 無量 : measureless; immeasurable; boundless
  • 比值 : specific value; ratio比值法 ratio method; 比值計 ratio meter; 比值檢波器 ratio detector; 比值控制...
  1. Then fuzzy maths is used here to get dimensionless form of the results, thus the quantitative index subjection model is build. by method of fuzzy statistic, the qualititive index subjection is model is build, too

    運用模糊數學方法，對有無對比值無量綱化，建立定量指標隸屬度模型；對定性指標分級量化，得到定性指標的隸屬度。
  2. By the result of these experiments, acoustic emission ( ae ) was chosen to use in the research. at the same time, we analyse the phenomenon of acoustic emission at the base of theory, the characteristic signal of acoustic emission which comes from the faulty bearing at the angle of application, and the expression of the characteristic signal. contrast was also made on the data achieved separately from vibrational signal and ae signal, and it is proved that ae is feasible and available to the diagnosis to the fault of the rolling bearing

    主要工作有如下幾方面：對本段前期實驗室階段採用的振動法幅值域無量綱處理進行了分析，並研製了現場所使用的滾動軸承故障檢測裝置，將無量綱參數診斷法應用於段修現場，且做了大量試驗；對于現場試驗中所出現的問題進行了分析，提出將聲發射的方法用於軸承的在線故障診斷；從理論上分析了聲發射現象，從應用的角度分析故障軸承的聲發射信號的特徵以及聲發射信號特徵的表示方法，並在實驗室中，採用振動法和聲發射法實時檢測的實驗數據進行了對比和分析，證明了使用聲發射法對軸承故障檢測的可行性和有效性。
  3. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  4. During the analysis, three non - dimensional parameters is considered : the ratio of outer diameter of hollow spherical joint to the thick of spherical ; the ratio of outer diameter of hollow spherical joint to the thick of steel plate ; the ratio

    分析時考慮了三個無量綱參數，空心球外徑d與壁厚t的比值;空心球外徑d與鋼板厚tp的比值;連接鋼管外徑與空心球外徑之比。
  5. The physical and mathematical models are founded. numerical simulation of marangoni convection in the liquid bridge and gas channel was performed by employing the primitive variable method and using galerkin finite element method, which is applied for discretization of non - dimensional governing equations and boundary conditions. the relationship between the suppressing status of mc in the liquid bridge and the inlet gas velocity or the channel width is obtained, and the suppressing status of some kinds of marangoni numbers ( ma ) or size ratios of liquid bridge a is analyzed

    採用原始變量法，用galerkin有限單元法對無量綱控制方程及邊界條件進行離散后，數值模擬了微重力條件下半浮區硅熔體及氣體流道內的marangoni對流，得出了無量綱氣流沖刷速度及流道寬度變化和熔體內熱毛細對流抑製程度的關系，進而分析了不同的無量綱參數ma數和不同熔體幾何尺寸比a下熱毛細對流抑制情況。
  6. By analysis of frequency spectrum based on matlab platform, wavelet method in the application of cutting out a section of inputting earthquake wave was presented. in the process of pseudo dynamic test results, the method of non - dimensional representation and analytic representation of hysteretic curve was provided. the above two methods will help to compare dissipation energy capacity of this structure at the different acceleration peak value stage of pseudo dynamic test more precisely and comparably

    通過基於matlab的地震波頻譜分析，說明了小波分析方法在擬動力試西安建築科技大學博士學位論文驗中地震波截取方面的應用；在擬動力分段試驗數據的處理方面，本文將試驗結果的無綱量表示方法以及曲線的多項式擬合法引入滯回曲線的數據處理，這將有助於擬動力試驗不同加速度峰值條件下，各階段結構耗能能力的客觀比較。
  7. With this method, dimensionless functions and correction formula were constructed to eliminate and correct the errors arising from the dimensions ' differences and the expectation distance scales ' inconsistency which enabled comparisons among distinct non - functional conditions

    通過建立無量綱化函數與修正公式，消除了因條件量綱不同而帶來的影響，並統一了期望值距離刻度，使不同意義的條件指標具有了可比性。
  8. Therefore, the solution of the problem can be reduced to a seri es of algebraic equations and solved numerically by truncating the finite terms of the infinite algebraic equations. finally, given two kinds of incident wave and different dimensionless parameters, numerical examples are provided to show the influence of wave number, shear modulus, thickness and distance between the center of the cavity and ground surface upon the dynamic stress concentration by incident steady sh - wave

    最後作為算例，給出了第一類和第二類兩種不同的sh波入射方式對襯砌的散射，並選取了兩種無量綱參數值，得出了圓形襯砌對sh波散射的數值結果，討論了不同的波數比、彈性模量比、厚度比以及不同的圓形襯砌中心到水平地面距離與襯砌內半徑的比值對動應力集中系數的影響。
分享友人
分享到 Line

分享到臉書