熔化溫度范圍 的英文怎麼說

中文拼音 [rónghuàwēndùfànwéi]
熔化溫度范圍 英文
melting range
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 范 : 名詞1 [書面語] （模子） pattern; mould; matrix 2 （模範; 榜樣） model; example 3 （范圍） boundar...
  • 圍 : Ⅰ動詞1 （四周攔擋起來 使裡外不通; 環繞） enclose; surround; corral 2 （繞; 裹） wrap Ⅱ名詞1 （四...
  • 熔化 : melt; smelt; meltdown; fusion; fusation; diatexis; eliquation; run; melting; smelting
  • 溫度 : [物理學] temperature
  • 范圍 : scope; limits; extent; boundary; confines; range; range dimension; spectrum
  1. And apatite. by these analyses and comparison with general granite both in china and the world and with the granite in other au or cu belt in china, the characteristics of the granite in this area are concluded as follows. it belongs to magnetite - i or syntectic granite and has crust - mantle mixed characteristics ; it was formed mainly by crystallization differentiation of melting magma and multiphase varied intrusion ; the degree of differentiation evolvement is not high ; the granite and its enclaves p. re congenetic ; the range of temperature is about 500 - 700, the range of pressure is about 2. 50 gpa - 4. 35 gpa, and the range of oxygen fugacity ( lg fo2 ) is - 15. 53 - - 14. 00 ; most granite bodies formed before the collision of plates, and few formed after the collision of plates

    通過對測試數據的分析與綜合研究，並同中國和世界一般花崗巖類以及中國主要金、銅成礦巖體的花崗巖類進行對比，得出本區花崗巖類巖石具有以下特徵：屬磁鐵礦-型或同熔型花崗巖，其巖漿物質具殼幔混源特徵：主要由熔融態巖漿經結晶分異作用，通過多期變速上侵而形成；其分異演化程度較低；寄主巖基和包體具有同源性；巖石的形成溫度范圍約為500 - 700 ，壓力大約為2 . 50gpa - 4 . 35gpa ，氧逸度值1gfo _ 2為- 15 . 53 ? 14 . 00 ；該巖帶主要形成於板塊碰撞前消減的活動板塊邊緣期，為燕山至喜馬拉雅早期的大陸邊緣火山弧環境的產物。
  2. 5, both melting point ( tm ) and isotropization temperature ( tj ) of all the three series compounds change regularly with the carbon numbers of the end alkoxy group increased. there is a gradual increase in smectic phase length and in the smectic - nemetic transition temperature. at the same time there is a gradual decrease in nemetic phase length

    五，三個類型化合物16ia至16id 、 16ila至16lid 、 17ia至17id 、 17ila至17lid 、 18ia至18id和18ila至18lid的熔點和液晶態的清亮點均化合物分子中末端烷氧基增大逐漸降低；近晶相的溫度范圍和近晶相一向列相轉變溫度逐漸增大，而向列相的溫度范圍遞減。
  3. Find the law of the influence from the injection pressure to the filling time and the cavity pressure and make certain of the best filling time, injection time and injection pressure. though the analysis of the flowing velocity and pressure spread of the key position element in the injection parts in different gate position, we forecast the injection parts quality and the possibility injection flaw and its position, optimize the gate position. in this paper, though the research of analogue of the runner system of metal - powder injection molding and the process of injection molding, we get the law of how the injection parameter influence the injection process

    在相同的注射條件下，通過分析喂料在不同直徑和長度流道中的流動規律，得到了喂料在流道中的速度場、壓力場和溫度場，找到了流道長徑比的合理取值范圍，並得出通過改變流道設計可實現對現有設備資源充分利用的結論；給出了不同注射壓力下，型腔壓力與充模時間關系曲線和喂料熔體平均充填速度與充模時間關系的曲線，得到了注射壓力對充填時間和型腔壓力的影響規律，確定了最佳的充模時間、注射時間和注射壓力；通過分析採用不同位置澆口注射時注射件關鍵位置單元的流動速度和壓力分佈，預測了注射件的成形質量，或可能產生的注射缺陷及位置，優化了澆口設置。
  4. Test methods for lead - free solders - part 1 : methods for measuring of melting temperature ranges

    無鉛焊劑的試驗方法.第1部分:熔化溫度范圍的測量方法
  5. But most of the researches focus on the reaction of single oxide and al to form wild phase al2o3. these researches show that only cuo / al reaction system can produce al2o3 particles steadily. however, the reaction is very drastic and it belongs to blast reaction

    但大部分的研究集中在單一氧化物與al的置換反應生成增強顆粒al _ 2o _ 3的方法上，研究表明，只有cuo al反應體系在al熔點以上不高的溫度范圍能穩定生成顆粒，但同時cuo al反應過于劇烈，屬于燃爆反應，不易控制。
分享友人
分享到 Line

分享到臉書