煅燒程度 的英文怎麼說

中文拼音 [shāochéngdù]
煅燒程度 英文
degree of calcination
  • 煅 : 動詞1. （中藥製法: 放在火里燒） calcine2. （鍛造） forge
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 程度 : 1. （知識、能力的水平） level; degree 2. （事物變化達到的狀況） extent; degree
  1. In this paper, co3o4 nano - particles were prepared by homogeneous precipitation method, technical conditions and kinetics were studied, the main contents and results are as follows : co ( no3 ) 2 6h2o was used as raw materials, and co ( nh2 ) 2 was used as precipitator, co3o4 nano - particles were prepared by homogeneous precipitation. the influences of concentration, molar ratio of reactants, reaction temperature and time, dryness temperature and time, and calcining temperature and time on particle size were investigated

    本文採用均勻沉澱法制備納米co _ 3o _ 4粉體材料，研究了制備工藝條件、沉澱反應和前驅體熱分解過程的動力學，主要研究內容及結果如下：以硝酸鈷為原料，尿素為沉澱劑，採用均勻沉澱法制備納米co _ 3o _ 4 ，考察了硝酸鈷濃度、反應物摩爾比、反應溫度和時間、乾燥溫度和時間、煅燒溫度和時間等條件對產物粒徑的影響。
  2. The new method is compared with the ordinary fire law, the characteristic of product such as to possess that the diametre is small and the size distributes narrow and the agglomeration level is light etc, and for further adopting the measure scatters providing the possibility

    實驗所得納米粉體與火法煅燒樣品相比，產品具有粒徑小、粒度分佈窄、團聚程度輕等特點，並且為進一步採取措施進行分散提供了可能。
  3. These studies have shown significant results : to protect wollastonite ' s crystal structure, we can forge and then cool it before fining ; adopting mechanochemical modification by jet mill, we can make wollasonite to fine and modification at the same time ; in order to understand thoroughly the major results achieved in enhancement of mechanical capabilities of the polypropyl ene filled with the modified wollastonite, this paper has researched deeply the interface mechanism through combining experiments and measure means with theory analysis, and tried to give a further explanation and demonstration about improving of the macroscopic mechanics performances of composite material and to offer a theoretical basis for improving material ' s mechanical properties

    特別是採用粉碎前對硅灰石煅燒空冷處理的方式，獲得了超細化程度更高、長徑比更大的硅灰石；利用機械力化學改性及超音速氣流粉碎技術，使硅灰石粉碎?改性同時完成；應用現代測試手段，結合實驗對界面微觀形貌、結構及其機理進行研究，進一步解釋與論證了復合材料的宏觀力學性能，為改善復合材料的綜合性能提供了理論基礎。這些方面的研究在同類研究中具有一定的創新性。
  4. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  5. Reaction of limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere were experimented on a bench scale fluidized bed facility and analyzed by thermodynamic analysis. limestone samples were analyzed by press mercury apparatus and scanning electron microscope. mechanism for limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere was raised and discussed

    熱力學角度和小型流化床試驗臺上研究了空氣和o _ 2 / co _ 2氣氛下的石灰石煅燒分解與硫化反應特性，並對煅燒過程和硫化反應過程中的石灰石樣品結合壓汞儀和掃描電鏡進行了微觀分析，得出了o _ 2 / co _ 2氣氛下石灰石煅燒與硫化反應特浙江大學博士學位論文點，探討了02 / co :氣氛下石灰石的硫化反應機理。
  6. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究，並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末，研究了溶劑量，溫度， ph值，煅燒溫度等對溶膠-凝膠過程的影響，以及摻雜稀土量對相結構的影響，從而確立了最佳的工藝參數。
分享友人
分享到 Line

分享到臉書